Evaluation of the Lazarus-Leblond constants in the asymptotic model of the interfacial wavy crack

The paper addresses the problem of a semi-infinite plane crack along the interface between two isotropic half-spaces. Two methods of solution have been considered in the past: Lazarus and Leblond [1998a. Three-dimensional crack-face weight functions for the semi-infinite interface crack-I: variation of the stress intensity factors due to some small perturbation of the crack front. J. Mech. Phys. Solids 46, 489-511, 1998b. Three-dimensional crack-face weight functions for the semi-infinite interface crack-II: integrodifferential equations on the weight functions and resolution J. Mech. Phys. Solids 46, 513-536] applied the “special” method by Bueckner [1987. Weight functions and fundamental fields for the penny-shaped and the half-plane crack in three space. Int. J. Solids Struct. 23, 57-93] and found the expression of the variation of the stress intensity factors for a wavy crack without solving the complete elasticity problem; their solution is expressed in terms of the physical variables, and it involves five constants whose analytical representation was unknown; on the other hand, the “general” solution to the problem has been recently addressed by Bercial-Velez et al. [2005. High-order asymptotics and perturbation problems for 3D interfacial cracks. J. Mech. Phys. Solids 53, 1128-1162], using a Wiener-Hopf analysis and singular asymptotics near the crack front.The main goal of the present paper is to complete the solution to the problem by providing the connection between the two methods. This is done by constructing an integral representation for Lazarus-Leblond's weight functions and by deriving the closed form representations of Lazarus-Leblond's constants.     

Specific heat and related thermophysical properties of liquid Fe-Cu-Mo alloy

The specific heat and related thermophysical properties of liquid Fe77.5Cu13Mo9.5 monotectic alloy were investigated by an electromagnetic levitation drop calorimeter over a wide temperature range from 1482 to 1818 K. A maximum undercooling of 221 K (0.13 Tm) was achieved and the specific heat was determined as 44.71 J·mol-1·K-1. The excess specific heat, enthalpy change, entropy change and Gibbs free energy difference of this alloy were calculated on the basis of experimental results. It was found that the calculated results by traditional estimating methods can only describe the solidification process under low undercooling conditions. Only the experimental results can reflect the reality under high undercooling conditions. Meanwhile, the thermal diffusivity, thermal conductivity, and sound speed were derived from the present experimental results. Furthermore, the solidified microstructural morphology was examined, which consists of (Fe) and (Cu) phases. The calculated interface energy was applied to exploring the correlation between competitive nucleation and solidification microstructure within monotectic alloy.     

Characterization of reduced iso‐α‐acids derived from hops (Humulus lupulus) by NMR

Reduced forms of iso‐α‐acids (isohumulones), used in modern beer brewing were separated and characterized by ¹H and ¹³C NMR spectroscopy. Components from mixtures of rho‐iso‐α‐acids, tetrahydro‐iso‐α‐acids, and hexahydro‐iso‐α‐acids were isolated using high‐performance liquid chromatography (HPLC) and analyzed by use of one‐ and two‐dimensional NMR experiments. The data presented assign the identities of the main peaks in the HPLC traces for the reduced iso‐α‐acids. Previous tentative assignments regarding the cis and trans configurations and the structures of the acyl residues of the reduced iso‐α‐acids were confirmed and extensive NMR assignments were made. Furthermore, the previously unknown stereochemistry in the C‐4 side‐chain of the rho‐ and hexahydro‐iso‐α‐acids was assigned. Copyright © 2003 John Wiley & Sons, Ltd.     

