温度梯度场对电声脉冲法空间电荷测量波形的影响

电力设备运行中的温升现象严重影响绝缘的使用寿命,因此高温下的空间电荷测量引起了许多学者的关注.但温度升高时,聚合物材料的声阻抗、Young模量、密度、声波在其中传播的速度、衰减特性均发生变化,因此无法准确测量出介质中的空间电荷特性.而对于温度梯度场下的绝缘介质(如电缆发热场)的空间电荷测量,温度的梯度分布对介质的声阻抗、弹性模量、密度、声速及声波衰减的影响将更为复杂.本文基于电声脉冲测量方法中声波的传播特性和温度对聚乙烯材料特性的影响,分析了温度梯度场对空间电荷测量结果的影响并进行了波形恢复.     

Growth and optical properties of Cr~（3＋）-doped CdWO_4 single crystals

A high-quality Cr 3+:CdWO4 single crystal at a size of approximatelyΦ25×80 mm is grown using the Bridgman method with CdO,WO3,and Cr2O3 as raw materials and their molar ratio of 100:100:0.5.The temperature gradient of solid-liquid interface at growth is approximately 50?C/cm and the growth rate is 0.05 mm/h.The X-ray diffraction(XRD),absorption,excitation,and emission spectra of different parts of the as-grown and O2-annealed crystals are investigated.Two strong broad optical absorption bands of about 472 and 708 nm are observed,and they are associated with the transitions 4 A2→ 4 T1 and 4 A2→ 4 T2.The weak 4 T2→ 2 E transition(the R-line)at 632 nm is also observed.The crystal-field parameter Dq and the Racah parameters B and C are estimated to be 1 412.4,776.8,and 3 427.6 cm? 1,respectively,according to the absorption spectra and crystal-splitting theory.A broadband fluorescence at about 1 000 nm due to 4 T2→ 4 A2 transition is produced by exciting the samples at 675 nm.After being annealed in an O2 atmosphere,the crystals become more transparent,while the effective light absorption of Cr 3+ ions is evidently enhanced and the emission intensity is also strengthened due to the reduction of oxygen vacancies in the CdWO4 crystal after annealing.     

一类奇异复本征方程组的数值计算

1引言 在研究离子温度梯度（ITG）驱动不稳定性中，当电磁效应被考虑后，常会碰到求解下述复本征方程组：     

Experimental Study on Liquid Free Surface in Buoyant-Thermocapillary Convection

We investigate the surface deformations of buoyant-thermocapillary convection in a rectangular cavity due to gravity and temperature gradient between the two sidewalls. The cavity is 52mm×42 mm in horizontal cross section, the thickness of liquid layer h is changed from 2.5 mm to 6.5 mm. Surface deformations of h = 3.5 mm and 6.0mm are discussed and compared. Temperature difference is increased gradually, and the flow in the liquid layer will change from stable convection to unstable convection. Two kinds of optical diagnostic system with image processor are developed for study of the kinetics of buoyant-thermocapillary convection, they give out the information of liquid free surface. The quantitative results are calculated by Fourier transform and correlation analysis, respectively. With the increasing temperature gradient, surface deformations calculated are more declining. It is interesting phenomenon that the inclining directions of the convections in thin and thick liquid layers are different. For a thin layer, the convection is mainly controlled by thermocapillary effect. However, for a thick layer, the convection is mainly controlled by buoyancy effect. The surface deformation theoretically analysed is consistent with our experimental results. The present experiment proves that surface deformation is related to temperature gradient and thickness of the liquid layer. In other words, surface deformation lies on capillary convection and buoyancy convection.     

六面顶压机高温高压弹性波速测量装置样品室温度梯度的校正

 大腔体六面顶压机波速测量装置的样品室内存在着较大的温度梯度。根据实验观测的样品室内的温度分布数据和在一定温度条件下波速随温度升高呈线性变化的特征，运用理论分析和计算相结合的方法对样品的弹性波速进行了校正。以斜长角闪岩为例，对其实验测量的纵波速度（v_P）进行了校正，并与原来的数据作了对比：波速校正量绝对值随着温度的升高逐渐增大；在2.0 GPa、530 ℃时，样品X和样品Y校正后的v_P比未校正的v_P分别减小了0.270 km/s（3.3%）和0.118 km/s（1.5%）。这种方法明显地提高了波速测量结果的精度，有助于更准确地进行地球物理资料的解释。     

温度对航天相机光学系统影响的研究

空间环境温度的变化对航天相机光学系统成像质量的影响很大。分析了几种不同的温度分布形式,即均匀温度变化、温度梯度变化、径向温度梯度变化、周向温度梯度变化、轴向温度梯度变化和主、次镜间轴向温差的变化对光学系统成像质量的影响,并给出了相应的分析方法。     

微通道脉冲管中He气交替振荡的分子动力学模拟

使用非平衡分子动力学模拟方法分析了微通道脉冲管(MPT)中由正弦速度活塞提供驱动力时He气交替振荡的微观动力学过程,并对MPT的冷却机制进行了分析.结果表明,MPT的压缩和膨胀过程之间存在一个交替的振荡过程,两个过程具有不对称的属性分布,膨胀过程具有比压缩过程更大的轴向压力梯度.当充气压力较低时,循环时间对冷端温度的影响很小,但是当充气压力高于20 bar时,冷端温度对时间较为敏感,随着时间的减少,冷端温度进一步降低,而冷端瞬时平均温度随着充气压力的增加而增加.另外,压比随着时间的减少而增加,并且明显不受充气压力的影响,但它会在MPT的轴向上产生较大的温度梯度.综上所述,在热端使用不同形式的换热器和调相元件会释放或回收额外的声功率.固定工作模式和尺寸参数的MPT具有最佳频率,可以在冷端获得最低的空载温度.仿真结果增进了对脉冲管制冷机的认识,并为微通道脉冲管制冷机的优化设计提供理论支持.     

带有两个共线裂纹载流薄板温度场的复变函数解

采用复变函数方法对带有两个共线穿透裂纹的导电薄板，在瞬间电流作用下的温度场进行了计算。针对带有两个共线裂纹或夹杂的载流薄板形成了边值问题，给出封闭形式的解，得到了电流在裂纹尖端的奇异特征。在形成了点热源的基础上，导出裂纹端附近区域的温度场表达式，为计算裂纹尖端附近应力场打下了基础。     

热声发动机起振行为实验研究

研究了热声发动机起振过程,对Benavides构建的动力学模型的计算方法进行了优化,计算了控制压力、回热器参数和系统频率对热声发动机起振温度的影响。并进行了实验,计算结果与实验结果一致,证明了优化效果。