n(Zn)：n(Ga)比值对合成ZnGa2O4结构及光致发光性能的影响

以ZnO和HGaO₂为原料,用不同配比合成出系列ZnGa₂O₄,并对其晶体结构和发光性能进行了研究。用荧光分光光度计检测了ZnGa₂O₄的激发和发射光谱,用X射线衍射仪检测了ZnGa₂O₄的衍射图谱,用热重差热仪绘制了TGA-DAT曲线。对检测结果分析认为:1.ZnGa₂O₄属于尖晶石结构,稍过量的Zn或Ga能进入ZnGa₂O₄结构中,并对ZnGa₂O₄的晶格常数产生一定影响。2.ZnGa₂O₄存在两个自激发光中心,当Ga稍过量时,自激发光中心是四面体镓氧键[T_d(Ga-O)],最大激发波长约248nm,最大发射波长约367nm;当Zn稍过量时,自激发光中心是八面体镓氧键[O_h(Ga-O)],最大激发波长约270nm,最大发射波长约441nm。当n(Zn):n(Ga)在理论值附近,激发和发射光强度最大,而且光谱峰位发生了红移。3.ZnGa₂O₄的热稳定性能非常好。上述结论对研究ZnGa₂O₄基质或掺杂的发光材料具有一定意义。     

Ni(111)表面一氧化碳和氢共吸附的密度泛函理论研究

本文用密度泛函理论(DFT)的总能计算研究了一氧化碳和氢原子在Ni(111)表面上p(2×2)共吸附系统的原子结构和电子态，结果表明CO和H原子分别被吸附于两个对角p(1×1)元胞的hcp和fcc位置.以氢分子和CO分子作为能量参考点，总吸附能为2.81 eV，相应的共吸附表面功函数φ为6.28 eV.计算得到的C—O，C—Ni和H—Ni的键长分别是1.19?, 1.96?和 1.71?，并且CO分子以C原子处于hcp的谷位与金属衬底原子结合.衬底Ni(111)的最外两层的晶面间距在吸附后的相对变化分别是 关键词： Fisher-Tropsch反应 催化作用 Ni(111) p(2×2)/(CO+H) 共吸附     

应力对M-Z型InP/InGaAsP-EAM偏振

采用Agilent 81910A光子全参量测试仪,首次实验研究了InP/In1－xGaxAs1－yPy-MQW（Multiple-Quantum-Well,MQW）材料与衬底间因应力而产生的M-Z型光调制器的PDL影响以及由此引起的由差分群时延(Differential Group Delay,DGD)表征的偏振模色散(Polarization Mode Dispersion,PMD).研究结果表明,半导体MQW光调制器的PDL与DGD是一致的.因此在半导体光器件的制作过程中,应尽可能地减小衬底与波导芯层之间的因残存应力的存在造成对光器件的高速性能的不利影响.     

识别过渡金属离子的1,8-萘二甲酰亚胺多胺衍生物荧光传感器的研究

设计合成了用以检测过渡金属离子的荧光化学敏感器体系,它们是由1,8-萘二酰亚胺为荧光团,多胺衍生物为金属离子受体组成．在室温下对其光物理性质的研究中发现,在没有加入过渡金属离子时,由于体系内存在有效的光诱导电子转移过程使得荧光团的荧光被淬灭．加入过渡金属离子后,金属离子受体中的氮原子和过渡金属离子之间的配位作用阻断了光诱导电子转移过程,体系的荧光增强．不同的金属离子受体表现出了和过渡金属离子不同的配位识别能力,并且通过荧光的变化传递出受体-金属离子作用的信息．     

铁分子Fe2的自旋极化效应

采用密度泛函方法(B3P86)对 Fe_2分子结构进行了优化.计算结果中未观察到自旋污染,基态波函数与高态波函数并未混杂,结果表明,Fe_2中有8个未配对电子,这些电子空间分布不同和自旋平行产生的自旋极化效应,使 Fe_2能量最低.计算结果表明,Fe_2分子的基态是~9∑_g~ ,并非~7Δ_u,进而表明 Fe_2的自旋平行效应比电子自旋配对效应要强.计算得到该分子基态的二阶、三阶和四阶力常数分别为1.4115×10~(-2)aJ/nm~2、-37.1751×10~3aJ/nm~3和 98.7596×10~4aJ/nm~4；光谱数据ω_eχ_e、B_e、α_e分别为0.3522、0.0345、 0.4963×10~(-4)cm~(-1)；离解能为3.5522eV,平衡键长为0.2137nm,振动频率为292.914cm~(-1)；并得到了 Murrel-Sorbie 函数.     

Structural and thermodynamic properties of AlB2 compound

We employ a first-principles plane wave method with the relativistic analytic pseudopotential of Hartwigsen, Goedecker and Hutter (HGH) scheme in the frame of DFT to calculate the equilibrium lattice parameters and the thermodynamic properties of AlB₂ compound with hcp structure. The obtained lattice parameters are in good agreement with the available experimental data and those calculated by others. Through the quasi-harmonic Debye model, obtained successfully are the dependences of the normalized lattice parameters a/a₀ and c/c₀ on pressure P, the normalized primitive cell volume V/V₀ on pressure P, the variation of the thermal expansion α with pressure P and temperature T, as well as the Debye temperature \Theta_D and the heat capacity C_V on pressure P and temperature T.     

An Integrated Two Phases Approach to Zn2+ Ions Electroreduction on Hg

The following two numerical models have been applied to zinc cations electroreduction in 1 M NaClO₄ water solution: a classical EE model describing the concentration of involved species in solution (semi infinitive diffusion region), an extended EE model describing both: the concentration of involved species in solution and the concentration of metallic zinc inside mercury drop (in limited area of diffusion). In the latter model the inner part of mercury drop and surrounding solution were treated as dynamic interrelated system. Both models were applied to experimental cyclic voltammetric CV data in 1 M NaClO₄, the results compared and discussed. The concentration profiles of all species including metallic zinc inside mercury drop were performed. The presented integrated model is essential for theoretical and analytical aspects of the electrochemistry of mercury soluble metal cations and amalgams.     

CONCEPTUAL DESIGN STUDIES OF AN 84 GHz, 500 kW, CW GYROTRON

The feasibility of an 84 GHz, 500 kW, CW gyrotron for ECRH on an experimental tokamak will be presented in this paper. Mode competition and mode selection procedures are carefully investigated by considering various candidate modes and the TE_10,4 mode is chosen as the operating mode. A conventional cylindrical cavity resonator with weak input and output tapers and parabolic roundings is considered for interaction studies. Self-consistent, both single mode and time-dependent, calculations are carried out and power and efficiencies are computed for a typical set of beam parameters. The results show that an output power of well over 500 kW, CW and efficiency around 40% can be reached without a depressed collector.