基于无网格Galerkin法的穿甲侵彻数值模拟

将无网格Galerkin法与LS-DYNA软件相结合,建立了穿甲侵彻的分析模型,对三维球形弹体侵彻双层无限大钢靶板进行了数值模拟,解决了该过程中出现的负体积现象,并将结果与空穴膨胀理论和有限元法进行了对比,所得结果证实了无网格Galerkin法在模拟穿甲侵彻时的可行性与优越性.     

大孔径双向聚能射孔弹的研究

 设计了一种双锥药型罩与双向装药结构相结合的聚能射孔弹模型,通过数值模拟方法研究其射流成型机理,并计算其射流参数。结果显示：双锥药型罩的小锥角部分形成聚能射流,大锥角部分形成翻转弹丸,射流头部和弹丸的速度分别为6 250 m/s和1 620.9 m/s,弹丸长度和平均直径分别为26.1 mm和8.6 mm。结合数值模拟结果,对射流侵彻公式进行了修正,并利用修正公式预测该射孔弹侵彻钢靶的深度,计算结果为69.6 mm。最后,按照该模型进行侵彻实验,实验回收弹丸的长度和平均直径分别为28.1 mm和8.8 mm,侵彻钢靶的深度和孔径分别为70 mm和17 mm。实验表明：数值模拟与理论计算方法相结合是可行的,能够有效地计算射孔弹的射流参数并预测其侵彻深度;该射孔弹侵彻性能优越。     

杆式射流侵彻半无限靶的理论分析

 理论分析高速杆式射流侵彻半无限靶过程时,考虑速度梯度对聚能射流的影响,将射流进行分段计算,得到了射流拉伸后实际碰靶时的微元长度和直径变化。采用伯努利方程和静力学方法,通过对射流形状和速度分布作线性近似,理论分析了高速杆式射流侵彻半无限靶的过程,得到了靶体中的侵彻深度和侵彻孔径与射流长度、速度及直径之间的关系。将模拟结果与实验结果进行对比,结果表明理论分析结果与侵彻实验结果符合较好。     

球形钨合金破片终点弹道性能实验研究

实验研究了球形钨合金破片的速度衰减规律、爆轰驱动下的变形和破碎、对半无限钢靶的侵彻以及对薄钢靶的贯穿。结果表明:(1)破片长距离(120m)飞行时的衰减系数为常数,阻力系数与破片初速成线性关系;(2)在爆轰驱动下,直径为6.0和7.5mm的破片破碎率为2%～3%,而直径为8.5mm的破碎率为45%;(3)破片长距离飞行后仍有很强的穿甲能力。     

大长细比弹体斜侵彻混凝土靶的动力学响应

基于刚塑性自由梁在横向冲击载荷下的动力学响应研究方法,结合空腔膨胀理论给出的弹体载荷分析,给出了弹体作为自由梁在塑性铰出现之前的响应行为,得到了梁内任一截面在横向载荷下剪力和弯矩分布规律以及轴向载荷下的轴力分布规律。计算结果表明,大长细比结构弹体的危险截面在承受较大轴向惯性压力载荷后,对由非正侵彻导致的横向载荷极为敏感。最后基于压弯联合作用载荷分析,给出了动能弹设计的抗弯极限壁厚要求。     

Electrode metal penetration of amorphous indium gallium zinc oxide semiconductor thin film transistors

Penetration effects of various electrode materials, namely Al, Au, and Cu, on the physical and electrical characteristics of amorphous oxide semiconductor thin film transistors (TFTs) were investigated. Amorphous indium gallium zinc oxide (a-IGZO) TFTs were fabricated with conventional staggered bottom gate structures on a p-type Si substrate. X-ray photoemission spectroscopy (XPS) analysis under the electrode deposition area revealed variations in the oxygen bonding states and material compositions of the a-IGZO layer. Field-emission scanning electron microscopy (FE-SEM) with the line scan of energy dispersive spectroscopy (EDS) showed lateral penetration by the electrode metal. To compare the electrical characteristics of the tested TFTs, the initial current–voltage (I–V) transfer characteristics were examined. In addition, the tested TFTs fabricated using various electrode materials were tested under bias stress to verify the correlations between variations in TFT characteristics and both the metal work function and penetration-induced oxygen vacancies in the channel around the contact area.     

Implementation of depth-dependent soil concentrations in multimedia mass balance models

In standard multimedia mass balance models, the soil compartment is modeled as a box with uniform concentrations, which often does not correspond with actual field situations. Therefore, the theoretically expected decrease of soil concentrations with depth was implemented in the multimedia model SimpleBox 3.0. The effects of this implementation on the model outcomes were explored for nine compounds in four environmental compartments. For compounds with a low penetration depth, the new model predicts substantially higher or lower concentrations in the vegetation compartment than the old model. For those compounds, predicted concentrations in surface water and air were higher in the new model, but the deviations from the old model were smaller than in the vegetation compartment. For compounds with a large penetration depth, the model adaptations show little effect. No field study was carried out to validate the results of the model calculations, but we did collect measured data on concentrations in vertical soil profiles from literature. According to those data, we concluded that the implementation of depth dependent soil concentrations might be a useful extension for steady state multimedia mass balance models. More field study has to be carried out to validate the model outcomes.     

细长尖头刚性弹对金属靶板的斜侵彻/穿甲分析

给出细长尖头刚性弹（如尖卵、尖锥形）斜侵彻/穿甲金属靶的一个分析模型。在细长尖头弹对中厚度金属靶的斜穿甲中,韧性孔洞扩张为主要的穿甲机理;着靶初期,发生方向角的改变。研究表明,金属靶的斜穿甲仅由4个量纲一参数控制,即冲击函数I、弹体几何函数N、量纲一靶厚和撞击斜角。分析得到显式的侵彻深度、终点弹道极限、剩余速度和撞击方向改变角表达式。该模型可预期跳飞发生的临界条件。理论预期与实验结果吻合较好。     

卵形杆弹对铝靶的斜侵彻

在Lagrange有限元基础上,扼要介绍了一种适用于三维斜侵彻数值模拟计算的滑移面处理技术。该方法放弃了传统滑移计算中从单元的设置,而代之以预设从节点,从而避免三维斜侵彻数值计算中主从单元的相交、滑移面的识别、修正与再定义的困难。在确保计算精度的同时,有效地提高了计算效率。卵形杆弹对铝靶侵彻的系列数值模拟计算表明,无论对于正撞击或斜撞击,本文中所获结果与实验结果都有良好的一致性,这说明本文中所述方法和所建程序的合理性和有效性,为侵彻贯穿过程的数值分析提供了一种实用和有效的手段。     

着靶速度对刚玉块石混凝土抗侵彻性能的影响

着重对不同着靶速度下,弹体在刚玉块石混凝土中的侵彻情况进行了试验。研究结果表明,弹体的侵彻深度不随靶速度的提高而增加。这与弹体在普通混凝土和岩石中的侵彻现象明显不同,主要是由侵彻弹体发生破坏失去了继续侵彻能力造成的。而且,与普通混凝土或岩石相比,着靶速度越高,刚玉块石混凝土的抗侵彻性能越强。