磁化作用对汽油动态挥发性影响的研究

用热重（TG）分析和自行设计的原位动态挥发实验，研究了在不同条件下汽油的挥发性，结果表明，磁化空气或磁化汽油都可提高汽油的挥发性，而汽油和空气共同磁化，可更大幅度地提高汽油的挥发性。     

氧瓶燃烧甲基百里酚蓝法测定有机物中硫含量

1 引言 有机硫的测定在有机微量定量分析中颇占重要地位。我们采用氧瓶燃烧分解有机硫元素成硫酸根离子,继而测定之。尽管测定硫酸根离子方法很多,但每种方法均有其不足之处。用甲基百里酚蓝(MTB)测定硫酸根在国外曾有报道,而国内还是空白。我们选择了该方法做了些工作,为我国有机硫测定增加一种可选择的方法。     

Y2O3涂层负载Pd整体式催化剂的制备和催化性能

以Y(NO3)3为前驱体制备了Y2O3涂层的堇青石蜂窝陶瓷载体.扫描电子显微镜、X射线能谱和超声波振荡等表征结果表明,Y2O3涂层不但具有良好的抗振荡性和粘结强度,而且具有很强的吸附催化剂活性组分(H2PdCl4)的能力,适合制备负载型Pd催化剂.以甲苯和乙酸乙酯完全燃烧为模型反应考察了催化剂的活性,发现以Y2O3涂层堇青石蜂窝陶瓷为载体的整体式Pd/Y2O3催化剂具有良好的催化活性和热稳定性,甲苯和乙酸乙酯催化燃烧的T99分别为210和300℃;催化剂经900℃焙烧4 h后,T99仅提高20℃,表明催化剂具有很高的热稳定性.催化剂的X射线衍射、拉曼光谱和程序升温还原结果表明,Pd/Y2O3催化剂经低温焙烧时,Y2O3和PdO均高度分散在堇青石蜂窝陶瓷的表面,而高温焙烧使催化剂活性组分PdO晶粒增大,从而导致催化剂活性下降.     

PREPARATION OF CUO/γ-Al2O3 CATALYSTS FOR CATALYTIC COMBUSTION VOCS VIA PLASMA

CuO/γ-Al2O3 catalysts were prepared by plasma treatment and conventional impregnation methods. The catalytic combustion of two kinds of volatile organic compounds (VOCs), toluene and benzene, were carried out over these CuO/γ-Al2O3 catalysts. The surface properties of these catalysts were characterized by X-ray Diffraction (XRD) and Scanning Electron Microscopy (SEM). The experimental results showed that in catalytic combustion the activity of the CuO/γ-Al2O3 catalyst prepared via plasma was much higher than that of the CuO/γ-Al2O3 catalyst prepared by conventional impregnation method. XRD results showed that an enhanced dispersion had been achieved with the plasma treatment. SEM results indicated that the size became much smaller and the surface became more uniform with the plasma treatment.     

卟啉化合物的热化学研究: V. 含溴卟啉化合物的标准燃烧能和生成焓

用本实验室建立的精密转动氧弹燃烧热量计测定了标准物质对溴苯甲酸、辅助物质鲨烷及四对溴苯基卟啉(Tp-BrPP)的标准燃烧能, 并计算出了它们的标准生成焓。     

Effect of Drying Methods on the Structure and Combustion Activity of Mn—Substituted Hexaaluminate Catalysts

Conventional oven drying (COD) and supercritical drying (SCD) methods were applied to the preparation of Mn-substituted hexaaluminate (BaMnA111O19-α) catalysts. The effect of drying methods on phase composition, specific surface area, pore structure, reduction behavior of Mn^3 ions, and combus-tion activity of the samples was investigated. The homogenous mixing of the components in the sol-gel process could be maintained by SCD, and the hexaaluminate phase was almost the only phase of the resulting materials after calcination. H2-TPR revealed that the Mn^3 ions in the sample obtained by SCD were easier to be reduced than that by COD. Moreover, the samples obtained by SCD have higher surface area, narrower pore size distribution, and higher combustion activity than those obtained by COD.     

逆微乳液法合成六铝酸盐甲烷燃烧催化剂

采用逆微乳液为媒介合成六铝酸盐及其金属取代系列甲烷燃烧催化剂.首先研制了由表面活性剂、助剂、油相和水相四组分逆微乳液拟三元体系相图,选择十六烷基三甲基溴化铵(CTAB)为表面活性剂,脂肪醇为助剂,正辛烷为油相和水相[或Al(NO3)3溶液].研究了助剂脂肪醇链长、表面活性剂与助剂相对量和盐浓度对微乳液体系形成和稳定性影响,并以电导率随水含量变化的规律很好地印证了微乳液体系的相行为.选取相图中稳定微乳区合成了具有高温稳定性的甲烷催化燃烧催化剂六铝酸镧[La(Mnx/Fex)Al12-xO19-δ].用BET、TG-DTA和XRD表征了催化剂的物性和结构,并在微型固定床反应器中考察了对甲烷燃烧的催化活性.结果表明,利用逆微乳液作为反应介质使催化剂前驱体分散更充分,使六铝酸盐晶相形成的温度有效地降低到950℃.Fe取代的六铝酸盐具有较好高温催化活性和热稳定性,而Mn取代的同晶体则具有较好的低温催化活性,Fe和Mn离子同时对Al3 进行取代时,由于两者之间存在的协同效应明显提高了催化剂的催化活性和比表面,T10仅为475℃,T90为660℃.     

Gd_3Al_5O_(12)∶Eu~(3+)柠檬酸盐硝酸盐燃烧法合成及其发光性能研究

采用柠檬酸盐硝酸盐燃烧法,在较低的温度(900℃)下成功地合成单一晶相Gd3Al5O12∶Eu3+发光粉体,紫外激发荧光光谱分析表明,粉体615 nm和593 nm荧光发射源于Eu3+的5D0-7F2和5D0-7F1跃迁.该方法中各工艺条件(如pH值、柠檬酸/金属离子比、煅烧温度)对Gd3Al5O12∶Eu3+发光性能均有影响,通过试验得出了获得最佳发光性能荧光粉体的工艺参数.     

热重质谱联用(TG/MS)系统的建立和应用

将两种商品型分析仪器热重（TG）和质谱（MS）联用，并将这一热重质谱联用系统（TG／MS）应用于含酚废水的催化氧化和煤燃烧的过程研究，在获取样品重量变化的同时对逸出气相产物进行了在线检测，获取了苯酚氧化反应的历程和煤燃烧过程中氮、硫氧化物的逸出信息。