Underpotential deposition of tin(II) on a gold disc electrode and determination of tin in a tin plate sample

This work describes a study of the underpotential deposition (UPD) of Sn²⁺ on a polycrystalline gold disc electrode using cyclic voltammetry (CV) and chronocoulometry (CC). Sn²⁺ ions showed well-defined peaks from UPD and UPD stripping (UPD-S) in 1 mol/L HCl solutions, while bulk deposition (BD) and BD stripping (BD-S) of the ions were also observed. The measured UPD shifts, E_UPD, between the UPD-S and the BD-S peaks were more than 200 mV. The UPD charge and the surface coverage of tin were measured by CC. A new method for determining Sn²⁺ was therefore developed, based on the excellent electrochemical properties of the Au/Sn UPD system. A plot of the UPD-DPASV (differential pulse anodic stripping voltammetry) signal versus the Sn(II) concentration was obtained for [Sn(II)] of 1.98×10^–7 to 3.64×10^–5 M. The method developed here has been applied to determine the tin in a tin plate sample.     

Mg-Nd-Zr-Zn合金的制备及钕对合金组织性能的影响

在RJ-2溶剂和Be的联合保护下制备了Mg-Nd-Zr-Zn系合金. 通过对合金组织的分析, 以及Nd对组织性能影响的研究, 试制出了Nd添加量合理的Mg-Nd-Zr-Zn合金. 经过测试, 认为Nd添加量的增加提高了合金的250 ℃高温抗拉强度, 当Nd添加量超过2.8%时, 合金的高温强化作用不十分显著. Mg-Nd-Zr-Zn合金在250 ℃时的拉伸断裂方式主要是韧性断裂.     

GC-MS法测定拟除虫菊酯类农药残留

介绍了蔬菜水果中8种拟除虫菊酯农药残留的快速检测方法。采用选择离子-气相色谱-质谱联用(SIM-GC-MS)方式,依据保留时间和特征离子丰度比对农药进行确证。此方法可以在13.50 min内快速检测拟除虫菊酯农药残留,并可同时定性和定量,用于蔬菜水果等多种作物的检验。回收率在75%~108%间,相对标准偏差<10%,检出限为0.000 90~0.008 4 mg.kg-1。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Process study of thermal plasma chemical vapor deposition of diamond,part II: Pressure dependence and effect of substrate pretreatment

The effect of pressure during thermal plasma chemical vapor deposition of diamond films has been investigated for a pressure range from 100 to 760 Torr. The maximum growth rate in our experiments occurs at 270 Torr for substrate temperatures around 1000°C. The existence of an optimum pressure for diamond deposition may he related to the balance between generation and recombination of atomic hydrogen and carbon-containing active species in front of the substrate. To estimate the concentrations of atomic hydrogen and methyl radicals under thermal plasma conditions, calculations based on thermodynamic equilibrium have been performed. This approximate evaluation provides useful guidelines because rapid diffusion results in a near frozen chemistry within the boundary layer. The effect of substrate pretreatment on diamond deposition depends on the type of substrate used. Two growth modes have been observed-layer growth and island growth of diamond crystals on various substrates. Screw dislocations have been observed in diamond deposition in thermal plasmas, and defects such as secondary nucleations are more concentrated along (III) directions than along (100) directions.     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.     

Deposition of Oral Bacteria and Polystyrene Particles to Quartz and Dental Enamel in a Parallel Plate and Stagnation Point Flow Chamber

The aim of this paper is to determine to what extent (i) deposition of oral bacteria and polystyrene particles, (ii) onto quartz and dental enamel with and without a salivary conditioning film, (iii) in a parallel plate (PP) and stagnation point (SP) flow chamber and at common Peclet numbers are comparable. All three bacterial strains showed different adhesion behaviors, and even Streptococcus mitis BMS, possessing a similar cell surface hydrophobicity as polystyrene particles, did not mimic polystyrene particles in its adhesion behavior, possibly as a result of the more negative ζ potentials of the polystyrene particles. The stationary endpoint adhesion of all strains, including polystyrene particles, was lower in the presence of a salivary conditioning film, while also desorption probabilities under flow were higher in the presence of a conditioning film than in its absence. Deposition onto quartz and enamel surfaces was different, but without a consistent trend valid for all strains and polystyrene particles. It is concluded that differences in experimental results exist, and the process of bacterial deposition to enamel surfaces cannot be modeled by using polystyrene particles and quartz collector surfaces.     

化学蒸气沉积硅氧化合物调变HZSM－5沸石的研究

本文研究了正硅酸乙酯分别在无胺法和有胺法制得的ＨＺＳＭ－５沸石上的沉积过程，并用吸附，ＮＨ３－ＴＰＤ及异丙醇探针反应等手段表征了沉积后的样品，发现沉积仅在外表面上进行，可使孔口变小但不影响孔道内性质，显示有对于二甲苯分子的择形吸附能力，且在甲苯甲醇烷基化反应和二甲苯异构化反应中表现出良好的择形催化性能．     

电沉积羟基磷灰石/TiO2复合涂层

结合强度;电沉积羟基磷灰石/TiO2复合涂层