Spatial and temporal resolution effects on dynamic contrast-enhanced magnetic resonance mammography

We tested the hypothesis that partial volume effects due to poor in-plane resolution and/or low temporal resolution used in clinical dynamic contrast-enhanced magnetic resonance imaging results in erroneous diagnostic information based on inaccurate estimates of tumor contrast agent extravasation and tested whether reduced encoding techniques can correct for dynamic data volume averaging. Image spatial resolution was reduced from 469 x 469 microm2 to those reported below by selecting a subset of k-space data. We then compared the top five K(trans)/V(T) "hot spots" obtained from the original data set, 469 x 469-microm in-plane spatial resolution and an 18-s temporal resolution processed by fast Fourier transform (FFT), with values obtained from data sets having in-plane spatial resolutions of 938 x 938, 1875 x 1875 and 2500 x 2500 microm2 and a temporal resolution of 18 s, or data sets with temporal resolutions of 36, 54 and 72 and a spatial resolution of 469 x 469 microm2, and found them to statistically differ from the parent data sets. We then tested four different post processing methods for improving the spatial resolution without sacrificing temporal resolution: zero-filled FFT, keyhole, reduced-encoding imaging by generalized-series reconstruction (RIGR) and two-reference RIGR (TRIGR). The top five values of K(trans)/V(T) obtained from data sets, the in-plane spatial resolutions of which were improved to 469 x 469 microm2 by zero-filling FFT, Keyhole and RIGR, statistically differed from those obtained from the original 469 x 469 microm2 FFT parent image data set. Only the 938 x 938 and 1875 x 1875 microm2 data sets reconstructed to 469 x 469 microm2 with TRIGR reconstruction method yielded values of the top five K(trans)/V(T) hot spots statistically the same as the original parent data set, 469 x 469 microm2 in-plane spatial and 18-s temporal-resolution FFT. That is, partial volume effects from data sets of different in-plane spatial resolution resulted in statistically different values of the top five K(trans)/V(T) hot spots relative to a high spatial and temporal resolution data set, and TRIGR reconstruction of these low resolution data sets to high resolution images provided statistically similar values with a savings in temporal resolution of 2 to 4 times.     

Molecular interactions between lipid bilayers and a water-soluble polymer

Molecular interactions between lipid bilayers (liposomes) and chondroitin sulfate C (CS), a water soluble polymer, have been investigated in terms of zeta-potential, particle size, microscopic-viscosity, microscopic-polarity of liposomes and permeability of calcein. Microscopic morphology is dramatically changed by the addition of CS to the positively charged liposomes (Pos.L), while it is not changed by the addition to uncharged liposomes (Unc.L) or negatively charged liposomes (Neg.L). The absolute value of the particle size of Pos.L increases with the addition of CS, while the zeta- potential of Pos.L decreases. Permeability of Pos.L decreases with an increase in the concentration of CS. Phase transition temperature of Pos.L is changed after the addition of CS. These values, however, are not changed for the other liposomes by the addition of CS. The results of gel filtration chromatography show that CS is absorbed on the Pos.L surface. Microscopic viscosity is also increased by the addition of CS to Pos.L due to the adsorption of CS.     

SYNTHESIS AND CHARACTERISTICS OF POLY(ARYLENE ETHER DIKETONE)S

Poly(arylene ether diketone)s were prepared by the aromatic nucleophilicdisplacement reaction of 4,4'-difluorobenzil with different bisphenols in the presence of an-hydrous potassium carbonate in diphenylsulfone at elevated temperature. The polymersobtained had inherent viscosity of 0.51 ～ 0.63 dL/g, and exhibited glass transition temper-ature ranging from 136 ～217℃ mainly depending on the bisphenols used in the polymersynthesis. Thermogravimetry of these polymers showed excellent thermal stability, indi-cating that 10% weight losses of the polymers were observed in the range above 428℃ and438℃ in air and nitrogen, respectively. The mechanical properties of these polymers werealso described and the permeability of five polymers for H_2, O_2 and N_2 was determined at30℃.     

