电流并联负反馈放大器实验的研究

用实验的方法，研究电流并联负反馈对放大器性能的改善，提出电流型、并联型负反馈放大器性能参数的测量方法。     

光纤放大器增益饱和对有源光纤环形腔滤波特性的影响

从理论和实验两个方面研究了有源光纤环形腔滤波器输入光功率对光纤放大器增益的影响及由此引起的对有源光纤环形腔滤波特性的影响。在考虑上述影响的情况下 ,对有源光纤环形腔滤波器参数的优化作了讨论     

Preliminary design of high-power wave-guide/transmission system for multimegawatt CW requirements of 100 MeV proton LINAC

Development of a 100 MeV CW proton LINAC has been planned at CAT. This LINAC will be needing CW rf power in the frequency ranges of 350 MHz and 700 MHz for its RFQ and DTL/CCDTL/SFDTL structures respectively. The power to the accelerating structures will be produced by either 1 MW CW or 250 kW CW klystrons/inductive output tubes (HOM IOTs). The power needed by respective feed points in the structure is max. 250 kW which will be powered by splitting the power from 1 MW klystron/klystrode into four channels by using a wave-guide system. In case of using 250 kW tubes the power to the structures will be provided directly from each tube. Two types of wave-guide transmission system have been considered, viz, WR 2300 for 350 MHz rf needs and WR 1500 for 700 MHz rf needs. The typical wave-guide system has been designed using the 1 MW CW klystron followed by wave-guide filter, dual directional coupler, high-power circulator, three 3 dB magic TEE power dividers to split the main channel into four equal channels of 250 kW each. Each individual channel has dual directional couplers, flexible wave-guide sections and high power ceramic vacuum window. The circulator and each power divider is terminated into the isolated ports by high power CW loads. Out of the four channels three channels have phase shifters. Present paper describes the technological aspects and design specifications-considerations for these stringent requirements.     

高精度的光纤衰减系数测试系统的设计

利用常规仪器设备，设计了一套集光、机、电为一体的光纤衰减测量,实现了数字化监测显示，并可与微机接口；采用双光路法，消除了由于光源光强不稳定产生的误差。     

An ASE Reduction Filter Using Cascaded Optical Fiber Grating Couplers in EDFA Repeater

A new configuration for an ASE reduction filter in EDFA repeaters for WDM optical transmission systems using optical fiber grating couplers (FGCs) was proposed and first demonstrated. The filtering characteristics of the proposed filter for amplified single wavelength signal and 2-channel WDM signals using EDFA were identified. It was found that the filter was effective to improve SNR in optical domain by reducing ASE noise. The required FGC characteristics for the filter were theoretically predicted under the condition that the total filter loss did not exceed 3 dB. More than 70% of drop efficiency was required in each FGC for the application of the proposed filter to an 8-channel WDM system using EDFA repeaters.     

Low noise double pass L-band erbium-doped fiber amplifier

A new double pass long wavelength band erbium-doped fiber amplifier with enhanced noise figure characteristics is demonstrated. The noise figure is improved by about 2.6 dB with the incorporation of broadband conventional-band fiber Bragg grating (FBG) in between the two segments of erbium-doped fiber. By incorporating both the pre-amplifier and the FBG, the noise figure is further improved, which varies from 4.0 to 5.0 dB in the flat gain region from 1570 to 1600 nm. The gain varies from 32.0 to 33.4 dB within this region. The new amplifier with high gain and low noise figure can be useful as an inline amplifier in a wavelength division multiplexing transmission system.     

多束速调管的增益带宽

 研究了M个束、N个共振腔的多束速调管(MBK)的增益和带宽，得到了描述小信号增益和带宽与器件结构参数和电子束参数关系的公式，给出了在不同参数下增益随频率的变化曲线。分析了多腔对增益，多束对带宽的影响。计算结果表明：多腔可以提高增益；多束可以降低Q值，从而可以增中带宽，带宽增加工了3.6%，还可以提高增益；对于MBK，频率交叉调谐对增加带宽不如频率调谐好；空间电荷波只对增益有影响，对带宽没有影响。最后，预估一种L带多束速调管的增益带宽为8.1%。     

光放大器前置可调光学滤波器

介绍Ｆ－Ｐ干涉滤波器实现中心波长可调的两种机理，给出通过改变腔距来改变中心波工的滤波器的典型结构，并且给出了相应的电压驱动电路，实验表明选择合适的光放大器前置滤波器可以提高系统的灵敏度。     

基于SOA和NOLM的光脉冲放大与压缩的设计模型

设计了一种基于半导体光放大器(SOA)和非线性光学环镜(NOLM)的光脉冲放大与压缩的模型。数值研究结果表明:在NOLM中,当调节合适的控制脉冲的输入和初始时延时,具有较低峰值功率、宽度为几十皮秒的高斯信号脉冲经此模型放大压缩后,可以得到脉冲峰值增益高、脉冲宽度窄以及基本无基座的高质量超短信号光脉冲。     

椭圆波导FEM放大器的非线性特性研究

 以椭圆波导、平板摇摆器为FEM放大器的模型，导出了自洽的注波互作用三维非线性方程组。在此基础上编制了相应的程序。利用该程序分析了FEM放大器的饱和功率、效率以及带宽等高频特性。考虑了摇摆器渐变、空间电荷波、电子初始速度零散对高频特性的影响。