光盘盘基应力双折射的研究

从理论和实验讨论了光盘盘基在不同入射角江束通过时所产生的相位延迟值的改变。用起偏器－调制器－补偿器－样品－检偏器结构形式的偏振相位调制方法对玻璃和聚碳酸酯两种材料光盘盘基进行测量，结果表明聚碳酸酯盘基的双折射远大于玻璃盘基的双折射。     

A Necklace of Wulff Shapes

In a probabilistic model of a film over a disordered substrate, Monte-Carlo simulations show that the film hangs from peaks of the substrate. The film profile is well approximated by a necklace of Wulff shapes. Such a necklace can be obtained as the infimum of a collection of Wulff shapes resting on the substrate. When the random substrate is given by iid heights with exponential distribution, we prove estimates on the probability density of the resulting peaks, at small density.AMS subject classification: 60K35, 60K37, 82B24, 82B41     

温度对纳米ZnO膜电学光学性质影响的研究

关键词：     

Growth of three-dimensional quantum dot crystals on patterned GaAs (0 0 1) substrates

The growth of a three-dimensional (3D) InAs quantum dot (QD) crystal on a patterned GaAs (0 0 1) substrate is demonstrated. The morphology of QDs grown on a surface patterned with shallow holes is studied as a function of the amount of deposited InAs. We observe that the QDs form in the patterned holes close to each other forming lateral QD bimolecules for InAs coverages below the commonly observed critical thickness of 1.6 monolayers. When the coverage increases, the QD bimolecules coalesce to form larger single QDs. The QDs in the holes are then capped with a Ga(Al)As spacer. The buried QD array serves as a strain template for controlling the formation site of the QDs in the second layer. By tuning the growth conditions for the second and subsequent layers, we achieve a 3D InAs QD crystal with a high degree of perfection. A detail investigation of the growth on hole patterns with different periodicities is presented.     

聚合物基片对柔性有机发光器件性能的影响

以聚合物基片柔性ITO膜为透明电极，制备了ITO／TPD／Alq3／Al结构柔性有机发光器件，并与在相同条件下制备的玻璃基片相同结构器件作了比较。研究了不同基片对有机材料及器件性能的影响，指出选择不易吸湿、耐温高、热胀系数小的聚合物材料，提高柔性ITO膜的附着力和导电性，结合柔性ITO膜的具体特性。优化有机层的蒸镀条件，是提高柔性有机发光器件发光亮度和稳定性的重要途径。     

液相性质对制备硫化物纳米级粒子化膜的影响

研究氯化锌浓度，溶液酸碱度，离子强度等底液性质及反应温度对化学反应法在不溶膜上制备纳米级硫化锌粒子化膜的影响，得出了一些规律并加以初步的解释。     

异硫氰酸荧光素标记抗体的固体基质室温磷光性质研究

研究了异硫氰酸荧光素（FITC）标记的羊抗人抗体（GAHAb-FITC)和兔抗羊抗体9RAGAb-FITC)，及其以三种免疫方式与人免疫球蛋白（IgG)反应所得免疫复合物在多种固体薄膜基质上发射室温磷光（RTP）的适宜条件及其光谱，强度和寿命等性质。研究发现，标记抗体及其免疫复合物保留了FITC优良的固体基质室温磷光性质，λ m0643em^(max)=525/650nm，其RTP强度与其浓度线性相关，并有很高的灵敏度，更为重要的是，免疫反应及其RTP检测能结合于同一基质，方便地相继完成，在聚酰胺膜（PM）上，以Pb(Ac)2为重原子微扰剂，稀释比为1：10（ψ）的GAHAb-FITC,RAGAb-FITC及其与人IgG形成的免疫复合物均能发射较强制 RTP信号并有较长的RTP寿命，本结果为建立相应的固体基质室温磷光免疫分析（SS-RTP-IA）新方法奠定了相应的实验基础。     

新型衬底晶体LiGaO2的生长和结晶性质研究

氮化物长期以来被看作是在蓝光及紫外波段光电子应用中最有希望的材料[1].但在改进材料质量方面最大的困难是:缺乏一种能和GaN在晶格及热性能方面十分匹配的理想衬底材料[2].Al2O3被普遍认为可以作为GaN的衬底材料.这主要是由于它具有的结构、热性能好,和生长加工容易等特点.     

MEASUREMENTS OF Fe AND Cu K-Shell IONIZATION CROSS SECTIONS BY SLOW ELECTRON IMPACT

ＭＥＡＳＵＲＥＭＥＮＴＳＯＦＦｅＡＮＤＣｕＫ－ＳｈｅｌＩＯＮＩＺＡＴＩＯＮＣＲＯＳＳＳＥＣＴＩＯＮＳＢＹＳＬＯＷＥＬＥＣＴＲＯＮＩＭＰＡＣＴＬｉＴａｉｈｕａＡｎＺｈｕＬｕｏＺｈｅｎｇｍｉｎｇＣｅｎｔｅｒｆｏｒＲａｄｉａｔｉｏｎＰｈｙｓｉｃｓ，Ｉｎｓ...     

Investigation of thin-film electroluminescent structures on rough subsrates

Results of experimental investigations of the volt-brightness characteristics, frequency dependences of brightness, and the directional radiation pattern of electroluminescent MSDM, MSCM, and MSDCM emitters, where M stands for the first transparent and second nontransparent electrodes, S is a semiconductor, D is a thin-film dielectric, and C is a silicone-based composite liquid dielectric with a powdered segnetoelectric filler, developed on conventional “smooth” and rough glass substrates are presented. It is shown that electroluminescent structures on rough surfaces have a brightness approximately two times higher than that of similar structures developed on a “smooth” substrate. Ul’yanovsk State University, 42, L. Tolstoi St., Ul’yanovsk, 432700, Russia. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 4, pp. 507–512, July–August, 1997.