Highly selective determination of rhodium(III) using silica gel surface-imprinted solid-phase extraction

A novel Rh(III)-imprinted amino-functionalised silica gel sorbent was prepared by a surface imprinting technique for preconcentration and separation of Rh(III) prior to its determination by inductively coupled plasma atomic emission spectrometry (ICP-AES). Compared with the traditional solid sorbents and non-imprinted polymer particles, the ion-imprinted polymers (IIPs) had higher adsorption capacity and selectivity for Rh(III). The maximum static adsorption capacity of the imprinted and non-imprinted sorbent for Rh(III) was 29.86?mg?g^?1 and 11.23?mg?g^?1, respectively. The imprinted Rh(III) was removed with 2?mL of 3% thiourea?+?2?mol?L^?1 HCl. The obtained imprinted particles exhibited excellent selectivity and rapid kinetics process for Rh(III). The relatively selective factor (α_r) values of Rh(III)/Ru(III), Rh(III)/Au(III), Rh(III)/Pt(IV), Rh(III)/Ir(IV), Rh(III)/Pd(II) were 26.7, 39.0 29.2, 28.1, 43.7, respectively, which were greater than 1. The detection limit (3σ) of the method was 0.26?µg?L^?1. The relative standard deviation of the method was 1.79% for eight replicate determination of 10?µg of Rh³⁺ in 200?mL water sample. The method was validated by analysing standard reference material (GBW 07293), the results obtained is in good agreement with standard values. The developed method was also successfully applied to the determination of trace rhodium(III) in geological samples with satisfactory results.     

电感耦合等离子体原子发射光谱法测定钒铁中8个杂质元素含量和方法精密度的验证

提出了电感耦合等离子体原子发射光谱法(ICP-AES)测定钒铁中硅、磷、铝、锰、镍、铬、铜、钛共8个杂质元素含量的方法。钒铁样品(0.5000g),先后加入50%(体积分数)硝酸溶液20mL及50%(体积分数)盐酸溶液10mL,在100℃左右加热溶解,溶解过程中应注意保持溶液体积在25mL左右。将溶液过滤并置于200mL容量瓶中作为母液留用。将滤纸及不溶物一并移入铂坩埚中,置于马弗炉中,先于250℃灰化20min,稍冷后加入无水碳酸钠和硼酸(质量比2∶1)组成的混合熔剂0.3g,升温至950℃融熔15min。冷却,用体积比1∶10的盐酸溶液10mL浸出熔块,将此溶液与上述母液合并并加水定容至200mL。此溶液供ICP-AES在仪器工作条件下进行分析。绘制校准曲线时,加入纯铁和五氧化二钒作为基体,以消除基体干扰,然后加入上述8种元素的标准溶液,并按上述溶液最终稀释体积条件和仪器工作条件制作曲线(R大于0.999)。为验证所提出的分析方法的测定数据的精密度,约请了10个实验室对8个不同含量水平的钒铁样品对方法作协同试验,按GB/T 6379.2-2004所规定的方法求算了重复性标准偏差Sr和重复性限r,以及再现性标准偏差SR和再现性限R,并求得所测定的8种元素在各自的测定范围内的r与w之间和R与w之间的函数关系,说明该方法有较好的稳定性和准确性,而且证明此方法是可行的。     

ICP—AES法测定混合稀土铜合金中14种元素

本文研究了用ICP-AES法,不必化学分离,一次同时测定混合稀土铜合金名14种稀土和非稀土元素,获得满意结果。     

ICP－AES法同时测定电解金属锰中的硅、铁、硒和磷

本文研究了用ＩＣＰ－ＡＥＳ直接测定电解金属锰中的Ｓｅ、Ｐ、Ｓｉ、Ｆｅ等元素的方法，方法简便、快速，精密度和准确度均能满足对出口电解金属锰的检验要求。     

On-Line Separation and Preconcentration of Trace Metals in Biological Samples Using a Microcolumn Loaded with PAN-Modified Nanometer-Sized Titanium Dioxide,and Their Determination by ICP-AES

A flow injection analysis system incorporating a microcolumn of nanometer-sized TiO₂ loaded with 1-(2-pyridylazo)-2-naphthol (PAN) has been used for the development of an on-line multi-element method for simultaneous separation and preconcentration and subsequent determination of Cu²⁺, Co²⁺, Cr³⁺, Y³⁺, Yb³⁺ and Bi³⁺ by ICP-AES. Effects of pH, sample flow rate and volume, elution conditions, adsorption capacity and interfering ions on analyte recovery were examined. The adsorption capacity of nanometer-sized TiO₂ loaded with PAN was 4.73, 18.57, 3.81, 6.14, 4.52 and 20.35mgg^–1 for Cu²⁺, Cr³⁺, Y³⁺, Yb³⁺, Co²⁺ and Bi³⁺, respectively. The method has been applied to the analysis of trace elements in standard reference biological samples, and the results are in good agreement with the certified values.     

微波消解-ICP-AES测定鄱阳湖流域沉积物中微量元素

为了研究鄱阳湖沉积物中微量元素近几年来随季节、年度及沿程的变化情况,对2003年和2005年不同季节采集的鄱阳湖流域各采样点底泥进行了ICP-AES测定.结果表明,鄱阳湖沉积物中各元素的含量随着季节和年度变化而发生一定改变,枯水期普遍大于丰水期;南矶山2005年Cu和Pb含量较2003年有所降低;蔡家湾则与南矶山相反;姚公渡2005年Cu含量也较2003年低,Pb含量则高于2003年;与鄱阳湖流域底泥背景值相比,所测几个样点的Cu,Pb,Cr和Zn含量均在一定程度上超标;除大坞河外,其余各样点As含量均在背景值范围内;从饶河到鄱阳湖入湖口处,各元素含量呈逐渐降低趋势.文章提出的研究方法操作简便,效率高,劳动强度低.     

ICP-AES快速测定土壤中硫含量

采用ICP-AES研究土壤中硫含量的测定.以王水消解土壤试样,优化全谱型ICP-AES分析条件测定土壤中S的含量,检出限为5.7ng/mL(180.7nm)和8.6ng/mL(182.0nm).测定土壤标准物质中的S含量,测定结果在标称值范围内,连续测定10个平行样其相对标准偏差均小于2%.方法快速、简单、准确.     

原子吸收光谱法和ICP-AES测定水中钠的比较

测定水中钠的含量,ICP-AES具有直接进样、测量稳定、校准曲线线性范围宽等特点;而原子吸收光谱法需要加入消电离剂硝酸铯或氯化铯,实际操作麻烦.该方法经过t检验证明与标准方法无显著性差异,加标回收率为96.9%-104%,可以代替原子吸收光谱法,相对标准偏差各为0.7%、0.8%.     

ICP-AES测定锰矿中二氧化硅含量

试样经氢氧化钠和过氧化钠混合熔剂碱熔,再用酸浸提,干过滤后定容.采用ICP-AES测定锰矿中二氧化硅含量.本法测定锰矿标样(冶金部标准样品505)中二氧化硅含量,其测定结果的相对标准偏差RSD为1.08%,测定平均值为33.93%(标样推荐值为33.58%).     

ICP-AES测定饮用水中微量钼

应用ICP-AES直接测定生活饮用水中微量钼,检出限:0.01μg/mL;精密度:RSD 0.76%-2%;加标回收率:97.6%-105%.