Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007     

High resolution staring arrays answering compact MW and LW applications

This paper overviews the electro-optical and thermal performances of different types of infrared detectors manufactured by Sofradir. The detector’s fabrication processes and detector’s performance are shortly described. New staring arrays are more compact and offer system solutions required by infrared market. Special attention is directed to some reliability advantages of new dewar design. Finally, the development trends for highest resolution infrared detector are discussed. The paper presented there appears in Infrared Photoelectronics, edited by Antoni Rogalski, Eustace L. Dereniak, Fiodor F. Sizov, Proc. SPIE Vol. 5957, 59570U (2005).     

高能闪光照相对电子束参数的要求

对高能闪光机光源性能用Monte-Carlo方法模拟研究发现：并非击靶电子束半径越小、发射度越低, 闪光机的照相性能就会越好. 研究结果表明：为了使闪光照相图像视面上照射量分布比较均匀, 对束半径与电子束归一发射度有一个联合限制, 对于20MeV闪光机, 如果击靶电子束有效半径是0.12cm, 那么仅当束归一发射度≥550cm.mrad时,在2°内的照射量不均匀性才小于5%.     

不同溶剂体系中改性氢氧化镁的分散行为

研究了不同的表面改性剂对超细氢氧化镁的表面改性.并分别以水和乙醇为溶剂,研究了表面改性后氢氧化镁的分散行为.实验结果表明,以水为溶剂的体系,六偏磷酸钠分散性能最好,而以乙醇为溶剂,硅烷偶联剂KH-550分散性能最好,其用量为基体量的5%左右,可使制备的超细氢氧化镁粒径达到0.2 μm尺度以下.试验结果对进一步认识超细氢氧化镁的性质及其应用具有重要意义.     

乳液聚合阶段Ⅱ动力学研究的进展

本文简述了乳浓聚合动力学研究的进展,着重于澳大利亚Sydney大学Gilbert等在乳液聚合阶段Ⅱ动力学方面的研究概况。介绍了不同水溶性单体的小尺寸种子乳液体系的SmithEwart递推方程的求解方法及其解析解形式和乳液聚合动力学数据的处理。同时讨论了该研究的局限性。     

(Ni0.81Fe0.19)1-xCrx作为种子层对NiFe/FeMn交换偏置的影响

采用一种新的种子层材料:(Ni081Fe019)1-xCrx,通过改变种子层中Cr原子的含量,使得在其上生长的NiFeFeMn双层膜的织构和晶粒尺寸产生极大的差异,系统研究了NiFeFeMn双层膜中FeMn晶粒尺寸和织构对交换偏置的影响.实验结果表明,在FeMn的γ相(111)织构较好的前提下,交换偏置场的大小与织构的差异没有关系;FeMn的晶粒尺寸对交换偏置场有很大影响,较小的反铁磁层晶粒对交换偏置场有利,过大的反铁磁层晶粒不利于交换偏置场.将(Ni081Fe019)05Cr05与传统的种子层材料Ta进 关键词： 交换偏置 晶粒尺寸 织构 种子层     

高性能ZnO纳米块体材料的制备及其拉曼光谱学特征

利用六面顶高压设备制备了高密度、低脆性、纳米级的ZnO块体材料，用MDI/JADE5 X射线衍射仪(Cu靶)和XL30S-FEG场发射扫描电子显微镜对高压样品的相组成、晶粒尺寸及微观形貌进行了表征.利用E55+FRA106/5傅里叶变换激光拉曼光谱仪通过ZnO块体样品位于50—500cm^-1之内的拉曼光谱, 研究了极性半导体纳米材料的拉曼光谱学特征.发现在极性半导体ZnO纳米块体材料中，没有出现明显的尺寸限制效应. 关键词： ZnO纳米块体 拉曼光谱 尺寸限制效应     

红外小目标与背景辐射对比度的研究

红外目标与背景的对比度特征是红外探测系统检测的重要特征。研究了目标和背景在探测器上的辐射照度,提出了一种红外小目标与背景的辐射对比度,分析了该目标与背景对比度的相关因素。     

Two-spin-majority cellular automaton as a model of 2D cluster and interface growth

A new probabilistic cellular automaton model is introduced to simulate cluster and interface growth in two dimensions. The dynamics of this model is an extension to higher dimensions of the compact directed percolation studied by Essam. Numerical results indicate that the two-dimensional cluster coarsening and growth can be described only approximately by the conventional cluster size scaling due to a crossover in the growth mode. The spreading of the initially flat interface follows a purely diffusional,t ^1/2, law.     

原子氢在Be(1010)薄膜上吸附的第一性原理计算

对原子氢在Be(1010)薄膜表面的吸附性质做了第一性原理计算研究.根据原子面间距的不同，可把Be(1010)表面分为两种.计算结果表明，原子氢在这两种表面上的吸附性质显著不同.为阐明和分析这些不同，系统计算和分析了Be(1010)薄膜的表面电子结构、电子功函数、平均静电势和局域电荷密度.这些物理量都自洽地表明，吸附过程中原子氢和表面铍原子间的电荷转移过程对于两种表面是完全不同的.对于L型表面来说，电荷由吸附原子氢向表面Be原子层转移，而对于S型表面而言，电荷转移过程恰恰相反. 关键词： 表面能 功函数 量子尺度效应