Pyranoxanthones from Calophyllum Inophyllum

Phytochemical investigation of the stem bark of Calophyllum inophyllum resulted in the isolation of a new dipyrenoxanthone, calophinone ( 1 ), together with four related xanthones ( 2–5 ). Identification of the isolated compounds was achieved through intensive studies of their spectral data, especially 2D NMR.     

电场作用下苏氨酸的电流特性研究

制备了以液态苏氨酸为沟道材料的四端有机场效应晶体管,观测了其随着栅极电压的不同呈现出源漏两极之间不同的电学特异现象;还观测了苏氨酸在外电场作用下,阻抗随着源漏之间电压频率变化的关系,提出一个极性液体模型解释了其导电机理。     

表面包覆改性对纳米CeO2分散性的影响

了改善纳米CeO2在Zn-Al类共晶合金中的分散性,采用超声液相包覆法对纳米CeO2进行表面活性剂表面包覆改性,并用AES测定了包覆层的厚度,用TEM研究了CeO2的团聚状况,用TGA分析了有机物包覆层的炭化温度范围,最后用FE-SEM观察了CeO2在复合材料中的分散情况。结果表明,包覆在纳米CeO2表面的厚度约为20 nm的表面活性剂层提高了微粒的分散性,而且该包覆层在495℃时已经炭化。热力学计算的结果也表明,炭化层能与氧化膜反应,该反应提高了CeO2与基体间的润湿性,并使其均匀分布在基体合金中。     

AM1法研究乙烯与环己－1，3－二烯热加成反应

用ＡＭ１方法（采用非限制的Ｈａｒｔｒｅｅ－ＦｏｃｋＵＨＦ计算）研究乙烯与环己－１，３－二烯的热Ｄｉｅｌｓ－Ａｌｄｅｒ反应。结果表明反应是放热的且存在两条竞争的路径；协同反应的活化能以及双自由反应速度控制步骤的活化能分别为１１２．６６７ｋＪ／ｍｏｌ和７８．４０６ｋＪ／ｍｏｌ。     

有机硅耐磨透明涂层的固化分析

ＦＴＩＲ、ＴＧ、ＴＢＡ等对有机硅耐磨涂料（有机硅溶胶）的热固化过程研究表明有机硅胶体中缔合羟基间的脱水缩合速率很高；羟基脱水程度与固化温度有关，温度越高，达平衡时羟基的浓度越低，在１０５～１３０℃间羟基的浓度变化最大，加入适当的固化剂，对羟基的脱水交联有促进作用，在较高的固化温度下，反应体系中出现了环氧环异构化产生的酮羰基的吸收峰     

同位素稀释结合固相萃取快速测定动物组织中β2-兴奋剂

本文采用同位素稀释结合固相萃取技术,测定动物组织中特布他林、克伦特罗、沙丁胺醇、莱克多巴胺4种β2-兴奋剂。动物组织加同位素内标D3-沙丁胺醇和D9-克伦特罗,经甲醇提取后,正己烷脱脂,过SLS离子交换固相萃取柱净化,用BSTFA 1%(φ)TMCS衍生,采用GC/MS进行测定,内标法定量。实验表明,动物组织中添加2.0~10.0μg/kg浓度水平的β2-兴奋剂,方法回收率在72.5%~97.9%,相对标准偏差1.0%~11.4%,线性范围为12.5~500μg/L,样品中特布他林、克伦特罗、沙丁胺醇、莱克多巴胺最低检出限分别为0.5μg/kg、1.0μg/kg、0.5μg/kg和1.0μg/kg。     

测接触角法确定偶联剂的最佳用量

偶联剂是一类能在无机填料和聚合物基材之间形成“分子桥”、改善两者之间相容性或提高两者之间相互作用能力的化合物。将经偶联剂改性的无机填料填充到聚合物中可以制得成本低、性能好的复合材料。由于偶联剂用量多少将对复合材料的性能产生较大影响,因此建立一种准确、简便地确定偶联剂最佳用量的方法有着十分重要的理论和实际应用意义。     

Modified modeling of the effect of pH and viscosity on the mass transfer in hydrophobic hollow fiber membrane contactors

This paper studied the effect of pH and the viscosity of feed solution on the mass transfer in two different specifications of hydrophobic hollow fiber membrane contactors. Experimental results showed that the pH of the feed had a significant effect on the rate of mass transfer, the flux and the removal efficiency of easily ionized volatile compounds (VCs), such as ammonia. In unbuffered feed solutions, both the resistance of membrane and the resistance of feed side were affected by the pH of feed and both of them had contributions to the overall mass transfer. A model, , was proposed to predict the effect of pH and gave good agreement with the experimental data for the two contactors. The relationship between viscosities and the mass transfer coefficient could be described by . Based on our experiments, the change of the viscosities in the concentration range of ammonia from 50 to 10,000 mg l⁻¹ caused about 3–4% variation of the mass transfer coefficients. Moreover, it may be more suitable to use the equilibrium concentrations of volatile species instead of the total concentrations of VCs to estimate mass transfer coefficients, removal efficiency and flux. Experimental results also revealed that the choice of the pH of feed might be one of the most crucial factors for removing easily ionized VCs, such as ammonia, from water and wastewater.     

High-efficiency, environment-friendly electroluminescent polymers with stable high work function metal as a cathode: green- and yellow-emitting conjugated polyfluorene polyelectrolytes and their neutral precursors

A series of aminoalkyl-substituted polyfluorene copolymers with benzothiadiazole (BTDZ) of different content were synthesized by Suzuki coupling reaction, and their quaternized ammonium polyelectrolyte derivatives were obtained through a postpolymerization treatment on the terminal amino groups. Copolymers are soluble in environmentally friendlier solvents, such as alcohols. It was found that the efficient energy transfer occurs by exciton trapping on the narrow band gap BTDZ site under UV illumination. Only 1% of BTDZ content is needed to completely quench a fluorene emission for both the neutral and the quaternized copolymers in the neat film. Absolute PL efficiencies of copolymer films were greatly enhanced as a result of the suppression of excimer formation. Light-emitting devices fabricated from these copolymers show high external quantum efficiencies over 3% and 1% for the neutral precursor and the quaternized copolymers, respectively, with high work function metals such as Al as a cathode. To the best of our knowledge, this is the first report on an electroluminescent polymer which bears the high EL efficiency, the electron-injection ability from high work function metals, and the solubility in environment-friendly solvents at the same time. These features make them a promising candidate for the next generation of light-emitting copolymers in PLED flat panel display application.     

一种新型铒镱共掺碲硅酸盐玻璃的光谱性质及荧光俘获效应研究

用高温熔制法制备了系列Er^3＋／Yb^3＋共掺碲硅酸盐玻璃样品，测试和分析了玻璃样品的吸收光谱、荧光光谱、上转换发光光谱及热稳定性。结果表明：这种玻璃具有较宽的荧光半高宽、较大的受激发射截面，较好的热稳定性。970nm泵浦下该系列玻璃在可见光525，546和658nm这3处存在明显的上转换现象，它们分别由Er^3＋离子^2H11/2→^4 I15/2，4S3/2→^4 I15/2和^4 F9/2→^4 I15/2辐射跃迁产生。另外，测试和讨论了在不同样品厚度下玻璃的光谱特性，如荧光光谱、荧光寿命和上转换发光光谱等。结果表明，荧光俘获效应对Er^3＋离子1．5μm波段荧光及上转换发光都有着较大的影响，并随着玻璃厚度的增加而增大，导致测量值与实际值产生较大的偏差。