Unknown residual solvents identification in drug products by headspace solid phase microextraction gas chromatography-mass spectrometry

Summary A sensitive headspace SPME method for the extraction of residual solvents from pharmaceutical products has been developed and optimized. It was found that minimizing sample and headspace volume has a beneficial effect on extraction efficiency. At the same time the method reproducibility was seriously affected by reducing sample and headspace volume. The added air volume was not found to have any significant influence on method sensitivity. The method showed reproducibilities of less than 10% and detection limits as low as 1 ppb for benzene and dichloromethane. The headspace SPME method is around 1000 times more sensitive than static headspace. The optimized parameters were headspace volume 1.5 mL, sample volume 10 μL, and extraction time 30 min. The method was successfully applied to the identification of unknown residual solvents in three different proprietary active drug substances and was successfully applied to the confirmation of the presence of benzene in a proprietary drug substance. Presented at Balaton Symposium '01 on High-Performance Separation Methods, Siófok, Hungary, September 2–4, 2001     

The relationship between the linear (oscillatory) and nonlinear (steady-state) flow properties of a series of polymer and colloidal systems

The Cox-Merz empirical relationship between the linear (oscillatory) and nonlinear (steady-state) viscosities has been shown to be valid for many polymeric systems. Here, we present an equivalent expression to relate the linear (G) and nonlinear (N ₁) elastic properties of viscoelastic systems. Like the Cox-Merz relationship, it uses a combination of elastic and viscous parameters. The modified form of the storage modulus is then equivalent to the Cox-Merz complex viscosity. It can be used to correlate with (half) the normal force at numerically equal circular frequency and shear rate, respectively.This new expression and the Cox-Merz rule are tested for a range of polymeric and colloidal systems. It is found that both expression work for the polymeric systems considered, but fail for the colloidal systems. In the latter, the steady state values of viscosity and elasticity are consistently low, and replacing them by the complex viscosity and our new elastic expression only makes matters worse.For polymer systems, we suggest this is a general but not universal observation, since we are aware of exceptions to the rule that polymeric systems obey the Cox-Merz rule for viscosity and our rule for elasticity. For colloidal systems we find that neither rule is obeyed for any of our systems.     

A New Criterion for Brittle-Ductile Transition of Polymer Blends

The T_c criterion was first used by S. Wu for characterizing the brittleductile (B-D) transition of N6/EPDM blends. But in this paper, a new criterion which is based on the stress analysis of blends is proposed to characterize the B-D transitions of blends, namely, A criterionV_(fc) and d_c are the critical volume fractions and particle size of dispersed particles in blends, respectively. For given blends, A is independent of the morphology of dispersed phase and is only the characteristic parameter of matrix. The B-D transitions of different blends, including polar N6/EPDM blends, nonpolar PP/EPDM blends and PE/CaCO_3 composites, were manipulated with A criterion and satisfactory results were obtained. In addition, a new master curve for the impact strength of PP/EPDM blends versus V_f~2/d was obtained. The results showed that A criterion is more suitable than T_c criterion for characterizing the B-D transition of blends.     

毛细管气相色谱法测定兰索拉唑中有机溶剂残留量

以N,N-二甲基甲酰胺(DMF)为溶剂,丁酮为内标,采用PV-101毛细管色谱柱 (30 m×0．22 mm),氢火焰离子化检测器,建立兰索拉唑中五种有机溶剂甲醇、乙醇、丙酮、二氯甲烷、乙酸乙酯残留量的定量分析方法。五种有机溶剂检出限分别为0．002 4％,0．002 4％, 0．001 2％,0．000 6％,0．000 6％;在10-1000 mg·L-1浓度范围内,各组分线性关系良好;对应的平均回收率分别为100．8％±3．6％,102．1％±2．3％,99．97％±4．1％,99．63％±2．7％, 102．3％±3．5％。     

Application of Liquid Crystalline NMR Solvents to a Mixture of Ketones

A series of dilute liquid crystalline solvents are used to study the effect of slight anisotropy caused by partial alignment on chemical shift and residual dipolar coupling (RDC) in small molecules. The residual dipolar couplings between protons in solutes are found to be almost independent of the local environment. It is also found that the chemical shift does not change over the concentration range observed. A linear relationship between residual dipolar coupling and liquid crystal concentration is observed at relatively low concentrations, but is severely violated at high concentrations.     

