提升教学魅力,打造一门好课——《材料表面与界面》教学改革探索

《材料表面与界面》为高分子材料与工程专业复合材料方向的限选课。本课程对于学生奠定学科基础、培养学生对复合材料方向的兴趣具有重要的先导作用。笔者以"提升教学魅力,打造一门好课"为改革目标,充分贯彻了"教学内容是教学魅力的根本,教学方法与教学手段是将教学内容高效转化为教学魅力的催化剂"这一指导思想,从教学内容与教学方式两方面进行改革。从教学反馈看,这些改革措施能够改善教学效果,提高学生学习效率,得到了学生的认可。     

Visible Up-Conversion Luminescence in Ho3+: BaTiO3 Nano-Crystals Prepared by Sol Gel Technique

Visible up-conversion emissions at (435, 545, 580, 675 and 690 nm) and (437, 547 575 and 675 nm) have been observed from the sol-gel derived nano-crystalline Ho³⁺: BaTiO₃ powders and thin films respectively, under 808 nm laser diode excitation emissions. Combined with the energy level structure of Ho³⁺ ions and the kinetics of the visible emissions, the up-conversion mechanism has been analyzed and explained. The blue, green and red emissions of both samples has been attributed to the ground state-directed transition from (⁵F₁), (⁵S₂) and (⁵F₅), which are populated through excited state absorption (ESA) for 808 nm excitation. Nano-structure pure barium titanate and doped with different concentrations of Ho³⁺ ions in the from of powder and thin film have been prepared by sol-gel technique, using barium acetate (Ba(Ac)₂), and titanium butoxide (Ti(C₄H₉O)₄), as precursors. The thin films were prepared by sol-gel spin coating method. The as-grown thin films and powders were found to be amorphous, which crystallized to the tetragonal phase after heating at 750°C in air for 30 minutes. The crystallite sizes of the thin film and powder both doped with 4% Ho³⁺ ions was found to be equal to 11 and 16 nm, respectvely.     

低热-高压法制备PLGA多孔支架及其体外降解研究

采用低热-高压法制备了聚(dl-丙交酯／乙交酯)75／25(PLGA75／25)组织工程多孔支架。该方法避免了使用有机溶剂，支架的孔隙率在90％以上，孔径大小分布均匀。多孔支架经过酒精处理后，支架表面产生许多微小的凹陷；用藻酸钙改性处理后，支架形态保持良好。两种处理都使支架的压缩强度有所增大，亲水性增强。虽然孔隙率高的支架降解速率稍慢，但其体外降解规律基本一致：特性粘数争力学强度衰减快，而质量损失较慢，降解6周后，支架的质量损失仅为3％左右；体外降解3周后，支架的形态保持良好，可望在细胞移植争组织修复的早期发挥支撑作用。     

Chemiluminescent determination of reactive hydrocarbons

Summary Chemiluminescent reactions of ozone with several classes of compounds at different temperatures are described. In a reaction chamber in front of a photomultiplier ozone is mixed with the compounds studied such as alkanes, olefins, alcohols, aromatics, C₂H₂, NO, vinyl chloride or H₂S. The chemiluminescent emission is proportional to the concentration of the compound involved. At room temperature only olefinic hydrocarbons respond but at temperatures above 150°C also a response for alkanes, alcohols, CO etc. is obtained. It is suggested that next to the ozonide-excited formaldehyde mechanism the CO-CO ₂ ^* mechanism is responsible for the chemiluminescent emission at high temperature. A detection limit of a few ppb is achieved. Possible applications are a selective gas-chromatographic detector, an air pollution monitor for instance for CO, and a photochemical reactivity monitor.

---

Bestimmung reaktiver Kohlenwasserstoffe durch Chemiluminescenz

Zusammenfassung Chemiluminescenzreaktionen von Ozon mit verschiedenen Verbindungsgruppen (hauptsächlich Kohlenwasserstoffe) bei unterschiedlichen Temperaturen werden beschrieben. In einer Reaktionskammer werden die Verbindungen vor einem Photomultiplier mit Ozon vermischt. Es handelt sich u. a. um folgende Verbindungstypen: Alkane, Olefine, Alkohole, Aromaten, C₂H₂, NO, Vinylchlorid, H₂S. Die Emissionsintensität ist proportional der Konzentration. Bei Raumtemperatur sprechen nur Olefine an, die übrigen Verbindungen erst über 150°C. Die Emission bei höherer Temperatur wird neben der Bildung von Formaldehyd auf die Reaktion CO-CO ₂ ^* zurückgeführt. Die Nachweisgrenze beträgt wenige ppb. Als mögliche Anwendungsgebiete werden ein selektiver GC-Detektor, ein Monitor für Luftverunreinigungen (z.B. für CO) sowie ein Monitor zur Messung photochemischer Reaktivität der Luft genannt.

Presented at the 6th Annual Symposium on Recent Advances in the Analytical Chemistry of Pollutants, April 21–23, 1976; Vienna, Austria.     

R?ntgenspektrometrische Elementbestimmung in Abwasser: Probenvorbereitung und Matrixkorrekturverfahren

Zusammenfassung Für Elementbestimmungen in Abwasser wird ein Röntgenfluorescenzverfahren beschrieben. Zur Probenvorbereitung werden die Elemente durch Gefriertrocknung auf einem inerten Träger angereichert. Diese Anreicherung ist nicht selektiv und erfaßt praktisch alle in Abwasser gelösten und suspendierten Verunreinigungen. Für die Berechnung der Elementkonzentrationen aus den gemessenen Fluorescenzintensitäten wird ein Matrixkorrekturverfahren angegeben, welches dem unterschiedlichen Absorptionsverhalten der Probenmatrix Rechnung trägt. Die Massenabsorptionskoeffizienten werden durch Messung der diffus gestreuten Bremsstrahlung bzw. der Comptonstreustrahlung ermittelt. Die Selbstabsorption des zu bestimmenden Elementes wird rechnerisch berücksichtigt. Das Korrekturverfahren kann auf alle mit Röntgenfluorescenzanalyse bestimmbaren Elemente angewendet werden.

