Self-assembly of Carboxyl Functionalized Polystyrene Nanospheres into Close-packed Monolayers via Chemical Adsorption

The polyacrylic acid functionalized polystyrene nanospheres were synthesized and self-assembled into irregular, densely packed monolayers in non-aqueous media. The polymer nanoparticles were chemically adhered to substrates. The morphologies of the resulting films were investigated. The impact of the volume fraction of alcohol in the mixed solvents on the particle adsorption and fabrication of nanosphere assembled films was examined.     

Dammann光栅在光互连中的应用

本文将Ｄａｍｍａｎｎ光栅［１，２］应用于光互连，提出了用Ｄａｍｍａｎｎ光栅实现完全混洗的方法．一个２×２的Ｄａｍｍａｎｎ光栅与一个成像透镜的组合，具有与四焦点透镜类似的成像作用．像面上，像的位置与Ｄａｍｍａｎｎ光栅的位置有关，适当选择光栅的位置可以实现不同元素数目及不同元素密度的完全混洗．本文给出了有关的理论推导及实验结果．     

洛仑兹变换的一种推导

如图一,oxyz为静止的参照系,o’x’y’z’为相对于oxyz参照系沿x轴正向以匀速率υ宜线运动的参照系.o’x’为一固定在o’x’y’z’中的物体,在相对于物体静止的参照系o’x’y’z’中测得其长度为x’,在相对于物体运动的参照系oxyz中测得其长度为x-υt.由于是在不同的参照系中测量的,根据相对论的时空概念,其结果是不相同的.它们之间已不再是经典的伽里略变换关系x’=x-υt,而应当是另一种关系.由于我们所考察的是彼此作匀速直线运动的惯性系之间的变换关系,这种关系只能是线性关系,亦即x’和x-υt之间只能相差一个比例常数,将常数定作k,则有…     

横向外延过生长磷化铟材料的生长速率模型

分别考虑气相扩散和掩膜表面扩散过程，建立了金属有机化学气相沉积条件下横向外延过生长的速率模型. 在砷化镓衬底上外延磷化铟条件下，模拟得到了生长速率随掩膜/窗口宽度(m/w)变化的关系. 通过讨论掩膜/窗口宽度的影响，说明了掩膜宽度、窗口宽度以及有效掩膜宽度是决定生长速率的关键因素. 以上结论与实验结果一致. 关键词： 横向外延 生长模型 扩散 生长速率     

催化动力学荧光法测定痕量培氟沙星

研究了培氟沙星对铜(Ⅱ)催化过氧化氢氧化罗丹明B使其荧光猝灭的抑制作用,据此建立了催化动力学荧光分析法测定培氟沙星的新方法。在最佳实验条件下,方法线性范围为0.2~4.29μg/mL,检出限为0.2μg/L。对实际样品分析,平均回收率为97.6%~101.7%,相对标准偏差为1.03%~1.9%。     

纳米Sb2O3的制备与性能研究

由于Sb2O3是一种性能优良的无机阻燃剂,并与卤素阻燃剂有很好的协效作用[1],1998年,全球用于阻燃的Sb2O3达80kt以上,占阻燃剂总耗量的7%[2]。但由于其本身的极性特点,加入到纤维、塑料等高分子材料中,材料的力学性能受到很大损失[3],因此对传统的微米级的Sb2O3进行超细、表面处     

CrOx/ SBA-15介孔催化剂上丙烷在二氧化碳气氛中脱氢反应的研究

The structure and catalytic properties based on Chromium Oxide supported on mesoporous SBA-15 for oxidative dehydrogenation of propane by CO₂ have been studied by using X-ray diffraction (XRD), ultraviolet-visible diffuse reflectance spectra (UV-Vis DRS), electron spin resonance (ESR), X-ray photoelectron spectroscopy (XPS) and propane pulsing experiments in the absence of gas-phase O₂. It has been shown that propane conversion and propene yield increase with Cr loadings. The propane conversion and propene yield on CrO_x(Cr: 10wt%)/SBA-15 catalyst for oxidative dehydrogenation of propane by CO₂ at 550 ℃ reach 24.8% and 21.8%, respectively .The results of ESR, UV-Vis DRS and propane pulsing experiments indicate that Cr^Ⅲ in the CrO_x/ SBA-15 catalyst is the main active species in oxidative dehydrogenation of propane by CO₂ and Cr^Ⅵ, Cr^Ⅴ is inactive in dehydrogenation.     

First-Principles Calculations of Electronic Structures of New Ⅲ-Ⅴ Semiconductors： BxGa1-xAs and TlxGa1-xAs alloys

We investigate the electronic structures of new semiconductor alloys BxGa1-xAs and TlxGa1-xAs, employing first-principles calculations within the density-functional theory and the generalized gradient approximation. The calculation results indicate that alloying a small TI content with GaAs will produce larger modifications of the band structures compared to B. A careful investigation of the internal lattice structure relaxation shows that significant bond-length relaxations takes place in both the alloys, and it turns out that difference between the band-gap bowing behaviours for B and TI stems from the different impact of atomic relaxation on the electronic structure. The relaxed structure yields electronic-structure results, which are in good agreement with the experimental data. Finally, a comparison of formation enthalpies indicates that the production Tlx Ga1-xAs with TI concentration of at least 8% is possible.     

硒化锑薄膜太阳电池的模拟与结构优化研究

采用wx-AMPS模拟软件对硒化锑(Sb_2Se_3)薄膜太阳电池进行建模仿真,将CdS, ZnO和Sn02的模型应用到Sb_2Se_3太阳电池的电子传输层中.结果显示,应用CdS和ZnO都能实现较高的器件性能,并发现电子传输层电子亲和势(Xe-ETL)的变化能够调节Sb_2Se_3太阳电池内部的电场分布,是影响器件性能的关键参数之一.过高或者过低的Xe-ETL都会使电池的填充因子降低,导致电池性能劣化.当Xe-ETL为4.2eV时,厚度为0.6μm的Sb_2Se_3太阳电池取得了最优的7.87%的转换效率.应用优化好的器件模型,在不考虑Sb_2Se_3层缺陷态的理想情况下,厚度为3μm的Sb_2Se_3太阳电池的转换效率可以达到16.55%(短路电流密度J_(SC)=34.88 mA/cm~2、开路电压V_(OC)=0.59 V、填充因子FF=80.40%).以上模拟结果表明,Sb_2Se_3薄膜太阳电池在简单的器件结构下就能够获得优异的光电性能,具有较高的应用潜力.     

超快激光与激光频率梳

用光干涉理论和傅里叶变换的知识,定性半定量的分析超快激光和激光频率梳,根据多光束干涉的结论分析锁模技术形成超快脉冲激光的原理以及超快激光的时域特性,用傅里级数和傅里叶变换的性质分析超快激光频率梳的物理图像、脉冲激光的时域脉宽与频域带宽的关系、以及时域脉冲间隔与频域频率间隔的关系.介绍频率梳在光频测量中的应用.