Influence of Cd and Cr substitutions on the magnetization and permeability of magnesium ferrites

Magnetization and permeability of polycrystalline ferrites with general formula Cd_xMg_1−xFe_2−yCr_yO₄ (x=0, 0.2, 0.4, 0.6, 0.8, 1.0; y=0, 0.05 and 0.10) were studied. Study of saturation magnetization reveals that the Neel's two-sublattice model exists upto x=0.4, for y=0, 0.05 and 0.1 and a three-sublattice model (YK-model) is predominant for x>0.4 and y=0, 0.05 and 0.10. The saturation magnetization and magnetic moment were found to decrease with the increase in Cr³⁺ contents, which is attributed to the dilution of B–B site interaction. Variation of initial permeability with temperature revealed the long-range ferromagnetic ordering in the compounds with x=0.4. The sample with x?0.4 and y=0, 0.05 and 0.10 showed peaking behavior near Curie temperature, which is attributed to the decrease of anisotropy constant K₁ to zero. Low-frequency dispersion of initial permeability suggests domain wall displacement. Addition of Cd²⁺ resulted in a sharp decrease in Curie temperature. With the addition of Cr³⁺, initial permeability was found to decrease.     

Suppression of red cell diffusional water permeability by lipophilic solutes

The inhibitory effect of a series of neutral lipophilic solutes (methanol, ethanol, n-propanol, iso-propanol, n-butanol, iso-amylalcohol, n-hexanol, diethylether, nitrobenzene, and pyridine) on the diffusional water permeability (Pd, tot) of bovine erythrocyte membrane at 25 degrees C was studied in comparison to that of p-chloromercuri benzoate (pCMB). Permeability data were obtained by measuring the transmembrane diffusional water exchange time tau(exch) using an 1H-T2 NMR technique. Maximal inhibition by approximately 50% of Pd, tot was produced by 2 mM pCMB which completely blocked the membrane water channels in 20 min, hence suggesting the channel-to-lipid diffusional water permeability ratio of about 1:1. Furthermore, the maximal inhibitory effect of pCMB in combination with the lipophilic solutes was lower than that of pCMB alone. As pCMB does not interfere with the lipid bilayer, and provided that it blocks the water channels in solute presence as well, this confirms that the solutes induce an increase in the lipid-mediated background water permeability contribution (Pd, lipid) by the formation of aqueous leaks in the membrane hydrophobic barrier. However, faster but less efficient in permeability inhibition than pCMB (either alone or combined with solutes) were the lipophilic solutes alone. Taken together, the results indicate that the lipophilic solutes suppress the membrane total permeability Pd, tot by two opposing effects: a reduction of its channel-mediated part (Pd, channel) to the extent exceeding that of a simultaneous Pd, lipid increase. The inhibitory potency of the solutes tested appears to be correlated with their solubility in the membrane medium.     

Dielectric,magnetic and mechanical properties of ferrite composites

The dielectric and magnetic properties of carbonyl—iron (CI) and nickel zinc ferrite polymer composites were studied with respect to the ferrite particulate content and microwave frequency. From the experimental data and using empirical models that relate the composite dielectric and magnetic properties, the respective dielectric and magnetic properties of the neat fillers were estimated. The tensile properties of the particulate composites comprising CI were shown to follow qualitatively Mooney's equation for the elastic modulus. The tensile strength of an elastomeric polyurethane and PVC composites containing CI increased with particulate content, while the elongation to break decreased with filler content. SEM micrographs of tensile fracture surfaces indicated that somewhat better adhesion is obtained in the case of the polyurethane-based composites compared to the PVC ones.     

多孔岩心的渗透性

The relaxation properties of water saturated in porous core are discussed and the distribution of proton transverse relaxation time and bi-exponential model of longitudiual relaxation time are obtained, which provide an illustration for two-model of fluids saturated in porous media. The cutoff value of T_1 based on relaxation specific property of fluids in porous core is adopted to improve the correlation between permeability and ?4T1b2.     

温度和压力对六氟二酐型聚酰亚胺的透气性能的影响

本文研究了温度和压力对五种六氟二酐（６ＦＤＡ）型聚酰亚胺膜对Ｈ_２、ＣＯ_２、Ｏ_２、Ｎ_２和ＣＨ_４五种气体透过性能的影响．在３０－１００℃区间，五种聚酰亚胺的透气系数与温度的关系均符合Ａｒｒｈｅｎｉｕｓ关系式；在０．３－１．２ＭＰａ区间，压力对透气系数的影响很小．６ＦＤＡ－４，４＇－二氨基二苯酮（ＤＡＢＰ）和６ＦＤＡ－３，３＇－二甲基二苯甲烷二胺（ＤＭＭＤＡ）在１００℃仍然具有较大的透气选择系数，是比较好的气体分离膜材料．     

联苯二酐型聚酰亚胺的透气性能与分子结构关系的研究

联苯二酐型聚酰亚胺的透气性能与分子结构关系的研究李悦生，丁孟贤，徐纪平（浙江大学高分子科学与工程研究所，杭州，３１００２７）（中国科学院长春应用化学研究所）关键词聚酰亚胺，膜，气体分离，透气性，透气选择性联苯二酐（ＢＰＤＡ）型聚酰亚胺具有较高的透气选...     

