An improved method for the simultaneous analysis of phenolic and steroidal estrogens in water and sediment

This paper describes an improved method for the extraction and analysis of seven endocrine disrupting chemicals with wide-ranging polarities from water and sediments using gas chromatography-tandem mass spectrometry (GC-MS/MS). The analytes were 4-tert-octylphenol, 4-nonylphenol, bisphenol A, estrone, 17β-estradiol, 17α-ethynylestradiol and 16α-hydroxyestrone. The optimised GC-MS/MS method produces increased selectivity and sensitivity compared to GC-MS, with limit of detection ranging from 0.01 to 0.49 ng L⁻¹ in water and from 0.05 to 0.14 ng g⁻¹ in sediment. Extraction from aqueous samples was performed by solid-phase extraction (SPE) and from sediment samples by microwave-assisted extraction (MAE). The improved method for the clean-up of sediment extracts carried out by SPE enhanced EDC recovery (86-102%) while reducing matrix interference and sample drying time. Derivatisation of final sample extracts was achieved using N,O-bis(trimethylsilyl)trifluoroacetamide and pyridine, and their stability was enhanced by reconstituting the derivatised extracts with hexane. The method was validated by spiking experiments which showed good recovery and reproducibility. The method was applied to samples taken from the Medway estuary in Kent, UK, where non-conservative behaviour of EDCs was demonstrated.     

Ultra-high-stability,pH-resistant sol–gel titania poly(tetrahydrofuran) coating for capillary microextraction on-line coupled to high-performance liquid chromatography

A sol–gel titania poly(tetrahydrofuran) (poly-THF) coating was developed for capillary microextraction hyphenated on-line with high-performance liquid chromatography (HPLC). Poly-THF was covalently bonded to the sol–gel titania network which, in turn, became chemically anchored to the inner surface of a 0.25 mm I.D. fused silica capillary. For sample preconcentration, a 38-cm segment of the sol–gel titania poly-THF coated capillary was installed on an HPLC injection port as a sampling loop. Aqueous samples containing a variety of analytes were passed through the capillary and, during this process, the analytes were extracted by the sol–gel titania poly-THF coating on the inner surface of the capillary. Using isocratic and gradient elution with acetonitrile/water mobile phases, the extracted analytes were desorbed into the on-line coupled HPLC column for separation and UV detection. The sol–gel titania poly-THF coating was especially efficient in extracting polar analytes, such as underivatized phenols, alcohols, amines, and aromatic carboxylic acids. In addition, this coating was capable of extracting moderately polar and nonpolar analytes, such as ketones and polycyclic aromatic hydrocarbons. The sol–gel titania poly-THF coated capillary was also able to extract polypeptides at pH values near their respective isoelectric points. Extraction of these compounds can be important for environmental and biomedical applications. The observed extraction behavior can be attributed to the polar and nonpolar moieties in the poly-THF structure. This coating was found to be stable under extremely low and high pH conditions—even after 18 h of exposure to 1 M HCl (pH ≈0.0) and 1 M NaOH (pH ≈14.0).     

Gas chromatographic retention indices of biologically and environmentally important organic compounds on capillary columns with low-polar stationary phases

This work presents linear temperature programmed retention indices on the columns with stationary phases of 5% phenylpolydimethyl silicone of 389 organic compounds, including extractive substances of plant tissues and environmentally important compounds. Certain factors which influence the values and reproducibility of retention indices during gas chromatographic analysis of multicomponent mixtures are discussed.     

V（HSO4）3 catalyzed chemoselectivity acetylation of alcohols and phenols in solution and under solvent-free conditions

A variety of alcohols and phenols are efficiently acetylated with acetic anhydride in the presence of a catalytic amount of V(HSO4)3 in solution and under solvent free conditions.Mild reaction conditions,high yields of the products,easy procedure and selective acetylation of alcohols and phenols in the presence of amines and thiols are the main advantages of this procedure.     

