纳米储能纤维复合过滤膜的制备及性能

以静电纺丝技术制备的同轴聚甲基丙烯酸十八烷基酯(PSMA)/聚对苯二甲酸乙二酯(PET)纳米储能纤维为支撑层,经聚偏氟乙烯(PVDF)涂覆成膜和溶剂化处理,制备了一种低压高水通量的纳米储能纤维复合过滤膜(NFCM),其中以水或乙醇为凝固溶液的复合过滤膜分别记为NFCM@H2O或NFCM@EtOH.分析并讨论了不同溶剂处理方式对NFCM力学性能和表面形貌的影响,表征了膜的纯水通量和抗污性能,用扫描电子显微镜(SEM)观察了膜的横断面形貌.结果表明,PSMA/PET纳米储能纤维具有明显的吸放热行为,熔融温度和热焓值分别为36.5℃和10.7J/g,NFCM的熔融温度和热焓值分别为36℃和2.7J/g.NFCM的形貌结构、纯水通量和截留率与溶剂处理方式相关,NFCM@EtOH膜的水通量介于100~1400L/(m2·h)之间,而NFCM@H2O膜的水通量仅在40~220L/(m2·h)之间.NFCM的拉伸强度由初始0.925MPa(PVDF)提高到4.28MPa以上.NFCM中的相变材料对膜过滤性能有重要影响,并在过滤温度低于50℃时具有减缓作用.     

New ion exchange membrane derived from sulfochlorated polyether sulfone for electrodialysis desalination of brackish water

The purpose of this work is to study the desalination of brackish water using a new ion exchange membrane, made from sulfochlorated polyethersulfone (Cl‐PES), and crosslinked using aminated polyethersulfone (NH2‐PES) as a crosslinking reagent. This membrane, named ClNH2 membrane, has been obtained by reaction between Cl‐PES with 1.3 SO₂Cl groups per monomer unit and 0.2 equivalent amount of NH2‐PES. ClNH2 membrane has been characterized in terms of contact angle, transport number, intrinsic conductivity, and water uptake (as a function of temperature). Electrodialysis performances of the newly synthetized membranes have been measured using an electrodialysis cell at a laboratory scale and compared to commercial membranes. All the experiments have been performed using synthetic brackish water solutions prepared from sodium chloride salts with different concentrations (varying from 0.5 to 5.0 g/L). The concentration of different water samples obtained has been found to be below the amount recommended by the World Health Organization (WHO) for drinking water.     

混合熔盐法低温合成Sm2Ti2S2O5及其光催化分解水产氢

以TiO2、TiS2及Sm2O3为前驱体,分别加入LiCl-KCl与LiCl-CsCl的最低共熔混合物作为熔盐,在较低温度下成功合成了Sm2Ti2S2O5(STSO)颗粒。通过对比不同温度下所制备产物的X射线衍射图,首次表明STSO的热力学结晶温度在520℃左右,远低于之前报道的650℃的最低合成温度。扫描电子显微镜照片显示,采用2种混合熔盐制备的STSO都呈片状形貌;同一合成温度下,采用LiCl-CsCl熔盐制备的STSO的厚度小于LiCl-KCl所得产物。采用出射光波长大于420 nm的氙灯作为光源,在含有Na2S-Na2SO3空穴牺牲剂的溶液中,所制备的STSO颗粒表现出最高35μmol·h-1的光催化分解水产氢活性以及20 h以上的产氢稳定性。     

红外碳硫分析仪测定耐火材料中碳化硅的含量

采用红外碳硫仪测定耐火材料中碳化硅的含量,选用多元助熔剂(LHDY01),缩短了操作时间,测定结果的相对标准偏差小于1.0%(n=8)。用该方法对两种碳化硅耐火材料样品进行测定,测定结果分别为16.16%,15.64%,与化学法测定结果 (15.99%,15.38%)相符合。该方法的精确度满足化学分析要求。     

Diels-Alder reaction mechanisms of substituted chiral anthracene: A theoretical study based on the reaction force and reaction electronic flux

Quantum chemical calculations were used to study the mechanism of Diels-Alder reactions involving chiral anthracenes as dienes and a series of dienophiles. The reaction force analysis was employed to obtain a detailed scrutiny of the reaction mechanisms, it has been found that thermodynamics and kinetics of the reactions are quite consistent: the lower the activation energy, the lower the reaction energy, thus following the Bell-Evans-Polanyi principle. It has been found that activation energies are mostly due to structural rearrangements that in most cases represented more than 70% of the activation energy. Electronic activity mostly due to changes in σ and π bonding were revealed by the reaction electronic flux (REF), this property helps identify whether changes on σ or π bonding drive the reaction. Additionally, new global indexes describing the behavior of the electronic activity were introduced and then used to classify the reactions in terms of the spontaneity of their electronic activity. Local natural bond order electronic population analysis was used to check consistency with global REF through the characterization of specific changes in the electronic density that might be responsible for the activity already detected by the REF. Results show that reactions involving acetoxy lactones are driven by spontaneous electronic activity coming from bond forming/strengthening processes; in the case of maleic anhydrides and maleimides it appears that both spontaneous and non-spontaneous electronic activity are quite active in driving the reactions.     

