新型样品前处理材料在环境污染物分析检测中的研究进展

针对复杂样品的分析和痕量目标物的检测,样品前处理是必不可少的,高效的样品前处理技术不仅可以去除或减小样品基质干扰而且能够实现分析物的富集,提高分析检测的准确性和灵敏度。近年来,固相萃取、磁分散固相萃取、枪头固相萃取、搅拌棒萃取、固相微萃取等高效的样品前处理技术已在环境污染物分析检测中获得广泛关注,萃取效率主要取决于萃取材料,所以新型的高效萃取材料一直是样品前处理研究领域的重要发展方向。该文总结和讨论了近年来新型样品前处理材料在环境污染物分析检测中的研究进展,主要聚焦在石墨烯、氧化石墨烯、碳纳米管、无机气凝胶、有机气凝胶、三嗪基功能材料、三嗪基聚合物、分子印迹聚合物、共价有机框架材料、金属有机框架材料以及它们的功能化萃取材料等。这些材料已经被应用于环境样品中不同类别污染物的萃取富集,如重金属离子、多环芳烃、塑化剂、烷烃、苯酚、氯酚、氯苯、多溴联苯醚、全氟磺酸、全氟羧酸、雌激素、药物残留、农药残留等。这些样品前处理材料具有高的表面积、大量的吸附位点,并涉及多种萃取机理如π-π、静电、疏水、亲水、氢键、卤键等相互作用。基于这些萃取材料的多种样品前处理技术与各类检测方法如色谱、质谱、原子吸收光谱、荧光光谱、离子迁移谱等相结合,已广泛应用于环境污染物的高灵敏分析检测。最后,该文总结了样品前处理发展中存在的问题,并展望了其未来在环境分析中的发展趋势。     

波长可调谐和异步双波长锁模掺铒光纤激光器

利用激光诱导沉积法制备了碳纳米管可饱和吸收体,结合偏振控制器和保偏光纤产生的双折射滤波效应,在同一个环形掺铒光纤激光器中实现了波长可调谐,并获得了两种异步双波长锁模状态。通过调节泵浦功率和偏振控制器,获得了中心波长在1550 nm附近稳定可自启的锁模,波长可调谐范围为8.88 nm。同时,获得了两种异步双波长锁模状态,重复频率均约为49.9 MHz,脉冲重复频率差分别为1395 Hz和1089 Hz。     

碳纳米管透明导电薄膜的可控制备

碳纳米管具有优秀的导电性能、 透光性能和十分突出的柔性, 在柔性透明导电薄膜中有着良好的应用前景. 如何制备同时拥有良好导电性能和透光性能的碳纳米管薄膜是这一领域研究的核心问题. 本综述介绍了碳纳米管薄膜的制备方法, 并重点讨论了基于漂浮催化剂化学气相沉积法的碳纳米管薄膜的可控制备. 在生长过程中限制碳纳米管的团聚、 增加碳纳米管的长度、 降低杂质的含量是提高碳纳米管薄膜性能的主要策略.     

Preparation and Properties of Poly（ether ether ketone）/Carbon Nanotube Modified Polypropylene Janus Composite Separator北大核心CSCD

Lithium-ion batteries （LIBs）have attracted wide attention because of their broad prospects in electric vehicles. However,the safety problems and low multiplier performance of the commercial polyolefin separator limit their further development,due to the poor dimensional thermal stability and low electrolyte absorption rate. Poly（ether ether ketone）（PEEK）and carbon nanotube（CNT）are compounded to coat on polypropylene （PP） to prepare Janus composite separator （PP@C） through the phase inversion method. PP@C composite separator does not deform at 180 ℃ for 0. 5 h（only slight deformation）,illustrating excellent thermal stability. The electrolyte absorption rate of PP@C2 is 193. 8%. The electrolyte uptake rate of the PP@C2 composite membrane was 193. 8%,which was 64. 5% higher than the PP membrane,showing a superduper electrolyte permeability. As a result,the specific discharge capacity of LIBs assembled with PP@C2 composite separator is 157. 6 mA·h/g at 0. 2 C and 129. 8 mA·h/g at 2 C,showing good rate performance with the capacity recovery rate of more than 99%. This might be attributed to the ultra-high thermal stability of PEEK,the good affinity of the electrolyte,the high conductivity of CNT,as well as the uniform dispersion of Li+ ,so that the separator can have excellent electrochemical performance while improving safety. © 2022, Science Press (China). All rights reserved.     

