用于强磁场的快响应真空规的研制进展

研制了能在强磁场、强干扰环境下工作的快响应真空电离规(快规),用于对HL 2A装置偏滤器室和等离子体附近的中性粒子密度和通量进行原位测量。介绍了快规的结构、工作原理、设计要点以及实验结果。在无磁场的情况下,快规对气体压强的测量范围为6.4×10-6～0.15Pa,在1×10-5～0.15Pa范围内,快规收集极离子流与发射电子流之比与气压保持良好线性关系;在0 15T的磁场下,快规的规管常数未发生显著变化,在规管对称轴与磁力线的夹角小于15o时,规管常数的变化小于10%。     

Desorption behavior of a surfactant in a linear low‐density polyethylene blend at elevated temperatures

The desorption behavior of a surfactant in a linear low‐density polyethylene (LLDPE) blend at elevated temperatures of 50, 70, and 80 °C was studied with Fourier transform infrared spectroscopy. The composition of the LLDPE blend was 70:30 LLDPE/low‐density polyethylene. Three different specimens (II, III, and IV) were prepared with various compositions of a small molecular penetrant, sorbitan palmitate (SPAN‐40), and a migration controller, poly(ethylene acrylic acid) (EAA), in the LLDPE blend. The calculated diffusion coefficient (D) of SPAN‐40 in specimens II, III, and IV, between 50 and 80 °C, varied from 1.74 × 10^?11 to 6.79 × 10^?11 cm²/s, from 1.10 × 10^?11 to 5.75 × 10^?11 cm²/s, and from 0.58 × 10^?11 to 4.75 × 10^?11 cm²/s, respectively. In addition, the calculated activation energies (E_D) of specimens II, III, and IV, from the plotting of ln D versus 1/T between 50 and 80 °C, were 42.9, 52.7, and 65.6 kJ/mol, respectively. These values were different from those obtained between 25 and 50 °C and were believed to have been influenced by the interference of Tinuvin (a UV stabilizer) at elevated temperatures higher than 50 °C. Although the desorption rate of SPAN‐40 increased with the temperature and decreased with the EAA content, the observed spectral behavior did not depend on the temperature and time. For all specimens stored over 50 °C, the peak at 1739 cm^?1 decreased in a few days and subsequently increased with a peak shift toward 1730 cm^?1. This arose from the carbonyl stretching vibration of Tinuvin, possibly because of oxidation or degradation at elevated temperatures. In addition, the incorporation of EAA into the LLDPE blend suppressed the desorption rate of SPAN‐40 and retarded the appearance of the 1730 cm^?1 peak. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1114–1126, 2004     

Effects of poly[styrene‐b‐(ethylene‐co‐butylene)‐b‐styrene] on the charge distributions of low‐density polyethylene/polystyrene blends

The effect of the triblock copolymer poly[styrene‐b‐(ethylene‐co‐butylene)‐b‐styrene] (SEBS) on the formation of the space charge of immiscible low‐density polyethylene (LDPE)/polystyrene (PS) blends was investigated. Blends of 70/30 (wt %) LDPE/PS were prepared through melt blending in an internal mixer at a blend temperature of 220 °C. The amount of charge that accumulated in the 70% LDPE/30% PS blends decreased when the SEBS content increased up to 10 wt %. For compatibilized and uncompatibilized blends, no significant change in the degree of crystallinity of LDPE in the blends was observed, and so the effect of crystallization on the space charge distribution could be excluded. Morphological observations showed that the addition of SEBS resulted in a domain size reduction of the dispersed PS phase and better interfacial adhesion between the LDPE and PS phases. The location of SEBS at a domain interface enabled charges to migrate from one phase to the other via the domain interface and, therefore, resulted in a significant decrease in the amount of space charge for the LDPE/PS blends with SEBS. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2813–2820, 2004     

铁基添加剂增强细水雾灭火性能的实验研究

采用实验模拟的方法,研究了添加氯化亚铁的细水雾在不同添加剂浓度、不同喷头压力下,熄灭不同性质的液体池火的性能。实验结果表明:添加有氯化亚铁的细水雾,其灭火性能发生了显著变化。存在一个最佳的灭火浓度,其对应的灭火时间最短,耗水量最少,灭火效率最高。细水雾喷头的工作压力和燃料的性质也对细水雾的灭火性能有影响:工作压力越大,细水雾的平均灭火时间越短。在相同的实验条件下,细水雾扑灭煤油池火的时间要短于扑灭酒精池火的时间。     

空间有源消声的微机控制

本文讨论用通用微机控制空间有源消声．以修正的PID（比例、积分、微分）算法加上逻辑判断构成的控制软件，使得系统收敛迅速，跟踪速度快，消声效果令人满意，而且系统工作稳定可靠，     

一种漂移室定位子性能反常现象的研究

研究了一种漂移室定位子性能的反常现象,它关系到定位子的使用寿命．着重测量了暗电流和随机噪声与时间、高压及温度的关系.     

高功率激光驱动器中小尺度自聚焦和噪声模型

 建立了一套线性的近似分析方法，研究高功率激光驱动器中强激光传输的小尺度自聚焦效应和相位噪声对光束传输和光束质量的影响，给出了系统噪声强度、B积分值与光束近场调制对比度之间的定量关系。研究表明,为保证输出光束质量，即近场调制对比度小于给定值，系统内的噪声强度必须符合一定的谱分布。     

A branching process model for sand avalanches

An analytically solvable model for sand avalanches of noninteracting grains of sand, based on the Chapman-Kolmogorov equations, is presented. For a single avalanche, distributions of lifetimes, sizes of overflows and avalanches, and correlation functions are calculated. Some of these are exponentials, some are power laws. Spatially homogeneous distributions of avalanches are also studied. Computer simulations of avalanches of interacting grains of sand are compared to the solutions to the Chapman-Kolmogorov equations. We find that within the range of parameters explored in the simulation, the approximation of noninteracting grains of sand is a good one.     

What is novel in quantum transport for mesoscopics?

The understanding of mesoscopic transport has now attained an ultimate simplicity. Indeed, orthodox quantum kinetics would seem to say little about mesoscopics that has not been revealed — nearly effortlessly — by more popular means. Such is far from the case, however. The fact that kinetic theory remains very much in charge is best appreciated through the physics of a quantum point contact. While discretization of its conductance is viewed as the exclusive result of coherent, single-electron-wave transmission, this does not begin to address the paramount feature of all metallic conduction: dissipation. A perfect quantum point contact still has finite resistance, so its ballistic carriers must dissipate the energy gained from the applied field. How do they manage that? The key is in standard many-body quantum theory, and its conservation principles.     

Performance Enhancement for Optical Fast Frequency-hopping CDMA Systems by BCH Channel Coding

In this paper, the impact of optical beat noise on the performance of optical fast frequency-hopping code-division multiple-access (FFH OCDMA) networks is analyzed. BCH/FFH-OCDMA to reduce the impact of optical beat noise is proposed. It is shown that, BCH/FFH-OCDMA has much better performance under the same bit rate, same chip time and same number of available wavelengths. Another advantage for BCH/FFH-OCDMA is that the code length of one-coincidence sequence will be shorter, which can greatly reduce the difficulty of fabrication for fiber gratings.