广义热波长:定义、意义和应用

光子气体和低温下强简量子气体都不是经典理想气体,通常的热波长没有意义。但是,它们存在每个粒子的平均动量,因此可以定义广义热波长.这个热波长是系统量子相干性的一个量度,在非简并条件下,实物粒子系统广义热波长回到通常的热波长.简并条件下,热力学系统的线度必须大于广义热波长,因此导致了对热力学系统出现相关现象的最小线度,即最小线度判据.本文利用这一判据给出了一些典型系统的最小线度.     

Reference-frame-independent quantum key distribution of wavelength division multiplexing with multiple quantum channels

Reference-frame-independent quantum key distribution (RFI-QKD) can allow a quantum key distribution system to obtain the ideal key rate and transmission distance without reference system calibration, which has attracted much attention. Here, we propose an RFI-QKD protocol based on wavelength division multiplexing (WDM) considering finite-key analysis and crosstalk. The finite-key bound for RFI-QKD with decoy states is derived under the crosstalk of WDM. The resulting secret key rate of RFI-QKD, which is more rigorous, is obtained. Simulation results reveal that the secret key rate of RFI-QKD based on WDM is affected by the multiplexing channel number, as well as crosstalk between adjacent channels.     

Characterization of a wavelength selection method using near-infrared spectroscopy and partial least squares with false nearest neighbors and its application in the detection of the chemical oxygen demand of waste liquid

Abstract

The spectral wavelength selection method is important in near-infrared spectroscopy. Eliminating redundant information and extracting useful information can improve the prediction accuracy and modeling efficiency of the quantitative analysis model for spectral analysis to obtain a near-infrared calibration model with strong predictability and good robustness. This paper proposes a wavelength selection method for near-infrared spectroscopy by combining the partial least squares and false nearest neighbor methods. In this method, the correlation between the characteristic wavelength variables and the measured index is assessed by means of a similarity-based distance measure of the characteristic wavelength variable, and the characteristic wavelength is selected according to the order of the correlation. The method was used to select characteristic wavelengths from the near-infrared spectrum of waste liquid to establish a prediction model for the chemical oxygen demand. Compared with the full-spectrum partial least squares and interval partial least squares based models, the number of characteristic wavelength variables is reduced from 1557 to 176, and the prediction accuracy of the model is improved. This method both simplifies the model and achieves higher prediction accuracy. Therefore, this study provides a novel solution for wavelength selection for multivariate calibration in near-infrared spectroscopy.     

112 Gbit/s信号混传多种速率信号的非线性效应影响

主要研究在波长间隔50GHz的密集波分复用系统中,112Gbit/s偏分复用差分四相移键控信号在不同速率的相邻信道影响下经过长距离传输后的非线性容忍度。实验结果表明,112Gbit/s信号结合43Gbit/s信号或者10Gbit/s信号传输时系统得到较好的非线性容忍度,验证了在严重的非线性效应存在的情况下同步传输系统的可行性。     

光学材料光学均匀性的波长调谐两步绝对测量法

光学均匀性是光学材料的重要指标,目前高精度的测量方法一般采用绝对测量法,而该方法步骤繁琐,容易受环境影响。根据波长移相干涉仪的移相特点,提出了测量光学材料光学均匀性的波长调谐两步绝对测量法。该方法在波长移相干涉仪中通过平行平板放入测量和空腔测量两个步骤得到平行平板的光学均匀性。在模拟仿真验证方法的正确性后,进行了实验研究,并与传统的绝对测量法的测量结果进行比较。结果表明,波长调谐两步绝对测量法可用于测量平行平板的光学均匀性,且测量步骤简单,精度较高。     

C波段半波长开路谐振器平行耦合滤波器的研制

采用切比雪夫低通原型滤波器综合法,设计了一种半波长开路谐振器平行耦合滤波器,该类型滤波器具有插入损耗低、结构简单、容易实现等诸多特点。从测试结果看出,实际测试值与理论分析及MWO软件仿真结果基本一致。     

长周期光纤光栅折射率特性仿真的新方法

基于长周期光纤光栅的模式耦合机理,提出一种快速模拟长周期光纤光栅折射率特性的方法。该方法在计算包层模式的有效折射率时分开计算,在环境折射率小于包层折射率时采用二分法和分步搜索法结合计算包层模式的有效折射率,在环境折射率大于包层折射率时采用Nelder-Mead加分步搜索法求解包层模式的有效折射率。在应用谐振波长的决定式求解与环境折射率的匹配的谐振波长时,采用变区间应用二分法求解而不是传统的逐步搜索法求解谐振波长。数值结果与实验结果做了对比,两者基本一致。实践证明,该方法方便快捷,比一般的方法速度提高7倍以上。     

微型光纤光谱仪波长标定技术的研究

为了得到准确的光谱测量结果,对AvaSpec-2048微型光纤光谱仪进行了标定实验设计。根据标定实验结果,采用两种不同的数学算法,使用MATLAB软件,得到了标定方程和拟合曲线。为了验证标定结果的准确性,设计了验证实验,通过对比验证实验结果得到最佳标定方程。     

基于光子晶体光纤中FWM的4×10 Gbit/s全光波长转换

 多波长转换对于增强波分复用光网络的灵活性具有重要意义。基于光子晶体光纤中的多四波混频原理,实现了4×10 Gbit/s全光波长转换,深入调查了泵浦功率、光纤长度、信号光与泵浦光偏振失配对波长转换信号质量的影响。结果表明：当泵浦光功率从6 dBm到20 dBm增长的过程中,转换信号Q因子随泵浦光功率增大而增大,最大为82.01,光纤长度从50 m到120 m变化过程中,转换信号Q因子最大为57.41,而随着信号光与泵浦光偏振失配角的增大,转换信号Q因子逐渐降低,当失配角大于60°后,转换信号质量急剧下降。     

Opportunities for wavelength conversion with on‐chip diamond ring resonators

Recent progress in the fabrication of high‐quality synthetic diamond and of diamond waveguide structures has enabled photonics researchers to start exploiting the unique optical properties of diamond for various applications. In this article the promise of on‐chip diamond ring resonators for wavelength conversion based on Kerr and Raman‐resonant four‐wave mixing is numerically demonstrated. After examining to what extent both dispersion‐engineered phase‐matching and “automatic” quasi‐phase‐matching can be established in diamond ring converters, it is shown that such a “double‐matching” approach can yield high conversion efficiencies for a wide range of wavelengths in the near‐infrared/mid‐infrared domain, as well as in the ultraviolet/visible domain.