An NMR study of methanol diffusion in polymer electrolyte fuel cell membranes

Methanol diffusion in two polymer electrolyte membranes, Nafion 117 and BPSH 40 (a 40% disulfonated wholly aromatic polyarylene ether sulfone), was measured using a modified pulsed field gradient NMR method. This method allowed for the diffusion coefficient of methanol within the membrane to be determined while immersed in a methanol solution of known concentration. A second set of gradient pulses suppressed the signal from the solvent in solution, thus allowing the methanol within the membrane to be monitored unambiguously. Over a methanol concentration range of 0.5–8 M, methanol diffusion coefficients in Nafion 117 were found to increase from 2.9 × 10⁻⁶ to 4.0 × 10⁻⁶ cm² s⁻¹. For BPSH 40, the diffusion coefficient dropped significantly over the same concentration range, from 7.7 × 10⁻⁶ to 2.5 × 10⁻⁶cm² s⁻¹. The difference in diffusion behavior is largely related to the amount of solvent sorbed by the membranes. Increasing the methanol concentration results in an increase in solvent uptake for Nafion 117, while BPSH 40 actually excludes the solvent at higher concentrations. In contrast, diffusion of methanol measured via permeability measurements (assuming a partition coefficient of 1) was lower (1.3 × 10⁻⁶ and 6.4 × 10⁻⁷ cm² s⁻¹ for Nafion 117 and BPSH 40 respectively) and showed no concentration dependence. The differences observed between the two techniques are related to the length scale over which diffusion is monitored and the partition coefficient, or solubility, of methanol in the membranes as a function of concentration. For the permeability measurements, this length is equal to the thickness of the membrane (178 and 132 μm for Nafion 117 and BPSH 40 respectively) whereas the NMR method observes diffusion over a length of approximately 4–8 μm. Regardless of the measurement technique, BPSH 40 is a greater barrier to methanol permeability at high methanol concentrations.     

Transport properties and electroanalytical response characteristics of drotaverine ion-selective sensors

The construction and electroanalytical response characteristics of poly(vinyl chloride) matrix ion-selective sensors (ISSs) for drotaverine hydrochloride are described. The membranes incorporate ion-association complexes of drotaverine with tetraphenylborate, picrate, tetraiodomercurate, tetraiodobismuthate, Reinecke salt, and heteropolycompounds of Keggin structure—molybdophosphoric acid, tungstophosphoric acid, molybdosiliconic acid and tungstosiliconic acid as electroactive materials for ionometric sensor controls. These ISSs have a linear response to drotaverine hydrochloride over the range 8×10^–6 to 5×10^–2 mol L^–1 with cationic slopes from 51 to 58 mV per concentration decade. These ISSs have a fast response time (up to 1 min), a low determination limit (down to 4.3×10^–6 mol L^–1), good stability (3–5 weeks), and reasonable selectivity. Permeabilities and ion fluxes through a membrane were calculated for major and interfering ions. Dependences of the transport properties of the membranes on the concentrations of the ion exchanger and near-membrane solution and their electrochemical characteristics are presented. The ISSs were used for direct potentiometry and potentiometric titration (sodium tetraphenylborate) of drotaverine hydrochloride. Results with mean accuracy of 99.1±1.0% of nominal were obtained which corresponded well to data obtained by use of high-performance liquid chromatography.     

Morphology and transport properties of protons and methanol through partially sulfonated block copolymers

The morphological changes with different compositions of casting solvents in the membranes of sulfonated polystyrene-block-poly(ethylene-ran-butylene)-block-polystyrene (SEBS) were investigated with small-angle X-ray scattering (SAXS) and transmission electron microscope (TEM). Using the single solvent of tetrahydrofuran (THF) and the solvent mixtures of methanol/THF with different compositions, the casting polymer solutions were prepared for the membrane fabrication. The proton conductivity and the methanol permeability of membranes were measured, and the effect of morphological changes on the casting solvents was discussed through Flory–Huggins theory. It was found that the sulfonated SEBS membranes were transformed from well ordered lamellar to disordered co-continuous structure and the morphological difference caused abrupt enhancement in the proton conductivity and the methanol permeability as the concentration of methanol in the mixed solvents (MeOH/THF) increased.     

Effect of the aspect ratio of silicate platelets on the mechanical and barrier properties of hydrogenated acrylonitrile butadiene rubber (HNBR)/layered silicate nanocomposites

The role of the aspect ratio of the layered silicate platelets on the mechanical and oxygen permeation properties of hydrogenated nitrile rubber (HNBR)/organophilic layered silicate nanocomposites was investigated. Montmorillonite (MMT) and fluorohectorite (FHT) bearing the same type of intercalant (i.e., octadecylamine; ODA), however, showing different aspect ratio was involved in this study. The dispersion of the layered silicates was assessed by X-ray diffraction (XRD) and transmission electron microscopy (TEM), respectively. Increasing aspect ratio (MMT < FHT) resulted in higher stiffness under uniaxial tensile loading. The dispersion state (“secondary structure”) of the organophilic layered silicates reduced dramatically the oxygen permeability of the rubber matrix based on the labyrinth principle. The lowest oxygen permeability was measured for the HNBR/FHT-ODA films in which the layered silicates had the highest aspect ratio. By varying the FHT-ODA volume fraction in the latter compound the mechanical and permeation properties were measured and modelled. It was found that the modified Guth’s and Nielsen’s equations predicted accurately the mechanical and permeation responses, respectively.