Gas chromatographic determination of some phenolic compounds in fuels and engine oil after simultaneous derivatization and microextraction

In this study, a simultaneous derivatization/air‐assisted liquid–liquid microextraction method has been developed for sample preparation of some phenolic compounds in fuels and engine oil. Analytes are transferred by back liquid–liquid extraction into NaOH solution and then are derivatized with butyl chloroformate and extracted simultaneously into carbon tetrachloride. The extracted derivatized analytes are analyzed using gas chromatography with flame ionization detection. The effect of extracting solvent type, derivatization agent and extraction solvent volumes, ionic strength of the aqueous solution, number of extraction cycles, etc., on the extraction efficiency is investigated. The calibration graphs are linear in the range of 3–10 000 μg/L. Enhancement factors, enrichment factors, and extraction recoveries are in the ranges of 497 to 1471, 571 to 991, and 60 to 109%, respectively. Detection limits are obtained in the range of 0.8 to 2.0 μg/L. Relative standard deviations for the extraction of each selected phenols are in the ranges of 2–4% for intraday (n = 6) and 3–6% (n = 5) for interday precisions for 200 μg/L. This technique is successfully applied for the extraction, preconcentration, and determination of the selected phenols in gasoline, kerosene, gas oil, and engine oil.     

Regioselective anti-addition of phenols to propargylic oxiranes by palladium(0) catalyst

(Z)-Phenol-substituted alkenes were produced by the palladium(0)-catalyzed reaction of propargylic oxiranes with phenols. The regio- and stereoselective addition of phenols to alkynes occurs via the formation of π-propargyl- and π-allylpalladium complexes. The phenoxy-substituted enones were produced simultaneously depending on the reaction conditions.     

Base catalyzed Mitsunobu reactions as a tool for the synthesis of aryl sec-alkyl ethers

A facile and versatile method for the synthesis of aryl sec-alkyl ethers from phenols with alcohols in the presence of base via a Mitsunobu reaction is described.     

Ionic liquid‐based headspace in‐tube liquid‐phase microextraction coupled with CE for sensitive detection of phenols

An ionic liquid‐based headspace in‐tube liquid‐phase microextraction (IL‐HS‐ITLPME) in‐line coupled with CE is proposed. The method is capable of quantifying trace amounts of phenols in environmental water samples. In the newly developed method, simply by placing a capillary injected with ionic liquids (IL) in the HS above the aqueous sample, volatile phenols were extracted into the IL acceptor phase in the capillary. After extraction, electrophoresis of the phenols in the capillary was carried out. Extraction parameters such as the extraction time, extraction temperature, ionic strength, volume of the sample solution, and IL types were systematically investigated. Under the optimized conditions, enrichment factors for four phenols were from 1510 to 1985. The proposed method provided a good linearity, low limits of detection (below 5.0 ng/mL), and good repeatability of the extractions (RSDs below 6.7%, n = 6). This method was then utilized to analyze two real environmental samples of Xiaoxi Lake and tap water, obtaining acceptable recoveries and precisions. Compared with the usual HS‐ITLPME for CE, IL‐HS‐ITLPME‐CE is a simple, low cost, fast, and environmentally friendly preconcentration technique.     

KAl(SO4)2 · 12H2O (alum) a reusable catalyst for the synthesis of some 4-substituted coumarins via Pechmann reaction under solvent-free conditions

A simple, efficient, and practical procedure for the Pechmann condensation using KAl(SO₄)₂ · 12H₂O (alum) as a non-toxic, reusable, inexpensive, and easily available catalyst is described under solvent-free condition at 65°C. These improved reaction conditions allow the preparation of a wide variety of some new substituted coumarins in high yields (86–96%) and purity under mild reaction conditions. Compared to the classical Pechmann condensation, this new method consistently has the advantage of high yields. Correspondence: Ali A. Mohammadi, Department of Chemistry, Shahid Beheshti University, P.O. Box 19839-4716, Tehran, Iran.     

聚酰亚胺固相萃取搅拌棒的制备及其在环境水中酚类的分析应用

利用相转换法制备了聚酰亚胺吸附萃取搅拌棒,用5种有机酚作为评价标样,并与现有商品化吸附萃取搅拌棒进行比较。优化了萃取搅拌速度、溶液离子强度、萃取温度、萃取时间以及热解析温度和时间。在最佳实验条件下,100 mL 样品,30% NaCl,在25℃下,经活化5 min 后的聚酰亚胺吸附搅拌棒萃取30 min (800 r/ min),然后300℃热解析4 min,使目标物脱附,再进行色谱分析。目标物在大于两个数量级浓度范围内具有良好的线性(R≥0.9995),定量限(LOQ,S/ N=10)为0.028~0.123μg/ L,重复性为1.6%~9.7%。将SBSE 与气相色谱-质谱联用,对海水、自来水和污水中的酚类进行定性与定量分析,结果表明,聚酰亚胺吸附萃取搅拌棒具有良好的选择性,最高热解析温度350℃,在分析水中痕量极性化合物领域具有广阔应用前景。