快速热退火对Co/Si0.85Geo.15肖特基结电学特性的影响

用离子束溅射技术分别在SiO2和单晶Si衬底上沉积了Si1-xGex和Co薄膜.在不同温度下,对Co/Si1-xGex肖特基结进行快速热退火处理(RTA),对处理后的样品进行了表面形貌和电学测量.发现退火温度升高,样品表面粗糙度变大,理想因子也变大,但对肖特基势垒高度(SBH)的影响很小.分析认为,随着退火温度的升高,...     

基于可调谐二极管激光吸收光谱波长调制技术在线测量燃烧场温度

 介绍了可调谐二极管激光吸收光谱（TDLAS）波长调制技术的测温原理。通过选择水在1 397.75 nm和1 397.87 nm处两条邻近的吸收线,运用多功能数据采集卡对二极管激光器进行控制和信号采集,实现了TDLAS波长调制技术对标定燃烧炉甲烷/空气预混火焰温度的实时在线测量,测量重复频率为250 Hz。分析了温度测量数据抖动的原因,结果表明燃烧过程中火焰本身温度的抖动是测量结果波动的主要原因,测量系统的A类标准不确定度小于53 K。     

强流二极管绝缘体滑闪监测及其影响

 以闪光二号加速器为研究平台, 建立了微分环阵列和Rogowski线圈同时监测二极管电流的方法,监测了二极管绝缘体表面的滑闪现象。根据电流探头测量结果的差异,分析了绝缘体滑闪对电子束流参数的影响。二极管绝缘体出现滑闪,位置附近的微分环波形严重畸变,其它位置的微分环和Rogowski线圈测量结果基本一致。采用距离滑闪位置较远的微分环结果处理二极管束流参数,相对于不出现滑闪时的结果,束流强度和总能量没有明显的变化。绝缘体滑闪沿面局部放电,能量损失较小,尚未对电子束流造成较大影响。     

应用于地形匹配导航的激光高度计设计

为解决基于雷达高度表探测的地形匹配导航系统探测精度不高、易受电子干扰影响而失效、且在跨海飞行时无法导航的难题,设计了一种激光高度计来代替雷达高度表进行地形探测。采用二极管泵浦固体激光器技术设计激光发射装置,输出近红外/蓝绿双波长激光,既可以测量陆地地形高度,又可以穿透海水探测海底地形;并根据激光高度计拟达到的性能指标选择合适的光电探测器,优化设计了光学系统、扫描系统和信号处理系统。所设计的激光高度计具有体积小、重量轻、高重频、探测灵敏度高、抗电磁干扰能力强等特点。     

高温环境中光触发开关的设计

 针对在高温环境中测试仪器的供电方式问题,利用光敏二极管响应时间短并对光灵敏的优点,将其作为供电电源的开关,吸收高温辐射源发出的红外光信号,通过光电转换,使电源导通,达到开关的效果。文中阐述了这种光控的供电方式的理论依据和实现方式,排除了日光等因素的干扰,并对该方法进行了验证。通过试验证明,该方法操作简单,实用性强,很适用于一些不适合人为操作的场合。     

A1/Ti/4H-SiC Schottky barrier diodes with inhomogeneous barrier heights

This paper investigates the current-voltage （I-V） characteristics of Al/Ti/4H-SiC Schottky barrier diodes （SBDs） in the temperature range of 77 K-500 K, which shows that Al/Ti/4H SiC SBDs have good rectifying behaviour. An abnormal behaviour, in which the zero bias barrier height decreases while the ideality factor increases with decreasing temperature （T）, has been successfully interpreted by using thermionic emission theory with Gaussian distribution of the barrier heights due to the inhomogeneous barrier height at the A1/Ti/4H-SiC interface. The effective Richardson constant A＊ = 154 A/cm2 . K2 is determined by means of a modified Richardson plot In（I0/T2） - （qσ）2/2（κT）2 versus q/kT, which is very close to the theoretical value 146 A/cm2 · K2.     

High-power diode-end-pumped Tm：YAP and Tm：YLF slab lasers

Diode-end-pumped continuous-wave(CW) Tm:YAP and Tm:YLF slab lasers are demonstrated. The a-cut Tm:YAP and Tm:YLF slabs with doping concentrations of 4 at.-% and 3.5 at.-%,respectively,are pumped by fast-axis collimated laser diodes at room temperature. The maximum CW output powers of 72 and 50.2 W are obtained from Tm:YAP and Tm:YLF,respectively,while the pump power is 220 W,corresponding to the slope efficiencies of 37.9% and 26.6%,respectively.     

Study of diode-pumped Yb:YAG disk lasers at low temperature

A Yb:YAG disk laser with V-shaped stable resonator and active-mirror configuration,end-pumped by a 940-nm InGaAs laser diode array,is demonstrated.Performances and optimization of the disk laser at low temperature over a range of 130-200 K are investigated theoretically and experimentally.Laser output energy of 1.46 J/pulse operating at 10-Hz repetition rate is obtained with the optimum output coupler transmission of 30%,and the corresponding optical-to-optical efficiency is 48.7%.     

Modified adaptive algebraic tomographic reconstruction of gas distribution from incomplete projection by a two-wavelength absorption scheme

A modified adaptive algebraic reconstruction technique (MAART) with an auto-adjustment relaxation parameter and smoothness regularization is developed to reveal the tomographic reconstruction of H 2 O distribution in combustion from incomplete projections. Determinations of relaxation parameter and regularization factor are discussed with regard to the consideration of improvement in reconstruction and reduction of computational burden. A two-wavelength scheme from tunable diode laser absorption measurement, 7444.36 and 7185.59 cm 1 , is used to simplify the nonlinear solution problem for obtaining the tomographic distributions of concentration and temperature simultaneously. Results of calculations demonstrate that MAART can perform the reconstruction results more efficiently with little complex modification and much lower iterations as compared with the traditional algebraic reconstruction technique (ART) or simultaneous iterative reconstruction technique (SIRT) methods. The stability of the algorithm is studied by reconstruction from projections with random noise at different levels to demonstrate the dependence of reconstruction results on precise line-of-sight measurements.     

n,p柱宽度对超结SiGe功率二极管电学特性的影响

结合SiGe材料的优异性能与超结结构在功率器件方面的优势,提出了一种超结SiGe功率二极管.该器件有两个重要特点:一是由轻掺杂的p型柱和n型柱相互交替形成超结结构,取代传统功率二极管的n^-基区;二是阳极p⁺区采用很薄的应变SiGe材料.该二极管可以克服常规Si p⁺n^-n⁺功率二极管存在的一些缺陷,如阻断电压增大的同时,正向导通压降随之增大,反向恢复时间也变长.利用二维器件模拟软件MEDICI仿真 关键词： 超结 锗硅二极管 n p柱宽度 电学特性