High Voltage Pulse Power and the Technics for the Capacitor Power-Storage Type

Lower hybrid wave （LHW）, electro cyclotron （EC） and neutral beam injection （NBI） etc. are the important methods of auxiliary heating. They would be devoted to the HL-2A tokamak step by step. In order to satisfy the debug of each system and the need of the experiment, the system should be equipped with high voltage pulse power （HVPP） according to the requirement.     

磁共振法研究(Fe1-xCox)84Zr3.5Nb3.5B8Cu1纳米晶薄带的磁各向异性

铁磁共振(FMR)实验研究(Fe1-xCox)84Zr3.5 Nb3.5B8Cu1(x=0.0,0.2,0.4,0.6, 0.8)合金薄带的各向异性,易轴在薄带的横向方向,同等宽度样品的各向异性常数K′随Co掺杂量的增加而减小, K′值在4.67×10-5 J/m(x=0.0)到2.54×10-5 J/m4(x=0.8)之间.由于磁化率的虚部χ″(H)随磁场强度H非线性变化,在低场(0-12 mT)有一个与FMR信号强度相当的低场非共振信号.特别是对Fe84Zr3.5 Nb3.5B8Cu1合金薄带的磁化,在可逆磁化(0-2.0 mT)和趋近饱和磁化(9.0-12 mT)区域, dχ″/dH=0;不可逆畴壁移动过程中,交流磁化率虚部χ″(H)与磁场强度的n次方即Hn(n≥3)有关;在磁畴转动过程中χ″(H)正比于H2(瑞利区),(dχ″)/(dH)为常数;而且发现,有不可逆畴壁移动-磁畴转动三段交替变化的过程,此过程对应三种磁畴的消失过程.     

Kondo绝缘体CeNiSn的低温物性研究

对ＣｅＮｉＳｎ的多晶样品进行了磁化率ｘ（１．８－２０Ｋ），电阻率ρ（３－１００Ｋ），Ｈａｌｌ系数Ｒ（４．２－３２Ｋ）和低温比热（１．２－３０Ｋ）的测量，经Ｘ射线衍射分析，该样品为单相结构，磁化率Ｘ在较高温区（３０－２００Ｋ）遵循Ｃｕｒｉｅ－Ｗｅｉｓｓ定律，并可推定出Ｃｅ离子的价态是＋３价的，在３０Ｋ以下磁化率Ｘ明显地偏离该定律并急剧增大，显示出明显的Ｋｏｎｄｏ行为，在１５Ｋ以上，ρ（Ｔ）很好地符合     

系数在复数域C上的Kac—Moody代数的低维上同调

§1引言和记号 李代数的上同调性质与其本身的结构有着密切的联系.本文我们将给出李代数G(A)的系数在C上的低维上同调.无限维李代数的上同调的计算比有限维的复杂得多.而且即使在有限维的情况,这样的上同调也是难计算的.因此与[1]一样,我们采取直接的方法计算.主要结果是定理3.1.最后指出,此结果推广了[1].     

Ce偶-偶同位素低激发态性质的IBM2描述

通过考虑同类核子相干对间的四极相互作用，在IBM2中对Ce偶－偶同位素^128Ce-^138Ce的低激发态能谱和E2跃迁几率及分支比进行了理论分析，计算结果有效地改善了IBM中这些核的γ带能谱的Staggering现象描述，与实验观察到的低激发态结果基本一致。     

HL－1装置中LHCD和等离子体参数的关系

本文研究了在ＨＬ－１托卡马克的不同放电阶段的低混杂波驱动特性。给出了驱动电流及驱动效率和等离子体参数，如电子平均密度ｎｅ、等离子体电流Ｉｐ及纵向磁场的关系。也给出和分析了波驱动和入射波功率的关系。在放电平段，对正反向驱动效率进行了研究和比较。     

Decomposition of the Two Lowest Lamb modes in a Bonded Plate

Based on the expression of the dispersion equation of Lame waves in an adhesive two-layered plate pressented in our proevious paper [Chin,Phys,Lett,18(2001)1483],the two lowest Lamb modes,the symmetric mode S0 and the antisymmetric mode A0 are successfully decomposed in the low-frequency regime,Relations between the rigidity of the bond and the velocity of the two Lamb modes are found,which lay a foundation for the estimation of the bond rigidity of the adhesive plate.The influence of the variations of the bond rigidity in terms of the stiffness constants KN and KT of the spring model on the velocity of the two Lamb modes in discussed and numerically evaluated.numerical results indicate that the deterioration of the bond rigidity causes the phase velocity decrease for Lamb modes of the two lowest order,thus having a possibility for the evaluation of the bonding state of the adhesive plate by using ultrasonic wave velocity measurement.