600mm望远镜液晶自适应系统成像光路设计

为了与600 mm望远镜匹配以验证液晶自适应光学的有效性,利用Zemax光学设计软件进行了液晶自适应光学系统的设计和优化.根据望远镜的参量、大气湍流的特性和液晶的特点提出设计要求,然后进行光学系统设计和Zemax软件模拟优化,设计出了满足要求的系统.对该光学系统进行性能评价.设计出的系统与望远镜的组合焦距为35 m, F数为58.求得光学系统在像面处的极限线分辨力为44.8 μm,成像CCD的像元尺寸为16 μm,满足采样定理.液晶自适应光学系统的调制传递函数与衍射极限传递函数非常接近,而且系统的光程差像差在0.1λ左右,说明系统具备优良的光学性能.     

染料掺杂液晶激光器的光谱特性研究

首先从理论上计算出了染料(DCM)掺杂液晶激光器的泵浦阈值能量为9.2×10-7 J,从而选定了最适合的泵浦光源,并在此基础上设计了相应的泵浦光路。通过检测输出激光的光强和波长,从光栅周期、外加电场两个方面着手对激光器的输出光谱进行了特性研究,结果表明,通过改变光栅周期就可以实现出射激光波长在100 nm范围内(585～685 nm)的调谐,符合理论计算值。与此同时,通过施加外加电场也可以实现出射波长的调谐,虽然调谐范围较小,但是也实现了输出激光强度的调谐,强度调谐幅度高达90.2%。染料掺杂液晶激光器的波长和光强双向可调谐特性,大大拓展了其在全光网络通信的应用前景。但是,当电场从0 V·μm-1增加到20 V·μm-1时,出射激光的线宽也从0.4 nm增加到了1.5 nm,在激光器的可调谐应用中也应注意线宽的变化。     

Electro-optical properties of polymer stabilized cholesteric liquid crystal film

Liquid crystals (LCs) and polymers are extensively used in various electro-optical applications.In this paper,normal mode polymer stabilized cholesteric LC film is prepared and studied.The effects of chiral dopant and monomer concentrations on the electro-optical properties,such as contrast ratio,driving voltage,hysteresis width and response time,are investigated.The reasons of electro-optical properties influenced by the concentrations of the materials are discussed.Through the proper material recipe,the electro-optical properties of polymer stabilized cholesteric LC film can be optimized.     

Electrochemical properties of SnO2 nanorods as anode materials in lithium-ion battery

Well-dispersed SnO2 nanorods with diameter of 4-15 nm and length of 100-200 nm are synthesised through a hydrothermal route and their potential as anode materials in lithium-ion batteries is investigated. The observed initial discharge capacity is as high as 1778 mA·h/g, much higher than the theoretical value of the bulk SnO2 (1494 mA·h/g). During the following 15 cycles, the reversible capacity decreases from 929 to 576 mA·h/g with a fading rate of 3.5% per cycle. The fading mechanism is discussed. Serious capacity fading can be avoided by reducing the cycling voltages from 0.05-3.0 to 0.4-1.2 V. At the end, SnO2 nanorods with much smaller size are synthesized and their performance as anode materials is studied. The size effect on the electrochemical properties is briefly discussed.     

相变前的热力学平衡态对铁电液晶排列的影响

本实验选用ZLI-3654型铁电液晶(FLC)以及SE-3140型取向剂制备FLC器件样品,通过改变FLC相变过程中的降温速率以及相变前的热力学平衡态来研究FLC相变前的热力学平衡态对FLC排列的影响,共进行了十组实验.实验后,将FLC器件静态对比度进行比较,得出手性向列相到近晶A相(N^*-SmA)相变前的热力学平衡态对FLC实现均匀排列起着极其重要的作用的结论.实验结果表明:器件的静态对比度可高达620 ∶1, N^*-SmA相变前的热力学平衡态有利于形成高对比 关键词： 铁电液晶 降温速率 热力学平衡态 高对比度     