---

Determination of elements in waste water by x-ray fluorescence analysis: Sample preparation and matrix correction method

Summary For sample preparation the elements are enriched upon an inert carrier by freeze-drying. This enriching procedure is not selective and collects all dissolved and suspended contaminations from the waste water. In order to calculate the element concentrations from the measured fluorescence intensities a matrix correction method is given which considers the different absorption behaviour of the matrix. The mass absorption coefficients are obtained by measuring the scattered X-ray tube spectrum or a Compton scattered X-ray tube line, respectively. The self-absorption of the element to be determined is taken into account. The correction method is applicable to all elements detectable by X-ray fluorescence.

Herrn Dr. H. Wagner danken wir für das stete Interesse, die zahlreichen konstruktiven Diskussionen und die Hilfe beim Abfassen des Manuskripts.     

Kinetic studies of nickel speciation in model solutions of a well-characterized humic acid using the competing ligand exchange method

Publications on the binding characteristics of metals with humic acid (HA) are sparse. Here we investigated the release of nickel from Ni(II)-HA complexes using model solutions of three different [Ni(II)]/[HA] mole ratios at three different pH values; we also compared the results with those of [Ni(II)]/[FA] complexes from previous work in this laboratory. Ligand exchange kinetics using the competing ligand exchange method (CLEM) were studied using two different techniques: graphite furnace atomic absorption spectrometry (GFAAS) with Chelex 100 resin as the competing ligand, and adsorptive cathodic stripping voltammetry (AdCSV) with dimethylglyoxime as the competing ligand to measure the rate of dissociation of Ni(II)-HA complexes. The results of the kinetic studies showed that as the [Ni(II)]/[HA] mole ratio was decreased, the rate of dissociation of Ni(II)-HA complexes decreased, and the proportion of free Ni²⁺ ions plus very labile nickel complexes decreased while the proportion of the less labile kinetically distinguishable components increased. Generally, the rate of dissociation of Ni(II)-HA complexes was slower than that of Ni(II)-FA complexes. Studies on the validity of the kinetic model showed that the concentrations of chemical species varied in a reasonable way with pH and the [Ni(II)]/[HA] mole ratios, indicating that the kinetically distinguishable components have chemical significance and the kinetic model is valid.     

Potentiometric measurements of the first hydrolysis quotient of magnesium(II) to 250°C and 5 molal ionic strength (NaCl)

The first molal hydrolysis quotient, Q_1.1, of Mg²⁺ was measured potentiometrically from 1 to 250°C at ionic strengths of 0.11, 0.31, 1.01, and 5.0 mol-kg^-1 in an aqueous NaCl medium using a hydrogen-electrode, concentration cell. Only hydrolysis of the first four percent of the magnesium in solution could be followed before precipitation of brucite, Mg(OH)₂(cr), occurred. The log Q_1.1 values were fitted as a function of temperature and ionic strength using four adjustable parameters. The resulting constants are compared with the limited existing low temperature data. At infinite dilution and 25°C the following quantities are reported: logK _1.1 = -11.68±0.05, †H_so = 70.1±1.2 kJ-mol^-1, †S^o = 11±4 J-K^-1-mol^-1, and †C _p ^o = 0 J-K^-1-mor^-1. At each ionic strength, including the values extrapolated to infinite dilution, the heat capacity change for the hydrolysis reaction was zero,i.e., logQ _1.1 was found to be a linear function of the reciprocal temperature in Kelvin, at least over the measured range of l-250°C. The hydrolysis constants at infinite dilution were modeled to 550°C and two kbar pressure with a function incorporating solvent density using published results obtained at these extreme conditions.     

C(2×2)S/Fe(001)吸附体系的SCF-Xa-MS研究

采用SCF-X_α-MS方法, 对于C(2×2)S/Fe(001)吸附体系, 选择Fe_5S和Fe_9S两种原子簇模型, 研究了该吸附体系的电子结构、吸附成键特征及其相互作用图象。结果表明, S吸附于Fe(001)单晶表面具有较强的定域性质, S原子与底物Fe原子之间的吸附相互作用主要表现为S(3p)-Fe(4s,3d)之间的轨道相互作用。通过对表面吸附键长的优化, 其结果与X.S.Zhang等的ARPEFS的实验结果一致。     

Dynamic headspace analysis of trace volatile components in polymeric materials by wide bore capillary gas chromatography

A novel dynamic headspace gas chromatographic system equipped with a wide bore capillary column was constructed for direct analysis of less volatile components in polymeric materials such as coating paints. With this system, the determination of typical paint additives such as hindered amine light stabilizers and ultraviolet absorbers could be carried out within a short time.     

Thermal effects and band spreading in capillary electro-separation

Summary Four Capillary Electroseparation methods are distinguished. All have an ultimate efficiency limited only by axial diffusion and are in principle capable of achieving 10⁶ plates in <1 hour.The main limitation to performance arises from Ohmic heating of the electrolyte. While forced convection at 10ms^–1 is recommended to keep tubes cool, the parabolic temperature profile within the electrolyte limits the tube bore which can be used. A simple limiting expression is derived: (d_c/m)³ (E/kV m^–1)³ (c/mol dm^–3) <3.3×10⁹.Values of constants underlined