A boron-lined proportional counter (BLPC) used in a mixed field of reactors

A boron-lined proportional counter (BLPC) with a count rate limit close to the multi-wire proportional counter was manufactured to measure the mixed field around reactors. After measurement with a standard Am-Be neutron source (activity: 100 mCi), the results show that the operating voltage of the BLPC is 800 V, the plateau length is 100 V and the slope is 13.2%/100 V. The width and rise time of the output pulse of the BLPC are 1.26 μs and 370 ns, respectively. When the BLPC works at a count rate of 1.0×10⁵ count/s, the pulse pile-up probability of the BLPC is 3.6%. A clear peak can be seen in the pulse height spectrum of the BLPC. and the performances illustrate that a BLPC working in pulse mode can serve as a source range detector of reactors.     

反相高效液相色谱法测定维格列汀

建立反相高效液相色谱法测定维格列汀的含量。采用Venusil MP C18色谱柱（250mm×4.6mm,5μm）,流动相为磷酸盐缓冲溶液(称取20mmol·L^-1磷酸二氢钾,用85%浓磷酸调至pH3.0)-乙腈（88:12,V/V）,检测波长为210nm,流速为1.0mL·min^-1,柱温为25℃。维格列汀在5—500μg·mL^-1范围内与峰面积呈良好的线性关系（r=0.9999）,维格列汀的平均回收率为102.0%,RSD为2.65%。方法准确、简便,适用于维格列汀的定量分析。     

“螃蟹脚”的红外光谱分析

利用傅里叶变换红外光谱仪测定了“螃蟹脚”(扁枝槲寄生Viscum articulatum Burm.f.)的红外光谱,其红外光谱主要峰位在3430、2927、2853、1625、1420、1317、1271、1074、876、781、622、545、518cm-1附近,光谱特征明显,可供辨别“螃蟹脚”真伪作参考;同时,对其化学成分和药理作用进行了初步分析.     

Ru(0001) 表面BaO吸附层的原子结构和氮分子的吸附性质

采用密度泛函理论研究了Ru(0001) /BaO表面的原子层结构和氮分子的吸附性质. 研究结果表明, 在低覆盖度下氧化钡倾向于以相同的构型形成Ru(0001) 表面原子层. 在此构型中, 氧原子位于表面p(1× 1) 结构的hcp谷位, 而钡原子则位于同一p(1× 1) 结构的顶位附近. 钌氧键键长等于0.209 nm, 比EXAFS的实验值大0.018 nm. 在Ru(0001) /BaO表面氮分子倾向吸附于钡原子附近. 相应位置的氮分子吸附能位于0.70到0.87 eV之间, 大于氧原子附近的氮分子吸附能. 钡原子附近的钌原子对氮分子具有更强的活化性能. 相应位置的氮分子拉伸振动频率等于1946 cm^{- 1}, 比氧原子附近的最大分子振动频率小约130 cm^-1. Ru(0001) /BaO表面氮分子键强度介于清洁Ru(0001) 和Ru(0001) /Ba表面之间. Ru(0001)/BaO表面不同位置的氮分子吸附性质差异是由钡和氧原子化学性质不同造成的. 表面钡原子的作用能够减少吸附氮分子的σ^*轨道电子密度, 增加π^*轨道电子密度, 从而增强氮分子和钌原子间的轨道杂化作用, 弱化氮分子键.     

Highly linear transmission and EVM improvement of vector modulation signals for radio-over-fiber applications

The principle of error vector magnitude (EVM) against modulator nonlinearity for vector modulation signal (VMS) transmission in radio-over-fiber (RoF) systems is theoretically and experimentally investigated. A highly linear modulation scheme is proposed and demonstrated using a single-drive dual parallel Mach-Zehnder modulator (MZM). This method improves EVM performance and enlarges the linear input dynamic range of the VMS transmission. An index of maximum allowable input power difference (MAIPD) that reflects the difference of upper input power limits between these two schemes is measured. An EVM limitation of 5% MAIPD has 5 dB. Both 16and 64-QAM results indicate that the proposed scheme supports VMS transmission better than the MZM one.     

Doctor-bladed Cu2ZnSnS4 light absorption layer for low-cost solar cell application

The doctor-blade method is investigated for the preparation of Cu2ZnSnS4 films for low-cost solar cell application.Cu2ZnSnS4 precursor powder,the main raw material for the doctor-blade paste,is synthesized by a simple ball-milling process.The doctor-bladed Cu2ZnSnS4 films are annealed in N2 ambient under various conditions and characterized by X-ray diffraction,ultraviolent/vis spectrophotometry,scanning electron microscopy,and current-voltage(J-V) meansurement.Our experimental results indicate that(i) the X-ray diffraction peaks of the Cu2ZnSnS4 precursor powder each show a red shift of about 0.4°;(ii) the high-temperature annealing process can effectively improve the crystallinity of the doctor-bladed Cu 2 ZnSnS 4,whereas an overlong annealing introduces defects;(iii) the band gap value of the doctor-bladed Cu 2 ZnSnS 4 is around 1.41 eV;(iv) the short-circuit current density,the open-circuit voltage,the fill factor,and the efficiency of the best Cu2ZnSnS4 solar cell obtained with the superstrate structure of fluorine-doped tin oxide glass/TiO2/In2S3/Cu2ZnSnS4/Mo are 7.82 mA/cm2,240 mV,0.29,and 0.55%,respectively.     

微燃机稳压箱的计算分析

本文对自行设计的100 kW微型燃气轮机的稳压箱进行了数值模拟,并将结果与国外某75 kW微型燃气轮机的稳压箱的数值模拟结果进行了对比。然后对结果进行分析,从中发现,自行设计的微型燃气轮机的稳压箱与国外同功率级的稳压箱相比,总压恢复系数有所提高,流动损失较小,因此具有更优良的气动性能。计算表明,进口处流动方向变化较大,流动损失也较大,并且流动复杂,有漩涡产生,流场具有复杂的结构,必须在设计时引起足够的重视。     

高规则性多孔硅材料的制备和作为生物酶的载体在有机溶媒中的应用

FSM- 16,MCM- 4 1和 SBA- 15等具有高规则性的二维六角晶格结构的多孔硅可由不同的硅酸盐或有机硅氧化物结合表面活性剂制备而成 ,孔径的大小可根据表面活性剂的不同烷基链长和有机膨胀剂的添加量加以控制 ,最大可分别达到 10 0 ,10 0和 150 ,但其晶格的规则性则随孔径的增大而降低。我们发现了用层状硅酸盐Kanemite制备的 FSM- 16和来自硅酸钠的 MCM- 4 1,其表面阴离子度比用四甲氧基硅烷 ( TMOS)制备的 SBA- 15高得多。如将在等电点以下呈阳离子性的生物酶插入多孔硅中 ,则由于形成的离子间相互作用和氢键结合力 ,可得到结合得十分稳定的生物 /无机陶瓷结合体。特别是孔径比生物酶的尺寸 ( 4 6 )稍大的情况下结合最稳定 ,其结合量可达 2 0 % ,以此结合体作为有机酸化反应的催化剂 ,呈现了很高的反应活性。此方法在环境工程上将有十分广阔的应用前景。