一种值得倡导的物理教学法——渗透性教学法

著名美籍华裔物理学家杨振宁教授，在他的演讲中，谈到有关教学方法与治学经验时，多次反复强调中国学生必须学会渗透性学习法，并且认为，能否在中国倡导体现这一精神的教学法，即渗透性教学法，归根结蒂在于改变中国传统的教育思想和教育体制。杨振宁教授     

Effect of dopant valence on the oxygen desorption and oxygen permeability of SrCo0.4Fe0.5M0.1O3-δ （M -Ni,Al and Zr） mixed-conducting oxides

The effect of dopant valence on oxygen desorption and oxygen permeability of SrCo0.4Fe0.5M0.1O3-δ （M = Ni, Al and Zr） mixed-conducting oxides were investigated in detail by O2-TPD and oxygen permeation measurement. The SrCo0.4Fe0.5M0.1O3-δ for M = Fe, Ni, Al and Zr were denoted as SCF, SCFN, SCFA and SCFZ, respectively. O2-TPD analysis revealed that the amount of α oxygen desorption decreased with increasing the valance of doped metal elements （SCFN 〉 SCFA SCF 〉 SCFZ）. The oxygen permeation flux at the temperature ≈igher than 1148 K decreased in the order of SCFN 〉 SCF 〉 SCFZ 〉 SCFA. Single activation for oxygen permeation was observed for SCFZ oxide and the activation energies of SCF and SCFA change at around 1073 K, while the change temoerature of SCFN was about 1173 K.     

二氧化钛纳米粒子-氧化石墨烯/聚酰亚胺混合基质膜的原位聚合及气体渗透性能

以钛酸四丁酯为前驱体,采用浸渍-沉淀法制备二氧化钛纳米粒子-氧化石墨烯(TiO_2-GO)复合物,再将TiO_2-GO复合物与4,4'-(六氟异亚丙基)邻苯二甲酸酐和4,4'-二氨基二苯醚通过原位聚合构建TiO_2-GO/TiO_2-GO/PI(聚酰亚胺)混合基质膜,用于CO_2的渗透脱除.采用傅里叶变换红外光谱(FTIR)、拉曼光谱(Raman)、透射电子显微镜(TEM)、扫描电子显微镜(SEM)、热失重(TG)和Zeta电位等表征了TiO_2-GO复合物和TiO_2-GO/PI混合基质膜的形貌与结构;探讨了TiO_2掺杂量对TiO_2-GO复合物及TiO_2-GO/PI混合基质膜的结构和气体渗透性能的影响.结果表明,TiO_2-GO复合物中TiO_2纳米粒子较均匀地沉积在GO片层上,TiO_2纳米粒子在形成的同时破坏了GO的结构,使其无序度增加.TiO_2的掺杂对TiO_2-GO/PI混合基质膜的形貌与结构影响较小,但提升了TiO_2-GO/PI混合基质膜的CO_2和N2渗透性能.但过量的掺杂使TiO_2粒子在GO片层上团聚,从而导致TiO_2-GO复合物在混合基质膜中的分散性变差,CO_2渗透性及CO_2/N2渗透选择性降低.当TiO_2掺杂质量分数为30%时,TiO_2-GO/PI混合基质膜的CO_2渗透性为360 Barrer[1 Barrer=10~(-10)cm~3(STP)·cm/(cm~2·s·cm Hg)=7.5×10~(-14)cm~3(STP)·cm/(cm~2·s·Pa)],CO_2/N_2的渗透选择性可达31.     

A Method of Analyzing Transmission Losses in Left-Handed Metamaterials

A method of analyzing transmission loss in left-handed metamaterials （LHMs） is proposed. As a demonstration of this method, transmission loss of LHMs composed of split-ring resonators （SRR） and conducting wires is studied. By means of retrieving and analyzing the effective constitutive parameters, different transmission losses as well as their origins are studied. The results show that the left-handed bandwidth is narrowed because of high loss caused by the non-zero high imaginary parts of the effective permeability and permittivity. In the effective left-handed band, the radiation loss is very low and can be neglected, and the transmission losses are the sum of the substrate loss and the ohmic loss. Moreover, when the dielectric loss tangent of the substrate is greater than 0.003, the substrate loss is higher than the ohmic loss.     