无机纳米材料在骨代谢调控中的应用

与有机和高分子纳米材料相比,无机纳米材料具有化学性质稳定、力学性能优良、生物相容性和骨诱导性良好等优势,是用于骨代谢调控的主要材料。文章分别从细胞、分子及动物水平总结了羟基磷灰石、稀土纳米材料、金纳米颗粒、碳纳米管等无机纳米材料在骨代谢调控中的作用及其机制,并对无机纳米材料在骨代谢调控中面临的挑战进行了展望。     

基于探针底物法的高效液相色谱-串联质谱法测定蚯蚓体内4种CYP同工酶活力及其应用北大核心CSCD

基于探针底物法,将蚯蚓微粒体悬浮液加入至含有混合探针底物香豆素(50μmol·L^(-1))、安非他酮(25μmol·L^(-1))、阿莫地喹(50μmol·L^(-1))、右美沙芬(5μmol·L^(-1))的孵育体系中(微粒体蛋白质量浓度需控制在32~96 mg·L^(-1)内),于37℃孵育20 min后,加入甲醇终止反应,静置10 min后过0.22μm滤膜,采用高效液相色谱-串联质谱法测定对应的代谢物7-羟基香豆素、羟基-安非他酮、N-脱乙基阿莫地喹、右啡烷的生成量。根据相应代谢物的生成量分别评价蚯蚓CYP2A6、CYP2B6、CYP2C8及CYP2D6酶活力。采用Acquity UPLC HSS T3柱作为分离柱,以不同体积比的含1 mmol·L^(-1)乙酸铵的0.05%(φ)甲酸溶液和甲醇的混合溶液作为流动相进行梯度洗脱,串联质谱中采用电喷雾离子源正离子模式和多反应监测模式检测,并用基质匹配法配制混合标准溶液系列。结果显示:7-羟基香豆素、羟基-安非他酮、N-脱乙基阿莫地喹、右啡烷的质量浓度均在2.5~50μg·L^(-1)内与其对应的峰面积呈线性关系;对空白样品进行3个浓度水平的加标回收试验,回收率为73.7%~103%,日内相对标准偏差(RSDs,n=5)为2.1%~11%,日间RSDs(n=5)为4.6%~10%。方法用于分析分别暴露于多壁碳纳米管染毒土壤(暴露组)和普通土壤(对照组)21 d后蚯蚓体内4种CYP同工酶的活力,CYP2C8酶活力明显高于CYP2A6、CYP2B6及CYP2D6,暴露组中CYP2A6及CYP2C8酶活力显著(P<0.05)高于对照组,而CYP2B6及CYP2D6酶活力与对照组的无显著性差异,因此推测可将CYP2A6及CYP2C8作为一套生物标记物,用于定性诊断土壤的多壁碳纳米管污染。     

CARBON NANOTUBES VIA METHANE DECOMPOSITION ON AN ALUMINA SUPPORTED COBALT AEROGEL CATALYST

An alumina-supported cobalt aerogel catalyst prepared from a sol-gel and a supercritical drying method was used in the catalytic decomposition of methane.The physical-chemical properties of the catalyst were characterized and its activity for methane decomposition was investigated.The effects of calcination and reaction temperatures on the activity of the catalyst and the morphology of the carbon nanotubes produced were discussed.A COAl2O4 spinel structure formed in the calcined catalyst.The quantity of the nanotubes produced in the reaction increases with the amount of cobalt in the reduced catalyst.A higher reaction temperature leads to a higher reaction rate,though faster deactivation of the catalyst occurs with the change.The carbon nanotubes grown on the catalyst have smooth walls and uniform diameter distribution.     

碳纳米管-聚丙烯酸乙酯复合乳液的制备及其润滑性能研究

采用乳液聚合方法合成了碳纳米管一聚丙烯酸乙酯(CNTs—PEA)复合乳液;采用JEM100XI型透射电子显微镜(TEM)观察了复合乳液的微观形貌;采用MQ-800型四球摩擦磨损试验机和MM-200型环一块摩擦磨损试验机考察了CNTs—PEA复合乳液作为水基润滑添加剂的摩擦学性能;并采用JSM-35型扫描电子显微镜(SEM)分析了磨斑表面．结果表明,CNTs—PEA复合乳液在极低浓度下即可有效地提高水基液的承载能力和抗磨性能．     

化学镀耐磨自润滑Ni-P复合镀层的摩擦磨损性能

利用化学复合镀技术制备了Ni-P-碳纳米管(Ni-P-CNTs)和Ni-P-无机类富勒烯WS2[Ni-P-(IF-WS2)]复合镀层,考察了复合镀层的减摩抗磨性能.结果表明,Ni-P-CNTs和Ni-P-(IF-WS2)复合镀层的减摩抗磨性能优于化学镀Ni-P和Ni-P-石墨镀层,其原因在于Ni-P-CNTs化学复合镀层中的碳纳米管具有优异力学性能和同轴石墨纳米管结构,而Ni-P-(IF-WS2)化学复合镀层中的IF-WS2具有封闭层状类富勒烯球形结构,二者均具有优异的自润滑性能.     

INTERACTION-MEDIATED GROWTH OF CARBON NANOTUBES ON ACICULAR SILICA-COATED α-Fe CATALYST BY CHEMICAL VAPOR DEPOSITION

Multi-walled carbon nanotubes (MWNTs) with 20 nm outer diameter were prepared by chemical vapor deposition of ethylene using ultrafine surface-modified acicular α-Fe catalyst particles.The growth mechanism of MWNTs on the larger catalyst particles are attributed to the interaction between the Fe nanoparticles with the surface-modified silica layer.This interaction-mediated growth mechanism is illustrated by studying the electronic,atomic and crystal properties of surface-modified catalysts and MWNTs products by characterization with X-ray diffraction (XRD),transmission electron microscopy (TEM),high resolution transmission electron microscopy (HRTEM),thermal gravimetric analysis (TGA) and Raman spectra.