The structure and electrochemical characteristics of La0.67Mg0.33 (Ni0.8Co0.1Mn0.1) x (x=2.5–5.0) multiphase alloys for nickel-metal hydride batteries

This paper presents results concerning structure and electrochemical characteristics of the La_0.67Mg_0.33 (Ni_0.8Co_0.1Mn_0.1) _x (x=2.5–5.0) alloy. It can be found from the result of the Rietveld analyses that the structures of the alloys change obviously with increasing x from 2.5 to 5.0. The main phase of the alloys with x=2.5–3.5 is LaMg₂Ni₉ phase with a PuNi₃-type rhombohedral structure, but the main phase of the alloys with x=4.0–5.0 is LaNi₅phase with a CaCu₅-type hexagonal structure. Furthermore, the phase ratio, lattice parameter and cell volume of the LaMg₂Ni₉phase and the LaNi₅ phase change with increasing x. The electrochemical studies show that the maximum discharge capacity increases from 214.7 mAh/g (x=2.5) to 391.1 mAh/g (x=3.5) and then decreases to 238.5 mAh/g (x=5.0). As the discharge current density is 1,200 mA/g, the high rate dischargeability (HRD) increases from 51.1% (x=2.5) to 83.7% (x=3.5) and then decreases to 71.6% (x=5.0). Moreover, the exchange current density (I ₀) of the alloy electrodes first increases and then decrease with increasing x from 2.5 to 5.0, which is consistent with the variation of the HRD. The cell volume reduces with increasing x in the alloys, which is detrimental to hydrogen diffusion and accordingly decreases the low-temperature dischargeability of the alloy electrodes.     

SDS/n－C5H11OH/n－C7H16/H2O体系中W/O－BI微乳液界面电性质

In the system of SDS/n-C5H11OH/n-C7H16/H2O with the weight ratio of SDS/n-C5H11OH/H2O system at5.0/47.5/47.5, the upper phase of the system was W/O microemulsion, and the lower phase was the bicontinuous microemulsion. When the n-heptane content was less than 1%, with the increase of the n-heptane content, the capacitance (Co, Cod) in the upper phase (W/O) dropped, the capacitance (CB1, CBld) in the lower phase (BI) raised. At the same time, the W/O-BI inteffacial potential (ΔE), capacitance (Ci), and charge-transfer current (ict) decreased.After the n-heptane content reached 1%, with the increase of the n-heptane content, ΔE, Ci and ict demonstrated no significant change.     

胆酸钠与支撑磷脂双层膜作用的电化学研究

采用电化学方法研究胆酸钠(NaC)与s-BLM的相互作用, 并结合实验结果对NaC与s-BLM的作用机理进行了讨论.     

氟的离子选择电极瞬时电位法测定

研究了氟离子选择电极瞬时电位分析法，其检出限和Nernst响应下限均低于传统电位分析法，空白液切换到试液时瞬时电位达到稳定的峰电位Vp比传统电位法的响应快得多，可以实现小体积试液的快速准确分析；用该法测定了自来水和矿泉水中氟的含量；利用校正曲线的截距和检出限计算了LaF3的溶度积，在0.1mol/L KNO3介质中Ksp(LaF3)=10^-28.45，在0.001mol/L柠檬酸钠＋HAc-NaAc缓冲液（pH=5.50，离子强度I＝0.10mol/L)介质中溶度积K′sp(LaF3)=10^-26.26；据此，计算得柠檬酸与La^3 络合物的稳定常数K1=10^5.46和K2=10^3.99；用离子水合吉氏自由能ΔGh(F^-,g)解释了不同浓度F^-试液瞬时电位的跃迁时间。     

Dissociation quotients of succinic acid in aqueous sodium chloride media to 225°C

The first and second molal dissociation quotients of succinic acid were measured potentiometrically with a hydrogen-electrode, concentration cell. These measurements were carried out from 0 to 225°C over 25° intervals at five ionic strengths ranging from 0.1 to 5.0 molal (NaCl). The dissociation quotients from this and two other studies were combined and treated with empirical equations to yield the following thermodynamic quantities for the first acid dissociation equilibrium at 25°C: log K_1a=–4.210±0.003; H _1a ⁰ =2.9±0.2 kJ-mol^–1; S _1a ⁰ =–71±1 J-mol^–1-K^–1; and C _p1a ⁰ =–98±3 J-mol^–1-K^–1; and for the second acid dissociation equilibrium at 25°C: log K_2a=–5.638±0.001; H _2a ⁰ = –0.5±0.1 kJ-mol^–1; S _2a ⁰ =–109.7±0.4 J-mol^–1-K^–1; and C _p2a ⁰ = –215±8 J-mol^–1-K^–1.     

