高效液相色谱法所用大孔硅胶填料的制备

对国产ＧＹＱＧ球形硅胶施加高压水热处理并进行扩孔，制备了用于高效液相色谱法的大孔硅胶填料，考察了扩孔压力，扩孔温度和扩孔时间对平均孔径和比表面积的影响。并将产品日本ＳＩＬ－３００３×１０＾－８ｍ硅胶进行了物理性质和孔分布的对比实验，结果表明ＧＹＱＧ硅胶扩孔后平均孔径为２０～３０ｎｍ接近日本ＳＩＬ－３００３×１０＾－８ｍ硅前平平均孔径２５ｎｍ。display structure     

Diffusion in organic solvents: Interdiffusion coefficient of 1,1,2,2-tetrabromoethane

Interdiffusion coefficient have been measured for 1,1,2,2-tetrabromoethane in 21 organic solvents in order to ascertain the influence of shape, size, viscosity, nature and degree of branching, of the solvent molecules on transport properties. None of the existing correlations for diffusion in binary liquid systems appear to fit all the experimental data. Steric effects due to the solvent molecules are shown to be very important in the interpretation of the diffusion process.     

Structure of polynuclear palladium(ii) hydroxocomplexes formed upon alkaline hydrolysis of palladium(ii) chloride complexes

The structure of polynuclear Pd^II hydroxocomplexes (PHC) formed as a result of alkaline hydrolysis of Pd^II chloride complexes was studied by EXAFS, SAXS, and TEM methods. It is established that in aqueous solutions a hydroxocomplex particle is a filament curled into a ball containing about 100 Pd atoms. The filament consists of planar coordination squares of PdO₄ units linkedvia one or two oxygen bridges of different geometry. Aging of samples results in an increase in the number of single bridging ligands and a decrease in the diameter of particles. Interatomic distances around palladium atoms were determined.Translated fromIzvestiya Akademii Nauk. Seriya Khimlcheskaya, No. 10, pp. 1901–1905, October, 1995.     

碳酸氢铵沉淀法制备氧化钇粉体时反应条件对产物粒度的影响

研究了碳酸氢铵沉淀法的反应条件对氧化钇粒度的影响,探讨了粒度变化规律。发现在沉淀反应中,晶型碳酸钇铵的形成与否是影响氧化钇粒度的关键因素。在较低的反应温度下,当碳酸氢铵和氯化钇的浓度大于0.25mol·L-1,摩尔比大于5,陈化时间大于60min时得到碳酸钇铵沉淀,经煅烧可获得粒度(D50)大于1μm的氧化钇。当反应物浓度较低、摩尔比小,陈化时间较短时得到无定型碳酸钇沉淀,煅烧沉淀可获得粒度(D50)小于0.5μm的氧化钇。实验证明选择适当的沉淀反应条件,可制备D50在0.3～10μm范围内的不同粒度级别的氧化钇粉体。     

On the physical adsorption of gases on carbon materials from molecular simulation

In this paper we present a series of work covering a range of aspects relating molecular simulation to experiment. The importance of surface mediation type effects to the adsorption of simple and complex gases is demonstrated. Coupled with the adsorption of simple gases is their projection area when used for surface area determination. The pressure dependence of a projection area is demonstrated for argon at 77 and 87.3 K. A simple model is used to account for the degree of graphitisation of a surface is demonstrated and used to account for the isosteric heat behaviour of non-graphitised carbon blacks. Turning from surfaces to porous solids, an alternative treatment of experiment data (either sub or super critical) is presented that avoids the ambiguity of excess amounts adsorbed. Using this method one is able to obtain pore size distributions and amounts adsorbed without relying on such things as helium expansion volumes. Since this type of method is usually applied to composite solids we also demonstrate the correct method for calculating the heat of adsorption using independent sets of simulations. The final topic covered in this paper is an example of the information that can be gained from the heat capacity of an adsorbed phase.     

介观化学体系中的动力学尺度效应

以生命和表面催化体系为对象，研究了介观化学体系中内涨落对体系非线性动力学行为的调控作用。内涨落可以诱导随机振荡，其强度在体系处于最佳尺度时会出现一个甚至多个极大值，并且在耦合体系中会得到进一步增强，表现为尺度共振效应、尺度选择效应和双重尺度效应，揭示了介观化学体系中尺度效应的新机制。     

Pore size distributions in low‐k dielectric thin films from X‐ray porosimetry

X‐ray reflectivity has been used to determine the mass uptake of probe molecules in porous thin films supported on thick silicon wafers. The adsorption occurs by capillary condensation when the films are exposed to probe vapor at controlled partial vapor pressures. The probe solvent partial pressure was varied by mixing saturated air and dry air at constant temperature or by changing sample temperature at a constant vapor concentration. Pore size distribution in the films can be calculated from the probe uptake with typical porosimetric approaches such as the application of the Kelvin equation to convert partial pressure into pore size. For illustration, the pore size distribution of three different nanoporous thin films, the primary candidate of ultra‐low‐k interlevel dielectrics in the next generation of integrated circuit chips, was determined with this technique. These samples represent different generations of low‐k dielectrics developed by industry. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 2170–2177, 2002     

Studies on the porous structure of di(methacryloyloxymethyl) naphthalene-divinylbenzene copolymers by inverse exclusion chromatography

Summary Using inverse exclusion chromatography the porous structure of the copolymers of di(methacryloyloxymethyl)naphthalenes and divinylbenzene was investigated.In order to determine the pore size distributions of the copolymers, toluene, alkylphenones, phthalates and polystyrene standards were used as the probes.The measurements proved that the existence of micropores depend on the method of copolymerization. The copolymers obtained by suspension and emulsion methods are more or less microporous, but the copolymer prepared by thermal polymerization in mass does not include micropores in its internal structure.     

化学蒸气沉积硅氧化合物调变HZSM－5沸石的研究

本文研究了正硅酸乙酯分别在无胺法和有胺法制得的ＨＺＳＭ－５沸石上的沉积过程，并用吸附，ＮＨ３－ＴＰＤ及异丙醇探针反应等手段表征了沉积后的样品，发现沉积仅在外表面上进行，可使孔口变小但不影响孔道内性质，显示有对于二甲苯分子的择形吸附能力，且在甲苯甲醇烷基化反应和二甲苯异构化反应中表现出良好的择形催化性能．     

氧化钇粒度控制与测定

用氨水或碳酸氢铵与氯化钇溶液反应生成沉淀，煅烧沉淀制备了D50为0．45μmt 2-10μm的各种粒径的氧化钇粉末。分别采用Coulter MultisizerⅡ和90Plus粒度仪测定微米和亚微米级氧化钇粉体粒度，研究了分散剂，待测样品量，分散时间等因素对亚微米级氧化钇粉体粒度测量精度的影响。