硝酸活化高灵敏度离子选择性电极法测定氟

先在0．5 mol·L-1硝酸介质中活化氟离子选择性电极,再在含硝酸的总离子强度调节混合液(TISAM)中测定氟,线性范围为1×10-7～1×10-2mol·L-1,检出限为1．9μg·L-1。该方法应用于绿茶饮料、水、牛奶中痕量氟的测定,结果的RSD小于4．8％,回收率在96．1％至100．2％之间,对氟离子选择性电极在硝酸介质中的活化机理作了阐述。     

Reactions of Hydroxyazolidines with π-Donor Heterocycles. 3. Reaction of 1-Acetyl-5-hydroxypyrazolidines with Oxindoles

The reaction of oxindoles with 5-hydroxypyrazolidines on the surface of potassium fluoride-modified alumina leads to 3-(5-pyrazolidinyl)oxindoles. The structure of these products was studied.     

聚偏氟乙烯的氯化改性

研究了聚偏氟乙烯 (PVDF)自由基引发的氯化反应。考察了各种因素 ,如氯化剂、引发剂的种类及浓度 ,反应介质、反应温度和反应时间的影响 ,确定了合成氯化PVDF的最佳反应条件。采用碱熔法测定氯含量 ,用HNMR进行了结构表征 ,并用溶度参数法、接触角法、DTA TG等方法对PVDF氯化前后的溶解性、附着力、熔点等性能进行了测试。结果表明 ,氯原子成功地引入到了PVDF上 ,当氯含量增加到 8 3 %时 ,氯化PVDF的熔点由 1 63℃降至 1 3 0℃左右 ,附着力也有了明显的改善 ,与水的接触角由 90°降至 5 4°,由不溶于丙酮变为溶于丙酮 ,对甲醇和四氯化碳的溶度参数的变化也说明了氯化PVDF的溶解性能变好 ,由TG曲线可知 ,氯化PVDF的热稳定性比改性前虽有一定的降低 ,但其分解温度仍在 3 0 0℃以上     

The Binary System BaF2/AlF3

The system BaF₂/AlF₃ is investigated by X-ray and D.T.A., and the liquid-solid phase diagram is established. Five ternary fluorides are disclosed: trimorphic BaAlF₅, Ba₃Al₂F₁₂, Ba₅AlF₁₉, polymorphic Ba₃AlF₉ and Ba₅AlF₁₃. Neutron thermodiffractometry experiments are performed to specify some parts of the diagram. The cell parameters of the fluorides are given and the results are discussed and compared with those of the previous works.     

Kinetics of radical telomerization of vinylidene fluoride in the presence of CCl3Z chain transfer agents

The kinetics of radical telomerization of VDF at 141 °C, initiated by ditertbutylperoxide, in the presence of three chain transfer agents (CTAs), HCCl₃, CCl₄ and CCl₃Br, are presented. The values of the chain transfer constants were assessed as 35, 0.25 and 0.06 at 141 °C for CCl₃Br, CCl₄ and HCCl₃, respectively. The values of the degree of polymerization (DP_n) were obtained for each CTA and were compared for the same CTA concentration. Hence, CCl₃Br behaved as an efficient CTA towards VDF and usually afforded the monoadduct selectively, but in certain conditions the VDF diadduct can also be produced. In contrast, HCCl₃ was not so efficient since a polymeric structure was identified as the major product.     

Pyrolytic synthesis and Eu→Eu reduction process of blue-emitting perovskite-type BaLiF3:Eu thin films

Perovskite-type barium lithium fluoride (BaLiF₃) was synthesized by pyrolysis of metal trifluoroacetates. The reaction temperature necessary for producing a single-phase material was found to be 600°C, which was lower than that for a conventional solid-state reaction or a melting method. Eu-doped BaLiF₃ was also prepared and characterized to examine the suitability of trifluoroacetates for precursors in synthesizing homogeneous complex metal fluoride materials. It was demonstrated that trivalent Eu³⁺, which was used as acetate for a starting material, was reduced to divalent Eu²⁺ in the pyrolysis process of BaLiF₃, as indicated by a broad blue emission due to an allowed 4f⁶5d→4f⁷ transition at 408 nm with a ultraviolet excitation at 254 nm. The concentration quenching of the blue emission occurred at 5 at% of Eu in BaLiF₃, indicating that Eu was homogeneously dispersed in the BaLiF₃ host lattice. Mechanisms of the formation and reduction process of BaLiF₃ were discussed based on pertinent chemical reactions.     

