A molecular fluorophore in citric acid/ethylenediamine carbon dots identified and quantified by multinuclear solid-state nuclear magnetic resonance

The composition of fluorescent polymer nanoparticles, commonly referred to as carbon dots, synthesized by microwave-assisted reaction of citric acid and ethylenediamine was investigated by ¹³C, ¹³C{¹H}, ¹H─¹³C, ¹³C{¹⁴N}, and ¹⁵N solid-state nuclear magnetic resonance (NMR) experiments. ¹³C NMR with spectral editing provided no evidence for significant condensed aromatic or diamondoid carbon phases. ¹⁵N NMR showed that the nanoparticle matrix has been polymerized by amide and some imide formation. Five small, resolved ¹³C NMR peaks, including an unusual ═CH signal at 84 ppm (¹H chemical shift of 5.8 ppm) and ═CN₂ at 155 ppm, and two distinctive ¹⁵N NMR resonances near 80 and 160 ppm proved the presence of 5-oxo-1,2,3,5-tetrahydroimidazo[1,2-a]pyridine-7-carboxylic acid (IPCA) or its derivatives. This molecular fluorophore with conjugated double bonds, formed by a double cyclization reaction of citric acid and ethylenediamine as first shown by Y. Song, B. Yang, and coworkers in 2015, accounts for the fluorescence of the carbon dots. Cross-peaks in a ¹H─¹³C HETCOR spectrum with brief ¹H spin diffusion proved that IPCA is finely dispersed in the polyamide matrix. From quantitative ¹³C and ¹⁵N NMR spectra, a high concentration (18 ± 2 wt%) of IPCA in the carbon dots was determined. A pronounced gradient in ¹³C chemical-shift perturbations and peak widths, with the broadest lines near the COO group of IPCA, indicated at least partial transformation of the carboxylic acid of IPCA by amide or ester formation.     

EAST装置上W波段多道极向相关反射仪的研制

在EAST装置上安装了X模极化W波段多道相关反射仪，用于测量等离子体芯部密度涨落。该诊断利用低损耗(<3dB)多工器将4个不同频率(79.2GHz，85.2GHz，91.8GHz和96GHz)的微波耦合在一起，通过同一个天线发射。反射波由两个极向分离(~5cm)的天线接收，通过下变频技术实现外差测量。通过对两个极向天线接收的信号进行相关分析，获得芯部湍流垂直速度。对2018年低约束模式(L模)放电进行分析发现，在电子回旋共振加热(ECRH)等离子体中，芯部湍流垂直速度在电子逆磁漂移方向。而在注入同向中性束(co-NBI)后，芯部湍流垂直速度变为离子逆磁漂移方向。     

某型电动飞机螺旋桨振动特性实验研究

某型电动飞机采用螺旋桨产生拉力,为了防止螺旋桨工作时共振,利用ES-2-150振动实验系统进行了两叶木质螺旋桨和碳纤维螺旋桨的振动特性实验,采用谐振搜索与驻留方法测量出木质螺旋桨的第一阶固有频率为36.07Hz,碳纤维螺旋桨的第一阶固有频率为73.58Hz。螺旋桨爬升状态转频为39Hz,这与木质螺旋桨的第一阶固有频率非常接近,导致木质螺旋桨在爬升状态出现比较严重的振动故障。因此,某型电动飞机最终选择两叶碳纤维螺旋桨作为其拉力产生装置。     

静止轨道星载差分吸收光谱仪CCD成像系统设计

静止轨道卫星差分吸收光谱仪采用摆扫成像方式对大气进行探测,针对其工作时CCD成像系统信噪比大于1 000、高速探测模式下探测周期小于10min、高分辨率模式下探测周期小于1h的要求,进行CCD成像系统设计.选取CCD47-20作为探测器,设计成像电路实现光谱图像信号的采集和上传.分析了帧叠加和像元合并对时间、空间分辨率的影响.结合帧转移CCD的特点设计了每个位置最后一帧读出时摆镜转动的成像方式,并合理设置了帧叠加数和像元合并数,达到优化成像周期的目的.1s曝光时间条件下,该CCD成像系统的高速、高分辨率模式探测周期分别为515s和3 315s,图像信噪比均大于1 000,污染物观测实验中未出现失帧或重复的现象.该CCD成像系统方案满足静止轨道星载差分吸收光谱仪的探测需求,为静止轨道环境监测仪器设计提供参考.     

航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束，在使用的振动环境中，会因弯曲应力而导致破裂，影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上，得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数，使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．     

一种新的岩石非线性黏弹塑性蠕变模型研究

为了克服传统元件组合模型不能描述岩石蠕变过程中非线性特征的缺陷，首先根据加速蠕变阶段的应变和应变率随蠕变时间急剧增大的特点，建立黏塑性应变与蠕变时间的指数函数关系并提出非线性黏塑性体．将该非线性黏塑性体与广义Burgers蠕变模型串联，建立可以描述岩石全蠕变过程的非线性黏弹塑性蠕变模型，根据叠加原理得到一维应力状态下的轴向蠕变方程．然后基于塑性力学理论指出岩石三维蠕变本构方程建立过程中的不足之处，并给出非线性黏弹塑性蠕变模型合理的三维蠕变方程．最后采用不同应力水平下砂岩轴向蠕变试验对模型合理性进行验证，结果表明：拟合曲线与试验曲线吻合度较高，所建蠕变模型能够很好地描述砂岩在不同应力水平下的蠕变变形规律，尤其对加速蠕变阶段的非线性特征描述效果很好，验证了模型的合理性．     

语音通信降噪研究

语音通信系统中，语音通过信道传输将不可避免地引入码间串扰和信号畸变，同时受到噪声污染。本文在分析自适应盲均衡算法CMA(constant modulus algorithm）和改进盲均衡算法的基础上，考虑到自适应盲均衡技术在语音噪声控制方面能力有限，将自适应盲均衡技术与小波包掩蔽阈值降噪算法联合使用，形成一种基带语音增强新方法。仿真试验结果显示自适应盲均衡技术可以使星座图变得清晰而紧凑，有效减小误码率。研究证实该方法在语音信号ISI和畸变严重情况下，在白噪及有色噪声不同的噪声环境中都具有稳定的降噪能力，消噪同时可获得汉语普通话良好的听觉效果。     

DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585