返波型行波电子直线加速结构的理论研究

比较了行波与驻波两种工作方式以及前向波与返波型行波的不同特点;研究了返波型行波电子直线加速结构的工作特性;并针对返波型行波电子直线加速结构的特点,进行工作模式的选择;对工作频率为2856MHz,3π/4模的返波加速结构进行了优化设计;研究了带聚束段的返波型行波加速管的纵向与横向粒子动力学问题;为海关大型集装箱在线检测用加速器设计了一根9MeV返波型行波加速管,并与采用盘荷波导结构的加速管进行了对比.研究结果表明,返波型行波电子直线加速结构具有一定的优势,它把鼻锥型加速结构分流阻抗高及盘荷波导行波工作方式填充时间短,工作稳定性好等优点结合起来,性能明显优越.     

钛铁矿中钛的测定

利用钛铁矿能显著吸收微波的介电特性，采用家用微波炉，在微波辐照下，用浓磷酸消解矿样，并用氧化还原滴定法测定钛的含量，试验结果表明，该方法能快速分解矿样，测定结果准确，与传统分析方法比较，该法具有简便、快速、低耗、适应大批量样品分析等优点。还对钛铁矿的结构作了X-射线衍射分析。     

温度及pH敏感的树枝状高分子衍生物合成及药物控制释放研究

对合成的系列聚酰胺-胺型(PAMAM)树枝状高分子进行端基的羟基化和氯乙酰化两步修饰,使PAMAM最外层接上烷基氯.以修饰产物为引发剂,通过原子转移自由基引发甲基丙烯酸N,N-二甲氨基乙酯(DMAEMA)聚合得到树枝状PAMAM高分子衍生物,并对其结构用FTIR、1H-NMR和粒径分析进行了表征.紫外可见分光光度仪测定证实此高分子具有温度及pH敏感性.通过对小分子药物控制释放研究表明,此树枝状高分子衍生物通过环境pH值可有效地控制小分子药物的释放.     

Dislocation Analysis for Large-sized Sapphire Single Crystal Grown by SAPMAC Method

In this paper,large-sized sapphire (230×210 mm,27.5 kg) was grown by SAPMAC method (sapphire growth technique with micro-pulling and shoulder-expanding at the cooled center). Dislocation peculiarity in large sapphire boule (0001) basal plane was investigated by chemical etching,scanning electron microscopy and X-ray topography method. The triangular dislocation etch pit measured is 7.6×101～8.0×102 cm-2,in which relative high-density dislocations were generated at both initial and final stages of crystal growth. The analysis of single-crystal X-ray topography shows that there are no apparent sub-grain boundaries; the dislocation lines are isolated and straight. Finally,the origins of low-density dislocation in sapphire crystal are discussed by numerical analysis method.     

微铂电极上1-酰基二茂铁动力学参数的测定

本文合成并研究了１－酰基二茂铁在ＣＨ２Ｃｌ２中的伏安行为，测定了它们在ＣＨ２Ｃｌ２中不同支持电解质浓度时的扩散系数，并分明用Ｚ．Ｇａｌｕｓ和Ｋ．Ａｏｋｉ方法计算了两种状态下的电子迁移速率常数。讨论了取代基的诱导效应和共轭效应及其链长对１－酰基二茂铁的动力学性质的影响以及支持电解质及其浓度等因素对伏安曲线的影响。     

Detection of Tumor Necrosis Factor Gene by Piezoelectric Nucleic Acid Senosr

A piezoelectric nucleic acid sensor was constructed ofr detection of tumor necrosis factor gene.Two methods were employed for immobilization of nucleic acid probe on gold electrode of piezoelectric crystal.The results show that polyethyleneimine adbesion and glutaraldehyde cross-linking method has higher sensitivity,stability and selectivity than protein A method.The solid-phase nucleic acid hybridization of oligo unclecotides and tumor necrosis factor target gene sequence were monitorde using this sensor.Tumor necrosis factor gene sequence(580bp) was detected by this nucleic acid sensor for the first time.     

痤疮患者血清中微量元素含量的变化

测定了52例痤疮患者血清Ca,Mg,Zn,Cu,Fe五种元素的含量。结果表明，痤疮患者血清Zn水平显著低于正常人（P＜0．001），血清Ca,Mg,Cu,Fe水平则与正常人无差别（P＞0．05）。部分病人口服补充锌剂后痤疮症状有所好转。提示痤疮患者应重视体内微量元素含量的变化，并做适当的补充。     

杂原子钛对TiY分子筛性能的影响

采用水热晶化法合成了含骨架杂原子的TiY分子筛，通过X射线粉末衍射（XRD）、傅里叶变换红外光谱(FT-IR)、差示扫描量热、吡啶吸附红外光谱等方法考察了杂原子Ti进入Y分子筛骨架后对分子筛各项性能的影响。结果表明，TiY分子筛具有典型的Y型分子筛晶体结构；随着Ti添加量的增加，TiY分子筛晶化所需的时间延长，晶胞常数增大，分子筛的热稳定性和水热稳定性均有所增强。与Y分子筛相比， TiY分子筛的L酸中心数量明显增加，同时B酸中心强度增加，TiY分子筛的裂化反应活性提高，催化剂上的积炭量明显减少。     

碘掺杂的3-乙基-5-[2-(3-乙基-2苯并噻唑啉基)亚乙基]罗丹宁的结构与电性能

The merocyanine dye 3-ethyl-5-(2-(3-ethyl-2-benzothiazolinylidene)-ethylidene)-rhodanine (BTER) known as Agfa-10 has been found to have a good photoconductivity as solution cast film. In this paper iodine-doped BTER was obtained by doping with iodine vapor. Its structure was investigated with the following characteristies. 1 The doped iodine had been excited as I_3~- anion. 2 Because the electron located on the sulphur atom was transferred to iodine, the charge transfer complex of (BTER-I_3) formed. 3 During the iodine doping process, BTER changed from α-form to β-modification. These had been identified by X-ray diffraction, VIS-absorption spectra and SEM picture.4 From the volt-Ampere curve obtained from sandwich cell, when E≤2.2×10~(-1) V·cm~(-1), the room temperature electrical conductivity of BTER and BTER-I_3 were found to be 2.22×10~(-10) s·cm~(-1) and 2.6×10~(-7) S·cm~(-1), respectively.