A New Hydroxo‐bridged Chromium(III) Dimer [Cr(saltn)OH]2·4H2O: Synthesis,Crystal Structure and Magnetic Properties

A new hydroxo‐bridged dimeric Cr(III) complex [Cr(saltn)OH]₂·4H₂O [H₂saltn=N,N′‐bis(salicylidene)trimethylenediamine] has been synthesized and its structural and magnetic properties have been investigated. The complex crystallizes in the triclinic space group P‐1 with one dimeric formula unit in a cell of dimensions a=0.95828(19) nm, b=0.95926(19) nm, c=1.0437(2) nm, α=86.77(3)°, β=82.48(3)°, and γ=64.93(3)°. The geometry around each chromium(III) center is six‐coordinate, distorted‐octahedral. The bridging Cr₂O₂ unit is strictly planar, as required by the crystallographic symmetry. The Cr? O? Cr′ bridging angle is 99.94(16)°, and the distance between Cr…Cr′ is 0.3019 nm. The magnetic susceptibility of the complex has been examined in the range of 2‐300 K. By using the spin‐spin coupled model for an S₁=S₂=3/2 dimeric system , the magnetic data were fitted to give the parameters of g=2.01(1), J=‐0.85(2) cm^‐1, and zJ' =0.18(3)cm^‐1, indicating the presence of a weak antiferromagnetic spin‐exchange interaction between the Cr(III) ions in the binuclear complex.     

聚乙二醇在高真空条件下的单链弹性

在过去二十年间，高分子的单链弹性已经得到了广泛的研究.然而由于环境和高分子之间往往有着复杂的相互作用，实验中很难得到高分子在严格无扰状态下的单链弹性（即本征弹性）.为此，利用单分子力谱技术研究了高真空条件下聚乙二醇（PEG）的单链弹性.结果表明，由于高真空条件下溶剂分子的干扰被消除，PEG在这一准无扰状态下呈现其本征弹性.在非极性有机溶剂中，由于溶剂分子和PEG之间只有微弱的范德华力作用，PEG表现出和高真空中基本一致的弹性.然而，在不同环境中，力曲线的低力区（F<100 pN）存在着细微的差异.这一现象可归因于不同条件下基底与PEG链之间的吸附力不同.采用的高真空力谱可用于研究其他高分子单链在准无扰状态下的本征弹性.     

DEHYDROGENATION AND AROMATIZATION OF METHANE IN THE ABSENCE OF OXYGEN OVER DOPED Mo/HZSM-5 CATALYSTS

研究了在Ｍｏ／ＨＺＳＭ－５催化剂上添加助剂以及不同的反应预处理温度对甲烷无氧脱氢芳构化反应的影响。实验结果表明，由于第二组分的添加，Ｍｏ／ＨＺＳＭ－５催化剂的活性和选择性都得到了较大程度的改善。预处理温度是影响催化剂反应性能的关键因素。Ｍｏ－Ｒｕ／ＨＺＳＭ－５催化剂经过８７３Ｋ空气预处理后，甲烷在９７３Ｋ的转化率约为１０％，催化剂的稳定性也得到较大程度的提高。ＴＰＳＲ实验结果表明，Ｒｕ的加入降低了芳烃生成的温度。ＴＰＯ和ＤＴＡ实验结果表明，在Ｍｏ－Ｒｕ／ＨＺＳＭ－５催化剂上可生成较多的碳物种，结合反应结果，可以认为反应过程中生成的碳物种对甲烷的无氧脱氢芳构化反应是起积极作用的     

BEHAVIOR OF SUPPORTED NANO-COPPER CATALYST IN CO OXIDATION

IntroductionNanomaterialisanewkindofmaterialwithparticlesizebetWeenIurnand100urn.Becauseofthesmallparticlesizeandthelargespecificsufficearea,nanomaterialpossessesmanyparticularproperties,suchashighersufficeenergyandhighersurfaceactivity.t.[l]Thehigheracti…     

Promoting effect of sol-gel method and pre-treatment on the activity of SnO2/Al2O3 catalyst for NO reduction by propene

SnO₂/Al₂O₃ catalyst prepared by sol-gel method showed higher activity than those prepared by impregnation method, and their activity was significantly improved by pre-treatment in the reaction gas. The increased activity is closely related to the agglomeration of SnO₂ species and the re-exposure of Al₂O₃, which was previously covered by dispersed SnO₂ species. This revised version was published online in June 2006 with corrections to the Cover Date.     

