CRT显示器稳定性实验研究

用屏幕色度计对一台SONY-G520显示器的显色特性进行了测量,研究了其开机稳定性和短、中、长期内的色差及色度偏差。实验结果表明,开机后,显示器的亮度Y和色度x,y分别可在2h,30min和1h达到相对稳定状态,且在达到相对稳定后,在短、中、长期内的平均色差分别为0.0611,0.1469和1.2536CIELAB色差单位;在中期内,Y,x,y,L,a,b的平均偏差分别为0.0663,0.0008,0.0015,0.0695,0.4740和0.1766。通过对显示器稳定性的测量,为在对比度敏感测量和色貌模型、图像质量、图像感知模型评价等研究领域中用显示器进行实验研究奠定了基础。     

理想气体吸热和放热的讨论

根据热力学第一定律和理想气体状态方程推导了理想气体的热容量公式,并对理想气体在p-V图上的直线过程和循环过程的温度变化及吸热和放热进行了讨论.     

气体放电等离子体特性测量I-V曲线不对称性的研究

利用气体放电双探针法研究了等离子体的I-V曲线中的电流I相对于电压V轴交点的不对称性,并提出2种可能的解释:一认为是由于两探针表面积不同引起的;二认为是由于探针所在处等离子体电位不等引起的.本文利用仪器的工艺误差和调换放电管电压的方法,对提出的2种可能原因分别进行验证,并指出第二种解释的合理性,并对其进行了理论分析.     

聚酰胺酸合成工艺研究

 采用超声波在线测量溶液粘度的方法，研究了合成聚酰胺酸过程中实验条件的影响，并对实验结果进行分析，由此确定了合成高分子量聚酰胺酸的最佳实验条件。研究表明：在加料次序为先加二胺后加二酐（二酐与二胺的摩尔比为1.01～1.02：1）、试剂中含水量尽可能少，反应温度0～5℃、反应时间以溶液粘度到达最大值为止的条件下，所合成的聚酰胺酸溶液粘度最大，可满足惯性约束聚变（ICF）充气腔靶端口膜的需要。     

Atomistic packing models for experimentally investigated swelling states induced by CO2 in glassy polysulfone and poly(ether sulfone)

Atomistic packing models have been created, which help to better understand the experimentally observed swelling behavior of glassy polysulfone and poly (ether sulfone), under CO₂ gas pressures up to 50 bar at 308 K. The experimental characterization includes the measurement of the time‐dependent volume dilation of the polymer samples after a pressure step and the determination of the corresponding gas concentrations by gravimetric gas‐sorption measurements. The models obtained by force‐field‐based molecular mechanics and molecular dynamics methods allow a detailed atomistic analysis of representative swelling states of polymer/gas systems, with respect to the dilation of the matrix. Also, changes of free volume distribution and backbone mobility are accessible. The behavior of gas molecules in unswollen and swollen polymer matrices is characterized in terms of sorption, diffusion, and plasticization. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1874–1897, 2006     

双电极对双脉冲激光器结构分析

本文对双电极对双脉冲激光器的谐振腔结构进行了分析,结果表明采用双非稳腔和增大反射镜的曲率半径可分别获得单纵模和基横模输出。为使输出能量稳定,则双电极对的间距有一最小值的限制。     

Effect of hydrogen on interatomic bonds in austenitic steels

Mössbauer spectroscopy was used to investigate the influence of dissolved hydrogen on the interatomic bonds in austenitic steels. It was carried out to prove the decohesion mechanism of hydrogen embrittlement (HE). It is shown that hydrogen increases Debye temperature, i.e., the interatomic bonds in hydrogenated austenitic steel becomes stronger.     

Flaked capillary columns with crown ether complexes for gas-liquid chromatography

Flaked capillary columns with an OV-101/CE-Na{in3}PO{in4} hydrophobic-hydrophilic sorbent have been suggested. This sorbent provides for the analysis of polar and nonpolar substances, including amines and aminoalcohols, in aqueous and organic solvents. The efficiency of new columns was demonstrated for the analysis of 25 organic substances of various classes.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 12, pp. 2169–2173, December, 1994.The work was financially supported by the Russian Foundation for Basic Research, Project No. 93-03-4969.     

Enantioselective separations by capillary GC on derivatized cyclodextrins. Part 2: Determination of enantiomeric excess of some racemic 2,3-isopropylidene-1,2,3-cyclohexanetriol derivatives on permethyl α-, β-, and γ-cyclodextrins

Capillary GC on permethyl α-, β-, and γ-cyclodextrins has been applied to separate and quantify the enantiomers of some 2,3-iso-propylidene-1,2,3-cyclohexanetriol derivatives. Quantitative CGC data are compared to those obtained with chiral shift ¹H NMR.     

Chromatographic characterization of thermally upgraded products from alternative fuels

An overview is presented of the analytical approaches developed by our research group over the last ten years for analysis of alternative fuel, both biomass and fossil. The alternative fuels are analyzed successively by PLC-8 (preparative liquid chromatography–group-type) fractionation and high resolution gas chromatography. Some of the possibilities for fractionation and characterization of alternative fuels are herein exemplified with sugar cane bagasse pyrolysis products.