Diversity of Strontium Nitridogermanates(IV): Novel Sr4[GeN4], Sr8Ge2[GeN4], and Sr17Ge2[GeN3]2[GeN4]2

Single crystals of three new strontium nitridogermanates(IV) were grown in sealed niobium ampules from sodium flux. Dark red Sr₄[GeN₄] crystallizes in space group P2₁/c with a = 9.7923(2) Å, b = 6.3990(1) Å, c = 11.6924(3) Å and β = 115.966(1)°. Black Sr₈Ge₂[GeN₄] contains Ge^4– anions coexisting with [Ge^IVN₄]^8– tetrahedra and adopts space group Cc with a = 10.1117(4) Å, b = 17.1073(7) Å, c = 10.0473(4) Å and β = 115.966(1)°. Black Sr₁₇Ge₆N₁₄ features the same anions alongside trigonal planar [Ge^IVN₃]^5– units. It crystallizes in P1 with a = 7.5392(1) Å, b = 9.7502(2) Å, c = 11.6761(2) Å, α = 103.308(1)°, β = 94.651(1)° and γ = 110.248(1)°.     

Intramolecular proton transfer in the isomerization of hydroxyacetone: Characterization based on reaction force analysis and the bond fragility spectrum

The mechanism of isomerization of hydroxyacetone to 2-hydroxypropanal is studied within the framework of reaction force analysis at the M06-2X/6-311++G(d,p) level of theory. Three unique pathways are considered: (a) a step-wise mechanism that proceeds through the formation of the Z-isomer of their shared enediol intermediate, (b) a step-wise mechanism that forms the E-isomer of the enediol, and (c) a concerted pathway that bypasses the enediol intermediate. Energy calculations show that the concerted pathway has the lowest activation energy barrier at 45.7 kcal mol⁻¹. The reaction force, chemical potential, and reaction electronic flux are calculated for each reaction to characterize electronic changes throughout the mechanism. The reaction force constant is calculated in order to investigate the synchronous/asynchronous nature of the concerted intramolecular proton transfers involved. Additional characterization of synchronicity is provided by calculating the bond fragility spectrum for each mechanism.     

Chitosan‐modified graphene oxide as a modifier for improving the structure and performance of forward osmosis membranes

Chitosan (CS) with good hydrophilicity and charged property was used to modify graphene oxide (GO), the obtained GO‐CS was used as a novel modifier to fabricate thin film composite forward osmosis (FO) membranes. The results revealed that the amino groups on CS reacted with carboxyl groups on GO, and the lamellar structure of the GO nanosheets was peeled off by CS, resulting in the reducing of their thicknesses. The GO‐CS improved the hydrophilicity of polyethersulfone (PES) substrate, and their contact angles decreased to 64° with the addition of GO‐CS in the substrate. GO‐CS also increased the porosity of the substrate and surface roughness of FO membrane, thereby optimizing the water flux and reverse salt flux of FO membrane. The average water flux of the FO membrane reached the optimal flux of 21.34 L/(m² h) when GO‐CS addition was 0.5 wt%, and further addition of GO‐CS to the substrate would decrease the water flux of FO membrane, and the reverse salt flux also decreased to the lowest value of 2.26 g/(m² h). However, the salt rejection of the membrane increased from 91.4% to 95.1% when GO‐CS addition increased from 0.5 to 1.0 wt% under FO mode using 1 mol/L sodium chloride (NaCl) solution as draw solution (DS). In addition, high osmotic pressure favored water permeation, and at the same concentration of DS, magnesium chloride (MgCl₂) exhibited better properties than NaCl. These results all suggested that GO‐CS was a good modifier to fabricate FO membrane, and MgCl₂ was a good DS candidate.     

Performance enhancement of a DC-operated micropump with electroosmosis in a hybrid nanofluid: fractional Cattaneo heat flux problem

The purpose of this investigation is to theoretically shed some light on the effect of the unsteady electroosmotic flow (EOF) of an incompressible fractional second-grade fluid with low-dense mixtures of two spherical nanoparticles, copper, and titanium. The flow of the hybrid nanofluid takes place through a vertical micro-channel. A fractional Cattaneo model with heat conduction is considered. For the DC-operated micropump, the Lorentz force is responsible for the pressure difference through the microchannel. The Debye-Hükel approximation is utilized to linearize the charge density. The semi-analytical solutions for the velocity and heat equations are obtained with the Laplace and finite Fourier sine transforms and their numerical inverses. In addition to the analytical procedures, a numerical algorithm based on the finite difference method is introduced for the given domain. A comparison between the two solutions is presented. The variations of the velocity heat transfer against the enhancements in the pertinent parameters are thoroughly investigated graphically. It is noticed that the fractional-order parameter provides a crucial memory effect on the fluid and temperature fields. The present work has theoretical implications for biofluid-based microfluidic transport systems.