Calorimetric approach to tetronic/water interactions

Tetronic^®comprises X-shaped copolymers formed by four poly(propylene oxide) (PPO) andpoly(ethylene oxide) (PEO) block chains bonded to an ethylene diamine centralgroup. Micellization behaviour of three representative Tetronics (T304, T904and T1307) was characterized to gain an insight into the interactions betweenthe copolymer unimers and the state of water in their solutions. The enthalpyof demicellization, recorded at 37°C in an isoperibol microcalorimeter,indicated that the process was in all cases exothermic and the enthalpy rankedin the order T1307≥T904>>T304. Micellization is entropy-driven owing tohydrophobic interactions between the PPO chains.DSC analysisshowed that the crystallization and melting peaks of the free water remainingin T304 and T904 solutions were progressively shifted toward lower temperaturesas the surfactant proportion increased, owing to a colligative effect. Boundwater corresponded to 3 water molecules per EO repeating unit. In the caseof T1307, which has longer PEO chains, a splitting of the melting peak wasobserved, one peak appearing around 0°C due to free water and anotherat –15°C due to interfacial water. As T1307 proportion raised, theenthalpy of the former decreased, whilst the enthalpy of the latter increased.In 40% T1307 solutions, interfacial water overcame the proportion of freewater; there being 1 interfacial and 3 bound water molecules per EO repeatingunit. Gaussian deconvolution of FTIR spectra also enabled to characterizethe evolution of free water as a function of Tetronic proportion. The dependenceof micellization and water interaction behaviour on Tetronics structure shouldbe taken into account to use these copolymers as drug solubilizers and micellarcarriers.     

Mg-Nd-Zr-Zn合金的制备及钕对合金组织性能的影响

在RJ-2溶剂和Be的联合保护下制备了Mg-Nd-Zr-Zn系合金. 通过对合金组织的分析, 以及Nd对组织性能影响的研究, 试制出了Nd添加量合理的Mg-Nd-Zr-Zn合金. 经过测试, 认为Nd添加量的增加提高了合金的250 ℃高温抗拉强度, 当Nd添加量超过2.8%时, 合金的高温强化作用不十分显著. Mg-Nd-Zr-Zn合金在250 ℃时的拉伸断裂方式主要是韧性断裂.     

(TiNi)_x(x=2~4)团簇结构和电子结构

从团簇角度对TiNi形状记忆合金进行了量子化学从头算研究。设计并优化了等原子比(TiNi)x(x=2~4)簇的多种可能几何结构,并对较稳定构型进行电子结构的分析。结果表明,等原子比的(TiNi)n团簇以TiNi成键为主要分子骨架,小团簇有较多能量接近的异构体,TiTi成键对能量降低有较大贡献。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Dynamic Interfacial Tension Behavior of Water/Oil Systems Containing In situ-Formed Surfactants

Time-dependent interfacial tension (IFT) has been investigated for an interfacially reactive immiscible system composed of model-acidified oil and alkaline water. The acidified oil was composed of either lauric acid or linoleic acid dissolved in n-dodecane. Drop volume tensiometry was employed to measure the interfacial tension between the two phases. In the case of lauric acid, the IFT value was found to decrease sharply with increasing alkali concentration, even at low drop formation times. In the case of linoleic acid, the IFT decrease with the drop formation time was more gradual, especially at low alkali concentration. The rate of formation of the interfacial area was also found to be dependent on alkali concentration.     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.     

Do intramolecular halogen bonds exist? Ab initio calculations and crystal structures’ evidences

Cl···O intramolecular contacts are analysed here. Hence the Cambridge Structural Database (CSD) search was performed to find five-membered Cl–C=C–C=O pseudo-rings closed through Cl···O intramolecular contacts. Such rings were analysed and it was found that some of Cl···O distances are smaller than the corresponding sum of van der Waals radii. Additionally ab initio MP2/6-311++G(d,p) calculations and AIM analyses were carried out here on 3-chloropropenal and its fluoro derivatives to deepen the nature of intramolecular Cl···O interactions, some of findings may indicate that they are attractive and stabilizing ones. This paper is dedicated to Prof. T. M. Krygowski on the occasion of his 70th birthday     

Borderline of hydrogen bonding of silanols

Two new silanols bearing very bulky silyl groups, (i-Pr₃ Si)₃SiOH and (t − BuMe₂Si)₃SiOH were prepared by peracidoxidation of their respective silanes. The X − ray crystallographic analysis revealed that (t − BuMe₂Si)₃ SiOH forms a dimeric structure with hydrogen bonding, while (i − Pr₃ Si)₃ SiOH exists as a monomer in the crystal. The effects of the size of the substituents as well as the reactivity of these silanols are discussed.     

表面能与晶体生长/溶解动力学研究的新动向

界面现象使物质在结晶过程中出现了临界现象.但最近的研究指出在物质溶解过程中,在表面能量的控制下也存在着临界现象以及尺寸效应.实验发现,当晶体自身小到一 定的程度时(通常在纳米尺度上并和临界蚀坑的大小相近),在溶解过程中其速度会自发降 低,反应被抑制乃至停止.尽管在热力学上表面能的因素可以赋予小颗粒晶体较大的溶解度 ,但表面能却也能通过对临界条件的控制而使这些微粒在动力学上不被溶解.这个发现不仅 解决了纳米颗粒在水溶液中稳定性的问题,而且还从动力学的角度解释了生物矿物选择纳米 尺度作为其基本构成单元的原因.由于表面能和晶体生长/溶解的动力学有着密切的关系, 我们可以通过对表面能的调节来修改它们的动力学速度和晶体的形貌.反过来,也可以用动力学的方法来测定表面能及表面吸附/脱附常数等.相对于常规的界面研究手段,通过生 长和溶解动力学途径所得的数据有着很好的可靠性及重复性.我们认为,晶体生长和溶解的 动力学和表面能的研究相结合,不仅为界面研究提供了新的思路和方法,而且也会推动晶体生长和材料科学的发展.