Suppression of red cell diffusional water permeability by lipophilic solutes

The inhibitory effect of a series of neutral lipophilic solutes (methanol, ethanol, n-propanol, iso-propanol, n-butanol, iso-amylalcohol, n-hexanol, diethylether, nitrobenzene, and pyridine) on the diffusional water permeability (Pd, tot) of bovine erythrocyte membrane at 25 degrees C was studied in comparison to that of p-chloromercuri benzoate (pCMB). Permeability data were obtained by measuring the transmembrane diffusional water exchange time tau(exch) using an 1H-T2 NMR technique. Maximal inhibition by approximately 50% of Pd, tot was produced by 2 mM pCMB which completely blocked the membrane water channels in 20 min, hence suggesting the channel-to-lipid diffusional water permeability ratio of about 1:1. Furthermore, the maximal inhibitory effect of pCMB in combination with the lipophilic solutes was lower than that of pCMB alone. As pCMB does not interfere with the lipid bilayer, and provided that it blocks the water channels in solute presence as well, this confirms that the solutes induce an increase in the lipid-mediated background water permeability contribution (Pd, lipid) by the formation of aqueous leaks in the membrane hydrophobic barrier. However, faster but less efficient in permeability inhibition than pCMB (either alone or combined with solutes) were the lipophilic solutes alone. Taken together, the results indicate that the lipophilic solutes suppress the membrane total permeability Pd, tot by two opposing effects: a reduction of its channel-mediated part (Pd, channel) to the extent exceeding that of a simultaneous Pd, lipid increase. The inhibitory potency of the solutes tested appears to be correlated with their solubility in the membrane medium.     

GAS SORPTION AND TRANSPORT IN POLY (PHENYLENE OXIDE)(PPO)AND ARYL-BROMINATED PPO MEMBRANES

The apparent solubility (S), concentration-average diffusivity (D), and permeability (P), for C0_2, CH_4 and N_2 through PPO and aryl-brominated PPO at 35℃for pressure ranging from 1 to 26 atm are reported. It is found that P, D, and S of the membranes to all the three gases vary with the extent of bromination. S increases with the increase of the percent of bromine in each case, but D to CO_2 increases remarkably only at higher degree of brominafion, and therefore, P to CO_2 is increased by more than 100% over a wide range ofpressure in the case. The solubility data are well described by the dual mode sorption model. It is found that the gas molecules sorbed by the Langmuir mode are relatively more immobilized and the contribution of the nonequilibrinm character of the polymer to gas permeation increases obviously for CO_2 and is hardly changed for CH_4 with increasing bromine content. These observations are interpreted in terms of changes in specific free volume (SFV)and the cohesive energy density (CED) of the polymers.     

温度和压力对六氟二酐型聚酰亚胺的透气性能的影响

本文研究了温度和压力对五种六氟二酐（６ＦＤＡ）型聚酰亚胺膜对Ｈ_２、ＣＯ_２、Ｏ_２、Ｎ_２和ＣＨ_４五种气体透过性能的影响．在３０－１００℃区间，五种聚酰亚胺的透气系数与温度的关系均符合Ａｒｒｈｅｎｉｕｓ关系式；在０．３－１．２ＭＰａ区间，压力对透气系数的影响很小．６ＦＤＡ－４，４＇－二氨基二苯酮（ＤＡＢＰ）和６ＦＤＡ－３，３＇－二甲基二苯甲烷二胺（ＤＭＭＤＡ）在１００℃仍然具有较大的透气选择系数，是比较好的气体分离膜材料．     

