Microwave synthesis of magnetic Fe3O4 nanoparticles used as a precursor of nanocomposites and ferrofluids

Methods to synthesize magnetic Fe₃O₄ nanoparticles and to modify the surface of particles are presented in the present investigation. Fe₃O₄ magnetic nanoparticles were prepared by the co-precipitation of Fe³⁺ and Fe²⁺, NH₃·H₂O was used as the precipitating agent to adjust the pH value, and the aging of Fe₃O₄ magnetic nanoparticles was accelerated by microwave (MW) irradiation. The obtained Fe₃O₄ magnetic nanoparticles were characterized by Fourier transform infrared spectroscopy (FT-IR), transmission electron microscopy (TEM), X-ray powder diffraction (XRD) and vibrating sample magnetometer (VSM). The average size of Fe₃O₄ crystallites was found to be around 8–9 nm. Thereafter, the surface of Fe₃O₄ magnetic nanoparticles was modified by stearic acid. The resultant sample was characterized by FT-IR, scanning electron microscopy (SEM), XRD, lipophilic degree (LD) and sedimentation test. The FT-IR results indicated that a covalent bond was formed by chemical reaction between the hydroxyl groups on the surface of Fe₃O₄ nanoparticles and carboxyl groups of stearic acid, which changed the polarity of Fe₃O₄ nanoparticles. The dispersion of Fe₃O₄ in organic solvent was greatly improved. Effects of reaction time, reaction temperature and concentration of stearic acid on particle surface modification were investigated. In addition, Fe₃O₄/polystyrene (PS) nanocomposite was synthesized by adding surface modified Fe₃O₄ magnetic nanoparticles into styrene monomer, followed by the radical polymerization. The obtained nanocomposite was tested by thermogravimetry (TG), differential scanning calorimetry (DSC) and XRD. Results revealed that the thermal stability of PS was not significantly changed after adding Fe₃O₄ nanoparticles. The Fe₃O₄ magnetic fluid was characterized using UV–vis spectrophotometer, Gouy magnetic balance and laser particle-size analyzer. The testing results showed that the magnetic fluid had excellent stability, and had susceptibility of 4.46×10⁻⁸ and saturated magnetization of 6.56 emu/g. In addition, the mean size d (0.99) of magnetic Fe₃O₄ nanoparticles in the fluid was 36.19 nm.     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

An optical fibre pH sensor based on dye doped mesostructured silica

This paper describes the synthesis and optical pH sensing properties of a pH indicator dye activated mesostructured silica coated optical fibre. The pH-sensitive dye bromothymol blue was incorporated into the mesostructure sol precursor and thin films/coatings were used for pH-sensing applications without prior removal of the surfactant. The pH sensitivity range and operating wavelength were analysed by absorption measurements on layer dip-coated on glass slides. The pH sensing properties of coated optical fibre were tested by evanescent wave method. Experiments were carried out by using a series of solutions of known pH. No leaching was observed (except at very high pH) and an excellent reversibility was obtained between pH=2 and 5.     

Synthesis and Raman analysis of 1D-ZnO nanostructure via vapor phase growth

1D-nanostructural zinc oxide (ZnO) with different shapes have been synthesized on p-type Si(1 0 0) and glass substrates via vapor phase growth by heating pure zinc powder at temperatures between 480 and 570 °C. The different ZnO nanostructures depend on the substrates and the growth temperatures. Scanning electron microscopy and X-ray diffraction revealed that a well-aligned nanowires array, which are vertical to the substrate of Si(1 0 0) with 18 sides on their heads, but six sides on their stems, has been formed at 480 °C. Raman study on the ZnO nanostructures shows that the coupling strength between electron and phonon determined by the ratio of the second- to the first-order Raman scattering cross-sections declines with decreasing diameter of the nanowires. However, a little changes of the coupling strength in terms of the width of the nanobelts have been observed.     

Formation of p-type ZnO film on InP substrate by phosphor doping

ZnO thin film was initially deposited on InP substrate by radio frequency (rf) magnetron sputtering and the diffusion process was performed using the closed ampoule technique where Zn₃P₂ was used as the dopant source. To verify the junction formation of ZnO thin films, the electrical properties were measured, and the effects of Zn₃P₂ diffusion on ZnO thin films were investigated. It is observed that the electrical property of the film is changed from n-type to p-type by dopant diffusion effect. Based on the results, it is confirmed that ZnO thin films can be a potential candidate for ultraviolet (UV) optical devices.     

ICP-AES同时测定混合矿物素中的磷、钙、铁、铜、锌、锰、镁、钴

采用ICP－AES法测定混合矿物素中的磷、钙、铁、铜、锌、锰、镁、钴元素含量，并对样品的溶解酸和酸用量、元素分析线的选择以及共存元素间的干扰进行了研究。该法简便、快速，精密度和准确度较好。     

Thermal conductance for single wall carbon nanotubes

We report a theoretical analysis of the phonon thermal conductance, κ(T), for single wall carbon nanotubes (SWCN). In a range of low temperatues up to 100 K, κ(T) of perfect SWCN is found to increase with temperature, approximately, in a parabolic fashion. This is qualitatively consistent with recent experimental measurements where the tube-tube interactions are negligibly weak. When the carbon-carbon bond length is slightly varied, κ(T) is found to be qualitatively unaltered which implies that the anharmonic effect does not change the qualitative behavior of κ(T). Received 12 June 2001     

Charge plate technique in recoil study: Evidence for collection of recoil charged species from solid targets on metal electrodes

The occurrence of charge on recoil⁵⁶Mn produced by the (n,γ) reaction in polycrystalline potassium permanganate has been examined using the ‘charge plate technique’. From considerations of capture gamma ray decay schemes and internal conversion it appears that, in a condensed medium, the recoil atom develops charge after losing much of its initial kinetic energy which allows collection on charged electrodes. Preliminary findings were presented at the International Symposium on Radiochemistry and Radiation Chemistry, RC-41 BARC, Bombay, Feb. 4–6 (1991).     

Solvothermal Synthesis of Molybdenum Disulfide Hollow Spheres Modified by Cyanex 301 in Water–Ethanol Medium

Hollow spherical molybdenum disulfide has been successfully synthesized via a solvothermal method using Cyanex 301 as sulfur source and modification agent. The hollow spheres are characterized by transmission electron microscopy, scanning electron microscopy, X-ray diffraction and Energy-Dispersive X-ray analysis. The influences of reaction conditions are also discussed while a mechanism is proposed to explain the formation of the peculiar morphology.     

Nanometric Antimony Powder Synthesis by Activated Alkaline Hydride Reduction of Antimony Pentachloride

A novel chemical reduction method using an activated alkaline hydride (LiH or NaH-t-BuONa) in tetrahydrofuran solvent has been applied to antimony salt reduction. X-ray diffraction and transmission electron microscopy studies have been carried out to characterize the morphology and structure of the materials. Alkali hydride nature influence has been proved. In both cases the process allows to prepare antimony particles in nanometer range from few nanometers to about 20nm which could be used as anodic materials for lithium–ion batteries. With lithium hydride well-crystallized particles inclined to agglomeration were observed whereas finely dispersed amorphous particles were pointing out after activated sodium hydride reduction.