SYNTHESIS AND PROPERTIES OF SULFONATED POLY（ARYLENE ETHER） CONTAINING TRIPHENYL METHANE MOIETIES FROM ISOCYNATE MASKED BISPHENOL

A novel sulfonated poly（arylene ether） containing triphenylmethane moieties was synthesized by the sulfonation of a designed parent polymer using chlorosulfonic acid as sulfonation agent. The sulfonation took place at the para position of the pendant phenyl rings because of the specially designed parent polymer. The position and degree of sulfonation were characterized by ^1H-NMR and elemental analysis. The sulfonated polymers are highly soluble in common organic solvents, such as dimethylsulfoxide, N,N＇-dimethylacetamide, dimethylformamide, ethylene glycol monomethyl ether, and can be readily cast into tough and smooth films from solutions. The films showed good thermal and hydrolysis stabilities. Moreover, Fenton＇s reagent test revealed that the films exhibited superior stability to oxidation. The proton conductivities of the films were comparable with Nation 117 under same conditions. The membrane electrode assembly （MEA） prepared with the asmade film （706 EW, 100 μm dry thickness） shows better cell performance than Nation 115-MEA in the whole current density range.     

Silver Selective Electrode Based on Hybrid Mesoporous Silica (MCM‐41) Modified Material

A silver selective electrode based on TEPQA‐MCM‐41 material was developed and used for the selective determination of Ag⁺ ion in various samples. The effect of various plasticizers i. e. dimethyl phthalate (DMP), Tris(ethylhexyl)phosphate (TEP), bis‐(2‐ethylhexyl)sebacate (BEHS), bis‐(2‐ethylhexyl)adipate (BEHA) was investigated. The electrode of the composition of 2 : 1 : 77 : 12 : 8 (w/w, %) of TEPQA‐MCM‐41 : NaTPB : Graphite powder : paraffin oil : DMP respectively, works satisfactorily in a wide concentration range of 1.3×10^?9 M–1.0×10^?1 M for Ag⁺ ion with a lower detection limit (LOD) of 1.0×10^?9 M and has Nernstian slope of 63.4 1 mV/decay. The electrode can be used in a pH range of 2.3 to 6.7 for a period of 3 months without any divergence in potential response. The selectivity coefficient calculated by fixed interference method indicates the high selectivity of the electrode towards Ag⁺ ion over other tested cations.     

Recent development of non-faradaic potentiometry

Non-faradaic potentiometry has been plagued by a great many fundamental errors and a lack of conceptualization. Of greatest concern is the second Nernst equation hiatus. Potentiometry may be generally classified as faradaic and non-faradaic. The former deals with the redox reactions using the Nernst equation to explain the potential origin. The latter deals with the non-redox reactions using the Boltzmann and modified Boltzmann equations to explain the origin of electrode potential. Redox faradaic potentiometry has been well described in the textbooks. However, non-faradaic potentiometry has been almost completely neglected in the literature. Many well-known electrodes, such as the pH glass electrode, common reference electrodes, and ion selective electrodes (ISE) have been mistakenly interpreted as redox reactions or ion exchange reactions. New theories and experimental results show their mechanisms to be non-faradaic in nature. Furthermore, the reaction mechanisms for ISE have been confused in textbooks with redox reactions and the Nernst equation. The ISE potentials originating from adsorption of ions or charged particles based on surface charge density will be explained using the double and counterion triple layers concept. The new counterion triple layer concept may be applied to the potential development of sensors. The reason for a new concept, theory, or mechanism is to better explain the phenomena. Examples will be given of how our new concept explains the capacitor, counterion triple layer, surface adsorbed layers interactions, and the interface structure. We will also discuss the new sensor development based on the new adsorption concept. For the first time a new type of Ag/AgCl reference electrode for non-faradaic potentiometry will be presented, one without a liquid junction and with a Pt wire instead of a salt bridge. They will help open up a new horizon for electrochemical sensor research and may be used under unusual conditions, such as high temperature and high pressure, stirring, etc.     

Vergleichende Messungen des Zeta-Potentials von Faserstoffen durch Elektroosmose und Strömungsstrom/Strömungspotential

An apparatus for the determination of zetapotential is described, which allows measurement of both streaming potential and streaming current as well as electroosmosis with one and the same fiber diaphragm with various electrodes (calomel, Ag/AgCl, palladium). Measurements with glass fibers, fibers of polyacrylonitrile and of polyester, and with cellulose pulp show that identical values for the electrokinetic parameters are obtained independent of voltage applied during electroosmosis resp. pressure difference during streaming measurements. This allows the conclusion that the zetapotential in dilute electrolyte solution is here an unequivocally determinable figure.

Herrn Prof. Dr.R. C. Schulz mit den herzlichsten Glückwünschen zum 65. Geburtstag gewidmet.