Optimization of Mass Transfer Processes in the Zone of the Air Electrode of a Fuel Cell with a Solid Polymer Electrolyte

A two-dimensional mathematical model for the transport of reactants in a fuel cell with a solid polymer electrolyte is developed. The model is used for analyzing spatial distributions of the concentration of reactants and current density over the cell. The effect of the catalytic-layer activity, reactant speed, bipolar-plate geometry, thickness and porosity of current collector and/or gas-diffusion sublayer, and the reaction mixture composition on the fuel cell efficiency is estimated theoretically and experimentally.     

Solid Phase Synthesis of 2-Substituted 1,3-Oxazin-6-ones Using Resin-bound Cyclic Malonic Acid Ester

A facile solid phase synthesis of 2-substituted 1,3-oxazin-6-ones using polymer-supported Meldrum‘s acid has been reported. Reaction of the resin-bound cyclic malonic acid ester with triethyl orthoformate and subsequent double substitution with amide, afforded the corresponding polymer-supported acylaminomethylene cyclic malonic acid ester, which upon thermal treatment led to 1, 3-oxazin-6-ones in good yields and with high purity.     

Solid phase synthesis of azapeptides using an automatic synthesizer

Peptides containing azaglycine located terminally or within the backbone have been prepared in the solid phase by means of an automatic synthesizer.     

四（对-羟基苯基）卟啉氧合配合物的室温固相合成，表征及氧合能力

采用固相反应合成了四羟基苯基卟啉与与Fe^2＋,Co^2＋金属离子的配合物,在室温下,将其与分子O2作用,提纯后得到两种固态氧合配合物．通过元素分析、红外光谱（IR）、核磁共振氢谱（^1HNMR）、电导、热分析（TG／DTA）、紫外光谱（UV）等测试手段确定了氧合配合物的组成为[Co·THPP·O2]（NO3）2·2H2O、[Fe·THPP·O2]Cl2·2H2O]，可知1mol配合物吸收了1molO2,采用失重法测定了氧合配合物中的配位氧,确定1mol金属配合物吸收1molO2形成超氧配合物．     

Developing a hybrid emulsion polymerization system to synthesize Fe3O4/polystyrene latexes with narrow size distribution and high magnetite content

A hybrid emulsion polymerization was formulated for synthesizing Fe₃O₄/polystyrene composite latex. This system, containing binary droplets that are magnetic (Mag)‐droplets with a diameter of 100–200 nm and styrene (St)‐droplets with a diameter of 3–4 μm, was obtained by mixing Mag‐miniemulsion and St‐macroemulsion. With extremely low surfactants concentration (?critical micelle concentration, CMC), the nucleated loci are selectively controlled in the Mag‐droplets, as the result of smaller droplet size and larger surface ratio. Both water‐soluble potassium persulfate (KPS) and oil‐soluble 2,2′‐azobis(2‐isobutyronitrile) was adopted to initiate the polymerization. In the presence of KPS, magnetic polystyrene latices with particles size of 60–200 nm, narrow size distribution, and high magnetite content (86 wt % measured by TGA) were attained successfully. The synthesized magnetic Fe₃O_4/polystyrene latices assembled into well‐ordered hexagonal structure in the surface of a carbon supported copper grid. The influence of various parameters on various aspects of the as‐synthesized Fe₃O₄/polystyrene was investigated in detail: type of initiator on composite morphology, feed ratio of Mag‐miniemulsion and St‐macroemulsion on magnetite content, and hydrophobic agent or amount of surfactant on size and size distribution. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5285–5295, 2007     

非晶硅薄膜的低温快速晶化及其结构分析

在镀铝的廉价玻璃衬底上高速沉积的非晶硅薄膜在不同的温度下退火10min.退火温度为500℃时,薄膜表面形成了硅铝的混合相,非晶硅薄膜开始呈现了晶化现象 退火温度为550℃时,大部分(约80%)的非晶硅晶化为多晶硅,平均晶粒尺寸为500nm 退火温度为600℃时,几乎所有的非晶硅都转化为多晶硅,其平均晶粒尺寸约为15μm.     

利用光反射精确测量亚共析碳钢的含碳量

本文从光学角度出发提出了一种经济实用、精度高的测量亚共析碳钢中碳的含量的新方法。阐述了该方法的测量原理，即以金相试样表面对光的反射程度来判定其含碳量，并给出了有关经验公式及数据处理方法。     

江汉平原上空QTEC变化特征的统计分析

提出了一种观测台网用多接收机性能一致性的标定方法，并利用江汉平原GPS接收台网的观测数据，分析了该地区上空QTEC的日变化、季节变化、年变化和逐年变化的统计特征．标定结果表明，不同接收机之间的仪器偏差是从双频GPS卫星信标推算QTEC的主要误差来源之一，必须校正．统计分析证实，江汉平原上空QTEC的日变化特征同时受电离层和等离子层控制，其年变化以半年周期为主，峰值和谷值分别出现在两分点和两至点附近，QTEC值的逐年变化从太阳活动峰年到低年逐年下降，与以太阳黑子数为代表的太阳活动密切相关．     

Effect of Hydrolysis Conditions on the Direct Formation of Nanoparticles of Ceria–Zirconia Solid Solutions from Acidic Aqueous Solutions

The effect of the cation concentration, hydrolysis temperature, and composition in the CeO₂–ZrO₂ system on the direct precipitation of ceria–zirconia solid solutions and the structure of the precipitates from acidic aqueous solutions of (NH₄)₂Ce(NO₃)₆ and ZrOCl₂ by hydrolysis under hydrothermal conditions were investigated. Nanometer-sized (8–10 nm) ceria–zirconia solid solution particles in a composition range of 0 to 60 mol% ZrO₂ were directly precipitated from the solutions with total metal cation concentration less than 0.2 mol/dm³ by simultaneous thermal hydrolysis at 150–240°C. The crystalline phase of the precipitates gradually changed from cubic and/or tetragonal to monoclinic with increasing the cation concentration of the solution from 0.2 to 0.8 mol/dm³ at the starting composition of 50 mol% ZrO₂ under hydrolysis condition of 150°C for 48 h, which was attributed to decrease in the supply of hydrolyzed Ce component caused by decrease in the hydrolysis ratio of (NH₄)₂Ce(NO₃)₆. Ceria–zirconia solid solutions containing large amount of ZrO₂ maintained high specific surface area and small-sized crystallite after heat-treatment at 900–1000°C for 1 h.     

Solid codes and the uniform density of fd-domains

By means of further investigation of solid codes,the problem“Is every fd-domain uni- formly dense”proposed by Yuqi Guo,C.M.Reis and G.Thierrin in 1988 is solved in this paper.