孔压静力触探(CPTU)测试成果影响因素及原始数据修正方法探讨

孔压静力触探(CPTU)是20世纪80年代在国际上兴起的新型原位测试技术,因其诸多优点,目前在欧美诸国已得到广泛应用。由于探头规格、技术标准和操作程序的差异,影响CPTU测试成果的因素很多,而且其影响程度也各不相同。根据前人的研究成果,对CPTU测试成果的影响因素进行了分析总结,以期在CPTU资料整理和应用中引起重视。最后,简要论述了考虑诸多影响因素的原始数据修正方法。     

射流对工业炸药的引爆及侵彻机制

本文用脉冲X光摄影技术及电探极-记录仪系统,对射流引爆及侵彻工业炸药的过程进行了观测,探讨了的流引爆及侵彻工业炸药的机制,给出了射流与工业炸药作用过程的物理图象。     

间隔靶对射流侵彻影响的数值模拟和实验研究

对某聚能装药射流侵彻靶板的过程进行了数值模拟 ,得出其碰撞点附近应力分布与传统理论相符 ,侵彻深度与实验结果及工程计算结果基本相符 ;分别对该聚能装药侵彻连续靶和间隔靶的过程进行了数值模拟 ,数值模拟结果显示间隔靶的侵彻深度明显低于连续靶的侵彻深度 ,这说明侵彻开坑阶段的能耗侵深比远大于准定常阶段。为了验证间隔靶对射流侵彻的影响 ,用另一聚能装药分别对连续靶和间隔靶进行了侵彻实验 ,并排除了炸高的影响。实验结果也表明 ,间隔靶对射流侵彻的确存在着不利影响。还结合数值模拟及实验结果对传统的侵彻公式进行了修正。     

Overwinter changes to near-surface bulk density, penetration resistance and infiltration rates in compacted soil

Previous studies at Yakima Training Center (YTC), in Washington State, suggest freeze-thaw (FT) cycles can ameliorate soil compacted by tracked military vehicles [J. Terramechanics 38 (2001) 133]. However, we know little about the short-term effects of soil freezing over a single winter. We measured bulk density (BD), soil penetration resistance (SPR), and steady-state runoff rates in soil newly tracked by an Abrams tank and in uncompacted soil, before and after a single winter at YTC. We similarly measured BD, SPR and saturated hydraulic conductivity (k_fs) in simulated tank tracks at another site near Lind Washington. Average BD was significantly greater in tank ruts at YTC and in simulated tracks at the Lind site than in uncompacted soil soon after tracking and did not change significantly during the winter of 1997–1998. Measurements of SPR were strongly influenced by soil moisture. When soil was moist or tracks were newly formed, SPR was significantly higher in tank ruts than in uncompacted soil from the surface to a depth of about 10–15 cm. The greatest average SPR in compacted soil was observed between 4 and 6 cm depth. We observed less difference in SPR between tank ruts and uncompacted soil near-surface at YTC as the time after trafficking increased. We observed highest SPR ratios (compacted rut:undisturbed) in fresh tracks near the surface, with lower ratios associated with increasing track age or soil depth, indicating that some recovery had occurred at YTC near-surface. However, we did not observe a similar over-winter change in SPR profiles at the Lind site. Rainfall simulator data from YTC showed higher steady-state runoff rates in tank ruts than over uncompacted soil both before and after winter. However, more time was required to reach steady-state flow in tank ruts and the proportion of runoff was slightly lower in May 1998 than in August 1997. At the Lind site, k_fs was lower in newly compacted soil than in one-year old compacted soil or uncompacted soil. Our data suggest that indices of water infiltration such as steady-state runoff rates or k_fs, are more sensitive indicators of soil recovery after compaction than are BD or SPR.     

高g值冲击下存储测试电路模块缓冲保护研究

为了采用弹载存储测试技术记录弹体高速侵彻硬目标过程中的加速度—时间曲线,必须对存储测试电路模块进行缓冲保护。本文利用非线性缓冲理论、技术,选择较理想的缓冲材料,设计出缓冲器件-泡沫铝试件,进行了静态压缩,得到应力-应变曲线,采用LS-DYNA模拟了空气炮冲击实验中泡沫铝试件的缓冲效果,并对应用于某型号弹侵彻混凝土靶的存储测试电路模块进行了缓冲保护,提高了数据的捕获率和电路模块的重复使用次数。通过试验证明了所设计缓冲器件对电路模块具有保护效果。     

聚能射流侵彻的一种耦合算法

介绍了一种能有效模拟聚能射流侵彻过程的计算方法，即二维数值解和解析解相耦合的方法。实际应用表明，此方法计算结果准确可靠，经济省时，其软件是聚能装药优化设计的实用工具。     

Effective detection of benzoyl peroxide in flour based on parameter selection of Raman hyperspectral system

Penetration depth and spatial resolution of Raman hyperspectral imaging system were studied for effective detection of benzoyl peroxide in flour. The determinations of parameters were achieved by using the single-band background-correct image of a benzoyl peroxide Raman characteristic band and a simple threshold method. The selected parameters were used to detect mixture samples with different concentrations. Percentage of detected benzoyl peroxide pixels was positively correlated to its concentration. The result shows that parameters selected in this study are effective for the detection of benzoyl peroxide additive in flour and can be used for quantitative analysis in the future.     

On the penetration of a rotating impactor into an elastic-plastic medium

This research is devoted to the modeling of high-speed rectilinear penetration of a rigid axisymmetric body (impactor with a flat bluntness) into an elastic–plastic media with account for its rotation about the axis of symmetry. The body has an arbitrary shape of the meridian. The resistance to the motion is represented as the sum of the body drag and the contribution of friction. The dynamic system governing the body motion is derived and the qualitative and numerical analysis of the projectile movement and perforation of a slab are performed. The problem of shape optimization of impactor with a flat bluntness is studied using evolutionary algorithm.     

考虑防御系统延迟使其预测误差最大的突防弹道设计

对中段多脉冲机动突防弹道的设计问题进行了研究。采用的原理与方法有别于成熟的航天器多脉冲变轨,而是基于路径规划的思想对弹道设计问题简化。考虑敌方防御系统延迟,改进多脉冲点火模型,并基于变射面的思想对关机点参数进行了设计及优化。然后,从使敌方预测误差最大的角度提出评价函数,并利用遗传算法进行优化。最后,给出了一种同时满足导弹机动突防与打击精度要求的多脉冲弹道设计方法。从模型的可行性,方法的有效性、灵活性、迭代效率及精度等方面进行了仿真验证分析。在PC机仿真中,20 s内就设计出一条保证打击精度的中段突防弹道。结果表明,建立的模型是可行的,提出的突防弹道设计方法是快速有效的。