ELECTRORHEOLOGICAL PROPERTIES OF POLYANILINE/PUMICE COMPOSITE SUSPENSIONS

Electrorheological （ER） properties of polyaniline （PAni）, pumice and polyaniline/pumice composites （PAPC） were investigated. Polyaniline and PAni/pumice composite were prepared by oxidative polymerization. PAni/pumice particlesbased ER suspensions were prepared in silicone oil （SO）, and their ER behavior was investigated as a function of shear rate, electric field strength, concentration and temperature. Sedimentation stabilities of suspensions were determined. It has been found that ER activity of all the suspensions increases with increasing electric field strength, concentration and decreasing shear rate. It has shown that the suspensions have a typical shear thinning non-Newtonian viscoelastic behavior. Yield stress of composite suspensions increased linearly with increasing applied electric field strength and with concentrations of the particles. The effect of high temperature on ER activity of purrfice/silicone oil systems was also investigated.     

Quantitative evaluation of stress distribution in bulk polymer samples through the comparison of mechanical behaviors between giant single‐crystal and semicrystalline samples of poly(trans‐1,4‐diethyl muconate)

The Raman shift and crystallite modulus were measured under the application of tensile force for a giant single crystal and a series of uniaxially oriented semicrystalline samples of poly(trans‐1,4‐diethyl muconate) (polyEMU). The apparent Raman shift factor α^app or a vibrational frequency shift per 1 GPa tensile stress was higher for the semicrystalline samples with lower crystallinity or lower bulk modulus. The apparent crystallite modulus E or Young's modulus along the chain axis in the crystalline region was not constant but varied remarkably between the giant single crystal and semicrystalline samples. A systematic change in α^app and E among the polyEMU samples with different preparation history could be interpreted quantitatively on the basis of a mechanical series parallel model consisting of crystalline and amorphous phases. The origin of different E and α^app was speculated to be a stress concentration on the taut‐tie chain contained as a parallel crystalline component in the mechanical model. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 444–453, 2003     

Investigation of Cd(II), Pb(II) and Cu(I) complexation by glutathione and its component amino acids by ESI-MS and size exclusion chromatography coupled to ICP-MS and ESI-MS

The elucidation of structures of glutathione (GSH) complexes play an important role in the fundamental understanding of biochemical pathways of metal ion deactivation in plants. This article attempts to feature key studies for stoichiometry of metal complexes with glutathione and its constituent amino acids to obtain a better understanding of the different metal affinities of the complexation sites of glutathione. The SEC-ICP-MS experiments have indicated that oxidation process of glutathione was accelerated by metal ion presence in following order Cu⁺, Pb²⁺ and Cd²⁺. The redox activity of metal ions was confirmed by ESI-MS experiments, which allowed to observe formation of glutathione disulphide (GSSG) in time. The stoichiometry of Cd²⁺, Cu⁺ and Pb²⁺ complexes with GSH was defined by observing the isotope pattern of investigated metals and hydrogen loss or transfer during binding. The complexes with metal bound to sulphur of 1:1 and 1:2 stoichiometry were found in case of cadmium and lead. The number of hydrogen atoms lost during metal binding and the SEC-ESI-MS results allowed to elucidate that copper is bound by GSSG in ratio 1:1 and 1:2. Additionally, size exclusion chromatography coupled to electrospray MS allowed to differentiate more stable complexes from weak ones that could be created in the gas phase.     

The effects of alternative stress on the cell membrane deformability of chrysanthemum callus cells

The effects of alternative stress, which was generated through a strong sound field apparatus set up in our lab, on cultured chrysanthemum callus cells were studied. Meanwhile we measured the deformability of chrysanthemum cell membranes and studied the influence of the cytoskeleton after the treatment of colchicine using micropipette aspiration technique. Based on our experimental results, we found that the deformability of cell membrane decreased in stress condition. However, the effect disappeared after the treatment of cytochalasin. Therefore, we thought that the reason on the deformability of cells decreasing was the microfilament rearranging and consequently the cells becoming more rigid under the alternative stress.     

顶空气相色谱法测定卷烟包装材料中的溶剂残留

采用顶空气相色谱法对卷烟包装材料中溶剂残留(乙酸乙酯、乙酸丁酯、甲苯、乙苯等)进行分析,并讨论了各种条件对测定的影响。分析结果表明,该方法对上述4种溶剂残留的检出限范围分别为乙酸乙酯0.4~120 mg.L-1,甲苯0.4~120 mg.L-1,乙酸丁酯1.2~600 mg.L-1,乙苯0.5~150 mg.L-1,测定结果的相对标准偏差为2.5%~3.1%,样品的回收率为90%~95%;方法用于卷烟包装材料实样中溶剂残留的分析。