阻隔性高分子材料研究进展

介绍了阻隔性高分子复合材料的种类,发展现状及趋势,同时也给出了高分子复合材料阻隔性的测试及表征方法。     

脂双层膜上双冠醚对碱金属离子的选择性

1967年,C.J.Pederson合成了一系列大环多醚及其与碱金属离子形成的稳定配合物,其后,G.Eisenman等研究了由许多类脂物质所构成的人工双层膜上的渗透性和电导,指出大环化合物能促进碱金属阳离子的运送选择性,本工作用5种Schiff碱型双冠醚作为离子载体修饰脂双层膜,研究了它们对碱金属离子的选择性。     

乙基纤维素三甲硅基衍生物膜的结构表征与氧氮渗透行为

Characterization of ethyl cellulose and its derivative membranes EC-SiMe3 was studied by ¹H-NMR, ¹³C-NMR, solids-state ¹³C-NMR(CPMAS) and IR spectra. The permselectivity for oxygen and nitrogen of EC-SiMe3 membranes was determined.     

Transport Selectivity of a Diethylene Glycol Dimethacrylate- Based Thymine-imprinted Polymeric Membrane over a Cellulose Support for Nucleic Acid Bases

The binding mechanism between 9-vinyladenine and pyrimidine base thymine in methanol was studied with UV-visible spectrophotometric method. Based on this study, using thymine as a template molecule, 9-vinyladenine as a novel functional monomer and diethylene glycol dimethacrylate as a new cross-linker, a specific diethylene glycol dimethacrylate-based molecularly imprinted polymeric membrane was prepared over a cellulose support. Then, the resultantly polymeric membrane morphologies were visualized with scanning electron microscopy and its permselectivity was examined using thymine, uracil, cytosine, adenine and guanine as substrates. This result showed that the imprinting polymeric membrane prepared with diethylene glycol dimethacrylate exhibited higher transport capacity for the template molecule thymine and its optimal analog uracil than other nucleic acid bases. The membrane also took on higher permselectivity than the imprinted membrane made with ethylene glycol dimethacrylate as a cross-linker. When a mixture including five nucleic acid bases thymine, uracil, cytosine, adenine and guanine passed through the diethylene glycol dimethacrylate-based thymine-imprinted polymeric membrane, recognition of the membrane for the template molecule thymine and its optimal analog uracil was demonstrated. It was predicted that the molecularly imprinted membrane prepared with diethylene glycol dimethacrylate as cross-linker might be applicable to thymine assay of absolute hydrolysates of DNA or uracil assay of absolute hydrolysates of RNA in biological samples because of its high selectivity for the template molecule thymine and its optimal analog uracil.     

Modeling of Fischer-Tropsch Synthesis in a Slurry Reactor with Water Permeable Membrane

Fischer-Tropsch synthesis is an important chemical process for the production of liquid fuels and olefins. In recent years, the abundant availability of natural gas and the increasing demand of olefins, diesel, and waxes have led to a high interest to further develop this process. A mathematical model of a slurry membrane reactor used for syngas polymerization was developed to simulate and compare the maximum yields and operating conditions in the reactor with that in a conventional slurry reactor. The carbon polymerization was studied from a modeling point of view in a slurry reactor with a water permeable membrane and a conventional slurry reactor. Simulation results show that different parameters affect syngas conversion and carbon product distribution, such as the hydrogen to carbon monoxide ratio, and the membrane parameters such as membrane permeance.     

凝胶注模成型Al2O3·ZrO2泡沫陶瓷的制备与表征

采用环保无毒生物高分子明胶作胶凝剂和四甲基氢氧化铵（TMAH）为分散剂，通过凝胶注模工艺制备了相对密度为10％～35％的ZrO2增韧Al2O3（ZTA）泡沫陶瓷，对制备泡沫陶瓷的结构和性能进行了表征。SEM分析表明泡沫陶瓷由相互贯通的球形孔室构成，其孔径分布取决于泡沫陶瓷的相对密度。ZTA泡沫陶瓷抗弯强度随相对密度从10％变化到31％而相应地从3．1MPa提高至28．1MPa，渗透系数随相对密度的增大呈指数衰减。