Hydrogenation Properties of Zr Films Under Various Conditions of Hydrogen Plasma

The hydrogenation properties of Zr samples with and without an Ni overlayer under various plasma conditions were investigated by means of non-Rutherford backscattering and elastic recoil detection analysis.The theoretical maximum hydrogen capacity,66.7 at%,could be achieved at a hydrogen absolute pressure of-2Pa and a substrate temperature of-393K for a plasma irradiation of only 10min;this was significantly greater than that for gas hydrogenation under the same hydrogen pressure and substrate temperature.It was also found that the C and O contamination on the sample surface strongly influences the hydrogenation,and that the maximum equilibrium hydrogen content drops dramatically with the increasing total contamination.In addition,the influence of the Ni overlayer on the plasma hydrogenation is discussed.     

利用光反射精确测量亚共析碳钢的含碳量

本文从光学角度出发提出了一种经济实用、精度高的测量亚共析碳钢中碳的含量的新方法。阐述了该方法的测量原理，即以金相试样表面对光的反射程度来判定其含碳量，并给出了有关经验公式及数据处理方法。     

Covariant Perturbation Theory of Non—Abelian Kinetic Theory

A “double perturbation” theory is presented in the framework of the kinetic theory of quark-gluon plasma.A solvable set of equations from the double perturbation are derived and proven to be gauge invariant.The Landau damping rate for the plasmon at zero momentum is shown to be a convergent series in correlators.     

双面电弧焊接的传热模型

将等离子焊接(PAW)电弧和钨极氩弧焊(TIG)电弧串接,相对作用于工件的正反面形成双面电弧焊接(DSAW)系统,可以引导焊接电流沿工件厚度方向流过小孔,补偿等离子电弧穿透工件时消耗的能量,以有效地提高等离子弧的穿透能力.综合考虑影响双面电弧焊接正反面熔池几何形状的力学因素,建立了熔池表面变形的控制方程,以此为基础并采用帖体曲线坐标系建立了DSAW焊接传热的数学模型,分析了DSAW,PAW焊接传热的差异,从传热的角度解释了DSAW焊接熔深增加的原因.焊接工艺实验表明,计算结果与实测结果吻合良好. 关键词： 双面电弧焊接(DSAW) 传热模型 熔池表面变形模型     

ICP-AES测定饮用水源中的Cu、Mn、Pb、Cd、Zn

用ICP－AES法同时测定饮用水源中的Cu、Mn、Pb、Cd、Zn等重金属元素，具有基体效应小、测量范围宽等优点。检出限为0．2－4．0μg/L，回收率为91．5％－103．9％，相对标准偏差为0．29％－1．5％，测定密码样与实际样品，结果令人满意。     

Spectrum Simulation of Li-Like Aluminium Plasma

X-ray emission spectra for L-shell of Li-like aluminium ions are simulated by using the flexible atomic code based on the collisional radiative model. Atomic processes including radiative recombination, dielectronic recombination, collisional ionization and resonance excitation from the neighbouring ion （Al^9＋ and Al^11＋ ） charge states of the target ion （Al^10＋） are considered in the model. In addition, the contributions of different atomic processes to the x-ray spectrum are analysed. The results show that dielectronic recombination, radiative recombination, collisional ionization and resonance excitation, other than direct collisional excitation, are very important processes.     

吸积盘的X射线辐射对周围星际物质的离化研究

利用辐射流体力学程序对三倍频纳秒激光与靶物质相互作用进行了模拟研究，得到了可以产生黑体辐射谱分布的激光等离子体X射线辐射靶的最佳厚度；数值模拟研究了黑体谱分布的X射线辐射场对等离子体系统平均离化度分布的影响，它有助于深入理解天体物理中吸积盘对它周围星际物质的离化影响. 关键词： 辐射流体力学 激光等离子体 X射线辐射 吸积盘 离化     

阴极还原处理对多孔硅发光性能的影响

对经过阴极还原处理后的多孔硅样片进行了光致发光测试和稳定性测试.实验结果表明这种处理能明显改善多孔硅的发光稳定性,使其表面结构更加稳定.利用原子力显微镜对不同还原时间的多孔硅微结构及形貌进行了比较,在一定范围内随着还原时间的增长多孔硅表面粗糙度增大,PL谱增强.     

喷气式Z箍缩等离子体辐射软X射线能谱的研究

研制了一台五通道ROSS-FILTER-PIN软X射线能谱仪，能谱范围为0.28—1.56keV.它由5个连续能段组成，每个能段的起止边由罗斯滤片对(ROSS-FILTERS)的L或K吸收边确定.罗斯滤片对的厚度通过优化计算得到，为了使每个通道的灵敏区外响应(即所测能段外响应)与通道总响应之比最小，在滤片对的第二滤片上镀上了一定厚度的第一滤片材料；为了缩减滤片表面积以增强低能滤片的抗冲击能力及方便滤片加工，能谱仪采用了小探测面积的PIN探测器(1mm²).借助此能谱仪，测量得到了喷气式Z箍缩(Z-pinch)等离子体辐射软X射线能谱的分布，并研究了软X射线产额随箍缩状况的变化趋势. 关键词： Z箍缩等离子体 罗斯滤片 软X射线能谱