基于液晶/聚合物光栅的高转化效率有机半导体激光器

采用有机半导体发光材料聚[2-甲氧基-5-(2-乙基己氧基)-1,4-苯乙炔]作为增益介质,低官能度光敏单体制备的液晶/聚合物光栅作为外部反馈谐振腔,制备出参数可独立控制的分离式结构的有机半导体激光器.液晶/聚合物光栅中液晶分子的取向影响光栅折射率调制量,从而影响光栅的反馈能力,最终影响激光器出射激光的性能.通过研究发现决定液晶分子取向的主要有两种与光栅周期有关的作用力,利用这一原理制备不同周期的光栅,光栅周期小于450 nm时,相分离出的液晶分子取向由光栅矢量方向变为光栅沟槽方向,此时光栅的折射率调制量增加,光反馈能力增强.采用周期为395 nm的液晶/聚合物光栅制备二级布拉格散射的有机半导体激光器,相较于大周期光栅(593 nm)制备的激光器,激光阈值由0.70μJ/pulse降低至0.18μJ/pulse,转化效率由2.5%提高到6.4%,且出射激光垂直于基板表面发射,有利于后续的处理及应用.     

Electro-optical properties of high birefringence liquid crystal compounds with isothiocyanate and naphthyl group

Liquid crystal(LC) compound with isothiocyanate and naphthyl group is an attractive high birefringence LC material,and can be used in optical devices. In this paper, the electro-optical properties of a series of this type of LC compounds were investigated. The melting points and enthalpy values of these LC compounds were higher than those of corresponding compounds with the phenyl group. These compounds exhibited high birefringence with a maximum value of 0.66. Fluorine substitution in the molecular almost does not affect the birefringence value. When these LC compounds with the naphthyl group were dissolved in a commercial LC mixture, the electro-optical properties depending on temperature were investigated. In the low-temperature region, LC mixtures with the naphthyl-group LC compounds exhibited higher viscosity than pure commercial LCs. In the high-temperature region, viscosity values very closely approached each other. When response performance was investigated, figure-of-merit(Fo M) values were measured. The Fo M values of LC mixtures containing LC compounds with naphthyl group were lower than those of reference benzene LCs in the low-temperature region. However, in the high-temperature region, the results were reversed. These isothiocyanate LC compounds with naphthyl group can be applied in special fast-response LC device, particularly the ones used under high-temperature conditions.     

Diffractive characteristics of the liquid crystal spatial light modulator

The liquid crystal spatial light modulator (LC SLM) is very suitable for wavefront correction and optical testing and can produce a wavefront with large phase change and high accuracy. The LC SLM is composed of thousands of pixels and the pixel size and shape have effects on the diffractive characteristics of the LC SLM. This paper investigates the pixel effect on the phase of the wavefront with the scalar diffractive theory. The results show that the maximum optical path difference modulation is 41\,$\mu$m to produce the paraboloid wavefront with the peak to valley accuracy better than $\la$/10. Effects of the mismatch between the pixel and the period, and black matrix on the diffraction efficiency of the LC SLM are also analysed with the Fresnel phase lens model. The ability of the LC SLM is discussed for optical testing and wavefront correction based on the calculated results. It shows that the LC SLM can be used as a wavefront corrector and a compensator.     

适用于高空间频率透射式全息聚合物分散液晶光栅的材料研究

提出了适用于空间频率为3000 lp/mm的透射式全息聚合物分散液晶(HF-THPDLC)光栅的材料体系,并在反应动力学方面进行了深入的分析.为了能够得到高衍射效率并具有良好表面形貌的HF-THPDLC 光栅,首先确定了体系的平均官能度,使得预聚单体和液晶的扩散时间、液晶的成核时间以及于聚合物的凝胶时间达到最佳匹配状态...     

Low Driving Voltage and Analysis of Azobenzene Polymer Doped Liquid Crystal Grating

We mix azobenzene polymer and liquid crystal in certain ratio. Then the mixture is injected into cells. Nonlinearly photoinduced birefringence takes place when linearly polarized ultraviolet is applied with the pattern photomask covering on the cells, which results in the formation of azobenzene polymer doped liquid crystal grating. The obtained grating is characterized by an optical microscope and a He-Ne laser. The results indicate that the samples have clear grating structure, and the diffraction efficiencies can be modulated by electric field. The sample driving voltage is 0.6 V/μm. It is lower than the driving voltage of holographic polymer dispersed liquid crystal transmission grating and could be matched with the driving integrated circuit.