An NMR study of methanol diffusion in polymer electrolyte fuel cell membranes

Methanol diffusion in two polymer electrolyte membranes, Nafion 117 and BPSH 40 (a 40% disulfonated wholly aromatic polyarylene ether sulfone), was measured using a modified pulsed field gradient NMR method. This method allowed for the diffusion coefficient of methanol within the membrane to be determined while immersed in a methanol solution of known concentration. A second set of gradient pulses suppressed the signal from the solvent in solution, thus allowing the methanol within the membrane to be monitored unambiguously. Over a methanol concentration range of 0.5–8 M, methanol diffusion coefficients in Nafion 117 were found to increase from 2.9 × 10⁻⁶ to 4.0 × 10⁻⁶ cm² s⁻¹. For BPSH 40, the diffusion coefficient dropped significantly over the same concentration range, from 7.7 × 10⁻⁶ to 2.5 × 10⁻⁶cm² s⁻¹. The difference in diffusion behavior is largely related to the amount of solvent sorbed by the membranes. Increasing the methanol concentration results in an increase in solvent uptake for Nafion 117, while BPSH 40 actually excludes the solvent at higher concentrations. In contrast, diffusion of methanol measured via permeability measurements (assuming a partition coefficient of 1) was lower (1.3 × 10⁻⁶ and 6.4 × 10⁻⁷ cm² s⁻¹ for Nafion 117 and BPSH 40 respectively) and showed no concentration dependence. The differences observed between the two techniques are related to the length scale over which diffusion is monitored and the partition coefficient, or solubility, of methanol in the membranes as a function of concentration. For the permeability measurements, this length is equal to the thickness of the membrane (178 and 132 μm for Nafion 117 and BPSH 40 respectively) whereas the NMR method observes diffusion over a length of approximately 4–8 μm. Regardless of the measurement technique, BPSH 40 is a greater barrier to methanol permeability at high methanol concentrations.     

Transport properties and electroanalytical response characteristics of drotaverine ion-selective sensors

The construction and electroanalytical response characteristics of poly(vinyl chloride) matrix ion-selective sensors (ISSs) for drotaverine hydrochloride are described. The membranes incorporate ion-association complexes of drotaverine with tetraphenylborate, picrate, tetraiodomercurate, tetraiodobismuthate, Reinecke salt, and heteropolycompounds of Keggin structure—molybdophosphoric acid, tungstophosphoric acid, molybdosiliconic acid and tungstosiliconic acid as electroactive materials for ionometric sensor controls. These ISSs have a linear response to drotaverine hydrochloride over the range 8×10^–6 to 5×10^–2 mol L^–1 with cationic slopes from 51 to 58 mV per concentration decade. These ISSs have a fast response time (up to 1 min), a low determination limit (down to 4.3×10^–6 mol L^–1), good stability (3–5 weeks), and reasonable selectivity. Permeabilities and ion fluxes through a membrane were calculated for major and interfering ions. Dependences of the transport properties of the membranes on the concentrations of the ion exchanger and near-membrane solution and their electrochemical characteristics are presented. The ISSs were used for direct potentiometry and potentiometric titration (sodium tetraphenylborate) of drotaverine hydrochloride. Results with mean accuracy of 99.1±1.0% of nominal were obtained which corresponded well to data obtained by use of high-performance liquid chromatography.     

联苯二酐型聚酰亚胺的透气性能与分子结构关系的研究

联苯二酐型聚酰亚胺的透气性能与分子结构关系的研究李悦生，丁孟贤，徐纪平（浙江大学高分子科学与工程研究所，杭州，３１００２７）（中国科学院长春应用化学研究所）关键词聚酰亚胺，膜，气体分离，透气性，透气选择性联苯二酐（ＢＰＤＡ）型聚酰亚胺具有较高的透气选...     

Morphology and transport properties of protons and methanol through partially sulfonated block copolymers

The morphological changes with different compositions of casting solvents in the membranes of sulfonated polystyrene-block-poly(ethylene-ran-butylene)-block-polystyrene (SEBS) were investigated with small-angle X-ray scattering (SAXS) and transmission electron microscope (TEM). Using the single solvent of tetrahydrofuran (THF) and the solvent mixtures of methanol/THF with different compositions, the casting polymer solutions were prepared for the membrane fabrication. The proton conductivity and the methanol permeability of membranes were measured, and the effect of morphological changes on the casting solvents was discussed through Flory–Huggins theory. It was found that the sulfonated SEBS membranes were transformed from well ordered lamellar to disordered co-continuous structure and the morphological difference caused abrupt enhancement in the proton conductivity and the methanol permeability as the concentration of methanol in the mixed solvents (MeOH/THF) increased.