核-壳型聚丙烯酸酯复合乳液

简述了核-壳型聚丙烯酸酯复合乳液的合成方法、形态及其影响因素与判断方法、结构与性能等方面的研究进展;认为核-壳型复合乳液膜机械性能优良的原因是:核、壳两相间存在的过渡区适当地抑制了二者的相分离。     

用二维色谱技术测定聚合反应气体组成

介绍一种无阀切换的二维气相色谱分析方法。采用两根不同性质的色谱柱并联连接，样品分别经两根色谱柱分离后汇合在一起进入同一检测器。一次进样可同时测定Ｈ２、Ｏ２、Ｎ２及Ｃ１～Ｃ３的组分。     

Preliminary study on dual fluorescence behavior of porphyrin

It is well known that porphyrin derivatives play a key role in the primary process of photo-synthesis[1], in which porphyrins directly absorb the sunlight or indirectly acquire excitation en-ergy from light-harvesting antenna system to reach their excited state, and then donate electrons to quinone acceptors to yield a series of charge-separated species. In general, only first singlet ex-cited state of porphyrins is involved in energy transfer process[2]. However, highly excited state (S2 stat…     

LaSrBO4型复合氧化物的合成及其CO氧化活性研究

LaSrBO4(B=Cu、Ni、 Co、 Fe、 Mn、 Cr ) was studied with respect to their preparation, characteristics and catalytic oxidation activity by means of XRD, XPS, electric conductivity and activity evaluation. Results showed that the calcination temperature has great influence on the formation of the phases of such samples, and was associated with the radius of B ion. The greater the B ion radius, the higher the calcination temperature required for the formation of the phases. It was also found that the activity and the relative content of adsorptive oxygen and lattice oxygen on the sample surf are, the activation energy of electron conduction and the CO oxidation activity may vary with different B ions, and demonstrate a dual-peak pattern with the increase in the number of 3d electrons of the B ion.     

TDI三聚体的合成研究

以一种碱金属羧酸盐K-1000作为甲苯二异氰酸酯(TDI)三聚反应的催化剂合成了以TDI三聚体为主要成分的多异氰酸酯固化剂。对合成工艺条件进行了探讨。结果表明,将反应温度控制在35℃,催化剂K-1000用量为0.06%时,用苯甲酰氯作为阻聚剂可得到性能基本稳定的TDI三聚体产品。     

腔靶X射线辐射对称特性实验观测

在“神光”装置上用两种特殊结构的实验靶型,通过两个不同方位的诊断孔观测腔内壁Ｘ光再辐射的空间能谱结构和Ｘ光辐射总量,分别研究了与激光第一打击面完全对称和不对称的腔内壁（两个被观测位置相差９０°）Ｘ光辐射能谱和辐射能量的对称性,并对测量结果进行了简要的分析讨论．     

镓铟锡液滴撞击泡沫金属表面的运动学特性研究

常温下为液态的镓铟锡合金以其优异的导热性能在具有特殊要求的传热领域有着重要的应用价值,与传统流动介质相比较大的表面张力使得其产生的流动现象必有所区别.本文研究镓铟锡所形成的液滴撞击泡沫金属表面后所产生的铺展、回缩及回弹现象.采用高速相机拍摄液滴投影轮廓随液滴运动的变化过程,并通过图像处理获得不同撞击速度、底板表面孔径下的液滴铺展系数、中心位置轮廓高度以及液滴回弹后在空中的振动特性.研究结果表明:具有较高表面张力的镓铟锡液滴的铺展系数随无量纲时间的变化在铺展初始阶段仍满足常规流体的1/2次幂关系,只在铺展后期与底板的无量纲孔径有关系;液滴的最大铺展系数在较小无量纲孔径底板大于在光滑镍板,且随底板无量纲孔径增大而逐渐减小;在回弹过程,由于底板孔隙结构的存在使得液滴回弹后在空中的振动呈现3种形态:规则的横向和纵向振动、带旋转的横向和纵向振动以及旋转振动;最后,通过对振动频率的拟合和分析,进一步拓展了传统振动频率理论公式在非规则振动过程预测中的应用.      

Investigation of magnetization reversal process in pinned CoFeB thin film by in-situ Lorentz TEM

Exchange bias effect has been widely employed for various magnetic devices.The experimentally reported magnitude of exchange bias field is often smaller than that predicted theoretically,which is considered to be due to the partly pinned spins of ferromagnetic layer by antiferromagnetic layer.However,mapping the distribution of pinned spins is challenging.In this work,we directly image the reverse domain nucleation and domain wall movement process in the exchange biased Co Fe B/Ir Mn bilayers by Lorentz transmission electron microscopy.From the in-situ experiments,we obtain the distribution mapping of the pinning strength,showing that only 1/6 of the ferromagnetic layer at the interface is strongly pinned by the antiferromagnetic layer.Our results prove the existence of an inhomogeneous pinning effect in exchange bias systems.     

基于O2-O2吸收的非相干宽带腔增强吸收光谱浓度反演方法研究

针对传统非相干宽带腔增强吸收光谱浓度反演方法的定量结果易受镜片反射率标定误差的影响问题, 提出了一种基于测量大气O₂-O₂吸收的浓度反演方法. 该方法是将非相干宽带腔增强吸收光谱技术的光学增强腔等效成吸收光程不随波长变化的多次反射池, 首先根据测得的宽带腔增强大气吸收谱和参考谱计算出光学厚度, 并应用差分光学吸收光谱算法拟合修正后的气体吸收截面到光学厚度, 反演得到大气中O₂-O₂以及被测气体的柱浓度, 然后根据O₂-O₂在大气中的含量已知且相对稳定这一特性, 确定出等效多次反射池的吸收光程, 最后从被测气体的柱浓度中扣除吸收光程信息得到被测气体的浓度值. 以监测大气中NO₂实验为例, 应用该方法在454-487 nm波段反演得到了大气NO₂的浓度(1-30 ppbv范围内), 并将反演结果与传统浓度反演方法的结果进行了对比, 发现两者的不一致性在7%以内. 实验结果表明, 非相干宽带腔增强吸收光谱技术可以利用大气O₂-O₂的吸收来定量其他被测气体的浓度, 而且定量结果对镜片反射率的标定误差不敏感.