A novel approach to the acoustic characterisation of porous road surfaces

Porous road surfaces offer an effective means of reducing the generation and propagation of noise from road traffic. However, the porosity of these surfaces can deteriorate over time, leading to a reduction in their noise reducing properties. Efficient methods are therefore required for monitoring this performance. Existing techniques for performing in-situ measurements of acoustic absorption are unsuitable for use within the traffic stream. Static measurements using time domain Maximum Length Sequence (MLS) based techniques have been demonstrated to offer advantages over traditional techniques, presenting the opportunity for measurements under dynamic conditions. This paper describes the design of a system for carrying out dynamic MLS-based measurements. Results are presented which demonstrate that stable dynamic measurements can be carried out at speeds of up to 30 km/h.     

Atomic distributions in acetylene-air flame using hydraulic high-pressure nebulization with direct (100%) introduction of solutions Applications to speciation analysis

One of the fundamental factors of the performance of atomic spectrometric methods is the efficiency of sample introduction into flame or plasma. By utilization of the formerly developed hydraulic high-pressure nebulizer, a nebulizer/burner system with solution uptake efficiency of 100% have been worked out. Optimizing operation parameters of nebulizer/burner system, an improvement of 2-12 times was achieved for the signal-to-noise ratio in the flame emission and flame atomic absorption spectrometry, depending on sample flow rate. This nebulizer is especially suitable for development of liquid chromatography-AAS/FES coupled technique for speciation analytical tasks.     

大气气溶胶粒子光吸收系数的测量

 采用核孔过滤膜累积气溶胶粒子的方法设计了气溶胶粒子光吸收系数的测量系统。该系统由双光路组成,可以减小光路损耗和电路噪声带来的各种测量误差。同时，具有体积小、光路易于调节、可进行实时测量、定标容易等特点。用200和400nm孔径的过滤膜，分别测量了实验室内大气气溶胶粒子对不同波长激光的吸收系数。随着累积时间的增加，系统的测量精度也不断的提高，在累积时间为900s时，系统测量误差为9.849×10^-6/m。     

Classical versus Jennings model for the ground state of H near a metallic surface

We show that, contrary to earlier reports, application of the one-parameter variational technique to the classical (image) model for H in front of an Al surface leads to energy shifts for the ground state which are very close to those obtained numerically with a more sophisticated model of the system.     

因素空间理论与知识表示的数学框架(XⅢ)──描述架中概念的结构(2)

本文是［１，１２］的继续，研究描述架中概念的结构；本文讨论后半部分，内容涉及概念内涵与外延的转换，清晰关系的内投影与内变换，概念的结构＊以及有关问题的注记。     

基于虚拟仪器的人体皮肤组织吸收光谱检测平台

本文运用光电无损检测技术,采用皮外反射式测量方法,通过光纤光谱仪和虚拟仪器构建人体皮肤组织吸收光谱检测平台.该平台适合于光子-组织相互作用基础研究及激光美容临床检测,可协助医师进行病理诊断和病变程度判别.文中给出几个吸收光谱的检测结果.     

火焰原子吸收光谱法测定钴-镍合金镀层中的钴和镍

利用原子吸收光谱法研究了在氨基磺酸钴-镍镀液中，赫尔槽试片上不同电流密度区合金镀层中钴、镍的含量。实验表明，该方法简便，快捷，结果准确，精密度高。相对标准偏差（RSD）为0.30%-0.62%，加标回收率为97.0%-104.0%。     

Acoustic characterization and prediction for fan-duct-plenum-room integrations

This paper investigates mutual influence of duct and room acoustics in the whole fan-duct-plenum-room integrations. Applying the parametric design language of finite element software ANSYS (APDL), dimensional and positional influence on system acoustics has been studied. Models with different room dimensions, duct lengths, duct cross-sections, duct locations, duct discharges and duct elbow were constructed, and their characteristics were compared qualitatively. Results show that small rooms, short ducts, large duct cross-sections and bell mouth duct discharges help to increase room sound pressure levels (SPLs); SPLs in ducts and plenums are sensitive to duct dimensions and duct discharge types but insensitive to duct locations and room dimensions; duct elbows have relatively indistinct acoustic influence in each component. Based on the calculation results, a semi-experimental method was proposed for simply and approximately evaluating indoor acoustic spectra of fan-duct-plenum-room integrations, then an example was used to demonstrate the prediction process. Finally, by adopting several ideal models, sound field constitutions, duct and room wall admittances and duct end reflection were explored quantitatively. This study may give a detailed understanding of fan-duct-plenum-room acoustics for researchers, also it might provide a new, simple and approximate prediction method for professionals to evaluate and improve fan-ducted acoustics.     

First-principles study on the origin of optical transitions to be associated with F colour centers for PbWO4 crystals

The electronic structures of PbWO₄ crystals containing F type color centers with the lattice structure optimized are studied within the framework of the fully relativistic self-consistent Direc–Slater theory, using a numerically discrete variational (DV-Xα) method. The calculated results show that F and F⁺ centers have donor energy level in forbidden band. Their optical transition energy are 1.84 eV, 2.21 eV, respectively, which corresponds to the 680 nm, 550 nm absorption bands. It predicts that the 680 nm, 550 nm absorption bands originate form the F and F⁺ centers in PbWO₄ crystals.     

Optimization of the locations of the loudspeaker and absorption material in a small room

The sound field both in the loudspeaker box and in the room is calculated by an analytical solution of three-dimensional wave equation. It is shown in theory that the amplitude response in small rooms is affected by the following positions: driver position on the front panel of the box, box position in the room, absorption material position in the box and absorption material position on the interior walls of the room. Both our computer prediction and experiments prove that the optimum positions are beneficial to the amplitude response.