室温下压致铁钴镍合金的bcc→hcp相变

 本文采用高压X光衍射方法在金刚石对顶压砧中在位地（in situ）研究了Fe₆₈Co₂₄Ni₈（wt%）合金在室温下的压致bcc→hcp结构相变和直到40.5 GPa的等温压缩行为。实验结果表明该合金在常压下为bcc结构，晶格常数a₀=(0.287 0±0.000 1) nm，体积V₀=(7.119±0.007) cm³/mol，密度ρ₀=(7.981±0.008) g/cm³；在20.9 GPa附近出现bcc→hcp结构相变，两相共存压力区约10 GPa，在此区域内有晶面间距d(002)_hcp=d(110)_bcc，且原子平面(002)_hcp//(110)_bcc，hcp相比bcc相体积减小(0.33±0.02) cm³/mol；高压相hcp结构的晶格参数比值c/a=1.608±0.004；相变后原子配位数的增加使得hcp相(002)平面内及(002)平面间的最近邻原子间距比bcc相最近邻原子间距分别增大约1.6%和0.5%；用Murnaghan状态方程对实验数据进行最小二乘法拟合，得到bcc相B₀=(130±13) GPa，B₀'=12.6±0.5；hcp相V₀=(6.62±0.04) cm³/mol，B₀=(243±21) GPa，B₀'=6.8±0.3；对于该合金的bcc→fcp相变时的结构转变机制做了详细的讨论。     

高压下液态Ag-20 at%Ge合金的凝固及密排六方亚稳相的形成

 利用高压淬火方法，在液态Ag-20at%Ge合金的凝固过程中，对比液态急冷低四个数量级的冷却速率得到了单相密排六方结构亚稳相，其点阵参数为a=0.289 8 nm，c=0.470 8 nm，c/a=1.625。     

高压处理对BiSrCaCu2Oy超导电性的影响

 本文在高T_c超导体BiSrCaCu₂O_y常压制备的基础上，研究了热压烧结和冷压处理对其形成、结构及超导电性的影响，并与常压结果进行了比较。结果表明，高压可以使样品的合成时间缩短，合成温度降低。但同时它也抑制了晶格参数较大的相（高T_c相）的形成，使小晶格参数的杂相含量增多。对于提高样品的超导电性而言，1.5 GPa时一个较好的压力点。     

Fluorescent humic substances–arsenic complex in well water in areas where blackfoot disease is endemic in Taiwan

The relationship between the four components, (1) fluorescence intensity, (2) arsenic concentration, (3) pH and (4) total dissolved solids, (TDS) measured in well waters from areas in Taiwan where blackfoot disease (BFD) is endemic was studied, as well as the relationships between the four degrees of BFD and each of the above four symptomatic components, in order to evaluate the etiological factors of BFD more progressively. The following 95% confidence intervals were obtained in well water samples (n = 1189): fluorescence intensity, 26.837–32.570; arsenic concentration, 0.103–0.127 mg dm^?3; pH, 7.466–7.519; and TDS 733.063–801.647 mg dm^?3. Fluorescence intensities of the four degrees of BFD were not all the same (F = 64.54, P < 0.001), and nor were arsenic concentrations (F = 72.03, P < 0.001), pH values (F = 7.30, P < 0.001), nor TDS values (F = 10.76, P < 0.001). In addition, multiple comparisons indicate that the higher the epidemical degree, the higher the fluorescence intensities, arsenic concentrations and pH values become; however, such a relationship is not found for TDS values. Moreover, the fluorescence intensities have positive linear correlations with arsenic concentrations (r = 0.49, P < 0.001), pH (r = 0.25, P < 0.001), and TDS (r = 0.18, P < 0.001), as do the arsenic concentrations with pH (r = 0.22, P < 0.001). Of the four epidemical degree groups, pairs are not significantly different from one another in correlation coefficients between fluorescence intensity and arsenic concentration, which implies a steady relationship between fluorescent compounds and arsenic. We conclude that fluorescent compounds in well water, as possible etiological factors of BFD, are closely related to arsenic along with pH and TDS values in the areas where BFD is endemic. In addition, we infer that a complex is formed by fluorescent compounds, arsenic and other metals.     

在相干理论的基础上分析光栅成像

本文在相干理论的基础上,推导了光栅成像中的光强分布和物像位置关系,并给出一组具有不同参数的实验照片及一组借助计算机绘制的强度分布图。     

Auditory evoked responses: A tool to assess the fetal neurological activity

An intact auditory system at birth is requisite for the successful accomplishment of many developmental skills. Evoked responses to auditory stimuli have been used as a sensitive test to determine the functional status of the adult and neonatal brain. It has been established that fetuses can hear in utero and respond to external acoustic stimuli. We present an overview of the transmission of sound through the maternal abdomen to the fetal ear and the recordings of an auditory evoked response obtained from the fetus using a non-invasive magnetoencephalography technique. The investigation of cortical activity of the fetus in response to auditory stimulation can help understand and track the neurological development of the fetus.     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007