Dependence of effective screening length in granular columns on bead and silo sizes and their ratio

Apparent mass measurements at the bottom of silos have been carried out. An important parameter in the Janssen model known as the effective screening length has been investigated for different bead and silo diameters as well as of their ratios. It is found that the effective screening length augments with the grain diameter d in addition to the granular column size. It is also revealed that λ exhibits stronger correlation with the bead diameter than that of the silo. This phenomenon is attributed to the reduced-shielding of the vertical stresses to the horizontal ones.     

Contact effect in the dynamic electron transport of a two-probe mesoscopic conductor

Based on the self-consistent electron dynamic transport theory for multi-probe mesoscopic systems, we calculate the distribution of internal potential, charge density, and ac conductance of a two-probe mesoscopic conductor with wide trapezoid reservoirs, and study the contact effect. The results show that including the contact effect can make a significant difference to the frequency-dependent electron transport properties. In the nonzero frequency case, the internal potential and the charge density are complex with extremely small imaginary parts. Importantly, the imaginary part of the charge density gives rise to a real ac conductance (admittance), which corresponds to the charge-relaxation resistance.     

High-performance 4H-SiC junction barrier Schottky diodes with double resistive termination extensions

4H-SiC junction barrier Schottky (JBS) diodes with a high-temperature annealed resistive termination extension (HARTE) are designed, fabricated and characterized in this work. The differential specific on-state resistance of the device is as low as 3.64 m ·cm2 with a total active area of 2.46×10-3 cm2 . Ti is the Schottky contact metal with a Schottky barrier height of 1.08 V and a low onset voltage of 0.7V. The ideality factor is calculated to be 1.06. Al implantation annealing is performed at 1250℃ in Ar, while good reverse characteristics are achieved. The maximum breakdown voltage is 1000 V with a leakage current of 9×10-5 A on chip level. These experimental results show good consistence with the simulation results and demonstrate that high-performance 4H-SiC JBS diodes can be obtained based on the double HARTE structure.     

渐开线斜齿轮非稳态弹流润滑数值模拟研究

建立了渐开线斜齿轮啮合的弹流润滑计算模型,将斜齿圆柱齿轮啮合的齿面接触等效为有限长线接触的弹流润滑问题.考虑斜齿轮啮合的实际因素,将斜齿轮啮合过程中的等效曲率半径和齿面载荷的变化反映到弹流润滑计算模型中,应用统一Reynolds方程方法求得轮齿在1个完整啮合周期内的瞬时弹流润滑数值解.结果表明：斜齿轮啮合线上各点处的膜厚、压力均有较大不同,各接触点处的油膜厚度受综合曲率半径的影响较大;斜齿轮传动非稳态效应相对较弱;小齿轮齿根附近和节点位置处润滑状态较差;适当增大压力角可以改善齿轮的润滑.     

冠脉支架纵向柔顺性数值模拟

柔顺性是冠脉支架重要的力学性能之一。本文针对一种具有非对称结构的冠脉支架,利用有限元方法深入研究与弯曲方向有关的支架柔顺性,在柔顺性数值模拟中使该支架获得较大的弯曲曲率并且考虑了接触因素。在一个周期结构内的多个弯曲方向上分别进行模拟,详细研究了支架抗弯刚度的各向异性。计算结果显示：在支架自接触现象发生前,支架的柔顺性表...     

HC轧机辊间接触与辊系变形的Taylor级数多极边界元数学规划解析

分析HC轧机辊间接触分布和辊系弹性变形对于改善辊间压力分布状态,减少轧故褂檬倜案纳瓢逍畏浅Ｖ匾?醯捎诩扑懔亢艽?使用传统数值方法(有限元法或边界元法)分析辊间接触和辊系变形是非常困难的.本文描述了一种基于点-面接触模型的三维弹性接触Taylor级数多极边界元法,给出了数学规划解析方法,适合大规模弹性接触问题的求解....     

微小深度尺寸现场测量系统的研究

针对目前微小深度尺寸现场测量难的问题,设计开发了一种基于光切原理的现场视觉检测系统,应用自主开发的基于Directshow和VC++的图像采集和处理软件,能快速、准确地检测被测工件表面的微小深度尺寸.实验结果表明,该测量系统景深达700μm,可测量20～990μm的深度尺寸,系统整体的测量不确定度优于3％;在200～5...     

气体凝聚团簇源中团簇形成的DSMC研究

利用直接模拟蒙特卡洛方法(DSMC) ,模拟了气体凝聚团簇源的引出口尺寸和中心位置不同的条件下,Cu团簇的尺寸分布以及模拟了随着时间的增长,腔内团簇数目的变化.模拟结果表明:引出口的直径越大,产生大团簇的比例越小;在引出口的直径相同的情况下,引出口的中心位置偏离坐标原点比在原点产生的大团簇的比例要大;随着时间的增长,腔内团簇数目先变多后变少.     

含遮蔽抛射沉积模型的有限尺寸效应

含遮蔽抛射沉积模型是在抛射沉积(BD)模型的基础上考虑了粒子以一定的角度分布倾斜入射的情况.本文应用外推方法确定了大尺寸极限下含遮蔽抛射沉积模型的各标度指数,讨论了该模型的有限尺寸效应及其标度性质.从模拟结果可以看出含遮蔽BD模型的有限尺寸效应与BD模型有所不同,遮蔽这种非局域作用可以显著地改变BD模型的标度性质. 关键词： 遮蔽效应 抛射沉积模型 有限尺寸效应 动力学标度     

拉盖尔高斯涡旋光束的传输

针对拉盖尔高斯涡旋光束,推导了其传输后目标平面上光电场的解析表达式,理论研究表明,传输一段距离后, 对于拉盖尔高斯光束的光斑大小的描述,高斯光斑尺寸已经不再适用.如果采用光强最亮处的半径来表示目标平面上的光斑大小则比较方便. 除了传输中的衍射导致光束展宽以外, 横截面上光束的相位分布也发生了独特的变化. 等相位线由原来的射线转化为弧线,拓扑电荷数为正时,弧线朝顺时针方向弯曲,拓扑电荷数为负时,弧线朝逆时针方向弯曲. 关键词： 涡旋光束 传输 光斑尺寸 相位分布