基于反射和透射光谱的氢化非晶硅薄膜厚度及光学常量计算

采用紫外-可见透射光谱仪测量了对靶磁控溅射沉积法制备的氢化非晶硅( a-Si:H)薄膜的透射光谱和反射光谱.利用T/(1-R)方法来确定薄膜的吸收系数,进而得到薄膜的消光系数;通过拟合薄膜透射光谱干涉极大值和极小值的包络线采确定薄膜折射率和厚度的初始值,并利用干涉极值公式进一步优化薄膜的厚度值和折射率;利用柯西公式对得...     

微波椭偏法测量不透明材料的厚度

在传统的激光椭偏法测量厚度的基础上,用微波取代激光测量了不透明材料的厚度.分析了偏转角及反射干扰产生的误差,并提出了修正方法.测量结果表明:该方法可以比较精确地测量铝板和塑料板的厚度;由于散射的影响,表面磨砂的有机玻璃板的厚度测量误差很大.     

非接触法自动测量薄膜厚度

根据白光等厚干涉原理,基于单片机改造的迈氏干涉仪用于自动测量透明薄膜厚度,采用非接触性测量法。当迈克尔逊干涉仪静镜形成的虚像与动镜相交所成的夹角很小时,在光屏上看到彩色干涉条纹,插入薄膜后,光程差改变,彩纹消失。步进电机带动微调手轮转动,当彩纹再次出现,即可得出透明薄膜厚度。     

制备均一性靶丸过程中的影响因素

在激光聚变实验中,高球形度、高厚度均一性的靶丸经常通过乳液微封装方法来制备。利用T.Norimatsu的模型研究在靶丸制备过程中,界面间表面张力、油相粘度、壳层尺寸、壳层厚度的影响。结果显示:较大的表面张力,较小的壳层尺寸,会使胶囊具有更好的均一性。当外部变形形式不同的时候,油相的粘度对于壳层均一性会有不同作用。     

胶粘光学元件的热应力和变形分析

由于光学元件和装配材料热膨胀系数的不匹配,在环境温度变化时会导致光学元件中产生热应力,并引起光学元件表面产生变形,影响光学系统的性能.针对光学元件的粘接固定方式讨论了连续边缘粘接引起的热应力和变形的分析方程,得出连续边缘粘接无热厚度的解析方程.采用有限元分析软件对胶粘固定光学元件进行了建模和热应力分析,得出光学元件边界...     

宽光谱膜厚监控系统中光谱实时测量技术研究

 在宽光谱膜厚监控系统中,利用光栅光谱仪分光,线阵CCD接收,完成光谱的一次性快速扫描来控制膜层厚度,达到实时监控的要求。而系统光谱扫描的准确性,直接影响膜厚实时监控的有效性。为了得到准确的光谱信息,首先确定CCD像素和光波波长的对应关系,基于特征谱线的离散关系,采用最小二乘拟合法建立了光谱标定函数,经实验,标定波长均方根误差为0.037 nm;对于CCD实时输出的光谱监控信号,利用小波阈值优化算法抑制信号中的随机噪声,保留了光谱信号的细节成分,峰值误差的最大值为1.0%,峰位误差的最大值为0.3%,满足了监控中光谱分辨率的要求。     

不同厚度的活性层及阴极的改变对聚合物太阳电池性能的影响

以MEH-PPV(poly(2-methoxy-5-(2'-ethylhexoxy)-1,4-phenylene vinylene))为电子给体材料, PCBM(1-(3-methoxycarbonyl)-propyl-1-1-phenyl-(6,6)C₆₁)为电子受体材料, 制成了共混体系太阳电池.研究了不同厚度活性层对太阳电池性能的影响.结果表明, 活性层厚度为100 nm时,太阳电池具有最佳性能.活性层厚度的增加,增大了光生电荷的复合,减少了太阳电池的填充因子,从而减少了太阳电 关键词： 太阳电池 厚度 电极 性能     

Analysis of ultrasonic guided waves propagating in long bones and cortical thickness based on time-frequency methods

The ultrasonic signals in long bones contain multiple guided modes which are mutual superposed.The velocities of guided waves in long bones are very sensitive to cortical thickness (CTh).In this paper,Hilbert-Huang transform(HHT) was proposed to analyze multi-mode guided waves,which can decompose superposed waves into many independent modes.Then the group velocity of each mode was obtained at corresponding frequency,which was compared with the results of short time Fourier transform(STFT).The CTh was also obtained by comparing with the theoretical calculation.The results showed that the experimental determined thickness was in agreement with the actual CTh,indicating that measuring the velocity of the guided mode can be used to estimate the CTh.The HHT is an effective method to identify multimode guided waves.     

A new probe of neutron skin thickness

The correlation between neutron-to-proton yield ratio (R_np) and neutron skin thickness (δ_np) in neutron-rich projectile induced reactions is investigated within the framework of the Isospin-Dependent Quantum Molecular Dynamics (IQMD) model. The density distribution of the Droplet model is embedded in the initialization of the neutron and proton densities in the present IQMD model. By adjusting the diffuseness parameter of neutron density in the Droplet model for the projectile, the relationship between the neutron skin thickness and the corresponding R_np is obtained. The results show strong linear correlation between R_np and δ_np for neutron-rich Ca and Ni isotopes. It is suggested that R_np may be used as an experimental observable to extract δ_np for neutron-rich nuclei, which is very interesting in the study of the nuclear structure of exotic nuclei, the equation of state (EOS) of asymmetric nuclear matter and neutron-rich matter in astrophysics, etc.     

梯度磁场中薄膜厚度梯度的形成机理

借助于基片下方放置的磁铁，在溅射的放电空间中引入了纵向的梯度磁场，辉光放电时，其外貌发生了显著的收缩，由此沉积的薄膜在平面内存在明显的厚度梯度，用磁场中带电粒子的运动理论解释了此种薄膜的形成机制。