聚偏氟乙烯微孔膜的亲水化改性及功能化研究进展

聚偏氟乙烯(PVDF)微孔膜的亲水化改性方法有物理共混、化学共聚、表面涂覆、表面化学处理、表面接枝等几种。其中物理共混和表面涂覆法比较成熟且已获得应用，而PVDF微孔膜的表面化学处理、等离子体或光引发改性技术以及环境敏感性等将成为PVDF微孔膜的改性和功能化研究的主要方向。     

Microcalorimetric studies on the non-competitive inhibition of bovine liver arginase

Two methods, e.g. initial rate method and thermokinetic reduced extent method were presented for studies on non-competitive inhibition. Arginase-catalyzed the hydrolysis of L-arginine toL-ornithine and urea and the inhibition of this reaction by sodium fluoride were studied in the absence and presence of exogenous of Mn²⁺at 37°C in 40 mM sodium barbiturate-hydrochloric acid buffer solution (pH 7.4). Both methods were successively used to determine the values of K₁. The advances and disadvantages of each method were compared in this paper. Exogenous Mn²⁺ could result in more sensitivity of arginase to F^-1. Since the inhibition of arginase by F^-1 depends on the pH values of the reaction system and behave as a non-competitive inhibition, it probably due to its small volume and high electronic density allow it access to the activity site of the enzyme and replaces of μ-OH₂ (or μ-OH) as the bridge ligand with Mn(II, II) cluster. However, further studies are necessary to determine the modes of interaction of F^-1 with bovine liver arginase. This revised version was published online in August 2006 with corrections to the Cover Date.     

Features and origin of the dynamic and the nonlinear piezoelectricity in poly(vinylidene fluoride)

Some of the piezoelectric coefficients of poly(vinylidene fluoride) are distinctly stress dependent. We report on their dependence on the frequency of an oscillatory stress excitation, on the amount of the remanent polarization in the sample materials, and on the magnitude of an offset stress. In order to explain the observed dynamic and nonlinear piezoelectric properties, a model is developed that attributes them to changes in the local polarization in an interphase between the crystalline and amorphous phases in this semicrystalline polymer.     

Synthesis of poly[arylene ether sulfone-b-vinylidene fluoride] block copolymers

A series of α,ω-dihydroxy polyarylene sulfones (PAES) were synthesized comprising bisphenol A (PAES1, M_n=1800, 4900, and 9500 daltons), 4,4^′-biphenol (PAES2, M_n=4100 daltons), and hexafluorobisphenol A (PAES3, M_n=3300 daltons). These were reacted with α,ω-dibromo poly(vinylidene fluoride) (PVDF, M_n=1200 daltons) prepared by telomerization, to yield block copolymers possessing rigid and flexible segments. Block copolymers were characterized by FTIR, NMR, GPC, DSC, TGA and TEM. In several cases the block copolymers exhibited distinct thermal transitions, i.e. T_m and T_g for PVDF and PAES segments, respectively. Where observable, T_g of PAES domains in the block copolymers occurred at a temperature lower than the corresponding PAES homopolymer due to the flexible nature of the surrounding PVDF domains. Block copolymers exhibited a similar thermal stability to the corresponding PAES homopolymers but higher stability than the PVDF homopolymer, and much higher still than α,ω-dibromo PVDF. TEM analyses indicate that phase separation of PAES and PVDF domains occurs on the nanometer scale.