红外光谱法研究LB膜中的分子取向

The structure information of orientation and packing of molecular chains can be obtained from infrared transmission and reflection-absorbance (RA) spectra. In the present paper, on the basis of Umemura et al., their FORTRAN program of minicomputer was developed and can be run on 486 personal computer. By comparison of infrared transmission and RA intensities, surface enhancement factors and molecular orientation angle were calculated using the above program, and the influence of complex refractive index, angle of incidence, and thickness of LB film were discussed. These results are consistent with that of Umemura et al.     

在线双毛细管-氢化物火焰原子吸收光谱法测定砷、锑、铋、汞、硒和锡

1引言使用氢化物原子吸收光谱(HG-AAS)法测定As、Sb、B、iHg、Se和Sn已有报道。但将氢化物在线引入空气乙炔焰,用火焰法快速测定这些元素的方法少见报道。本实验利用双毛细管装置,建立了在线HG-AAS测定As、Sb、B、iHg、Se和Sn的方法,该方法具有简便、快速、灵敏度高,干扰少和KBH4用量少的优点。2实验部分2.1仪器及试剂GGX-9型原子吸收分光光度计;微型多功能进样装置(自制专利产品);空心阴极灯;盐酸(1 1);硫脲溶液(5%);抗坏血酸溶液(5%);KBH4溶液(1%,2%);邻二氮菲溶液(1%);As、Sb、B、iHg、Se、Sn的标准溶液;蒸馏水;其余试剂…     

pH值对聚四氨基酞菁钴膜电化学和紫外光谱性质的影响

用循环伏安法在导电玻璃(ITO)和玻碳电极(GC)上制备了聚氨基酞菁钴(CoTAPc)修饰电极(CoTAPc/GC)。探讨了pH值对CoTAPc膜的光谱和电化学性质的影响，发现其氧化还原电位与pH值有线性关系，电催化活性也随酸度的增加而增加。CoTAPc膜的紫外吸收带变化与溶液pH值及在溶液中浸泡时间有关。     

稀土变质热锻模具铸钢高温磨损性能的研究

研究了稀土（RE）变质热锻模具铸钢的高温磨损性能，并与热锻模具钢H13钢和3Cr2W8V钢进行对比，探讨了稀土元素的作用和热锻模具铸钢的高温磨损机理。结果表明：随着RE加入量的增加，热锻模具铸钢的磨损率先减后增，RE加入量在质量分数为0．05％时热锻模具铸钢具有最佳的高温磨损性能。RE变质热锻模其铸钢的高温耐磨性明最高于H13钢和3Cr2W8V钢。高温磨损机理为氧化磨损和氧化物的疲劳剥落，磨屑为块状的Fe2O3和Fe3O4。     

Crystalline Morphology and Polymorphic Phase Transitions in Electrospun Nylon 6 Nanofibers

Uniform nylon 6 nanofibers with diameters around 200 nm were prepared by electrospinning. Polymorphic phase transitions and crystal orientation of nylon 6 in unconfined (i.e., as-electrospun) and a high T(g) (340 degrees C) polyimide confined nanofibers were studied. Similar to melt-spun nylon 6 fibers, electrospun nylon 6 nanofibers also exhibited predominant, meta-stable gamma crystalline form, and the gamma-crystal (chain) axes preferentially oriented parallel to the fiber axis. Upon annealing above 150 degrees C, gamma-form crystals gradually melted and recrystallized into the thermodynamically stable alpha-form crystals, which ultimately melted at 220 degrees C. Release of surface tension accompanied this melt-recrystallization process, as revealed by differential scanning calorimetry. For confined nanofibers, both the melt-recrystallization and surface tension release processes were substantially depressed; gamma-form crystals did not melt and recrystallize into alpha-form crystals until 210 degrees C, only 10 degrees C below the T(m) at 220 degrees C. After complete melting of nano-confined crystals at 240 degrees C and recrystallization at 100 degrees C, only alpha-form crystals oriented perpendicular to the nanofiber axis were obtained. In the polyimide-confined nanofibers, the Brill transition (from the monoclinic alpha-form to a high temperature monoclinic form) was observed at 180-190 degrees C, which was at least 20 degrees C higher than that in unconfined nylon 6 at approximately 160 degrees C. This, again, was attributed to the confinement effect.