Accelerated Hydrolysis of p-Nitrophenyl Picolinate Catalyzed by Metallomicelle Made from a Novel Macrocyclic Polyamine Copper（Ⅱ） Complex

A copper（Ⅱ） complex 1 of a novel macrocyclic polyamine ligand with hydroxylethyl pendant groups, 4,11-bis（hydroxylethyl）-5,7,7,12,14,14-hexamethyl-1,4,8,11-tetraazacyclotetradecane （L） has been synthesized and characterized. Rate enhancement for hydrolysis of p-nitrophenyl picolinate （PNPP） catalyzed by 1 was studied kinetically under Brij35 micellar condition. For comparision, the catalytic activity of corresponding copper（Ⅱ） complex 2 of non-substituted macrocyclic polyamine ligand, 5,7,7,12,14,14-hexamethyl-1,4,8,11-tetraaza-cyclotetradecane （L＇） toward the hydrolysis of PNPP was also investigated. The results indicate that the macrocyclic polyamine copper（Ⅱ） complex 1 effectively catalyzed the hydrolysis of PNPP, and the pendant ligand hydroxyl group or deprotonated pendant ligand hydroxyl group can act as catalytically active species in the reaction. A ternary Complex kinetic model involving metal ion, ligand and substrate has been proposed, and the results confirmed the reasonability of such kinetic model.     

超支化聚硅(碳/氧)烷的研究进展

总结了近十年来超支化聚有机硅(碳/氧)烷的研究进展,其中着重综述了硅氢加成反应、亲核取代反应和脱氢反应在制备超支化聚硅(碳/氧)烷的过程中各种因素对反应过程及产物物化性能的影响。     

可控降解超支化聚碳硅氮烷的合成与表征

通过锂化四甲基二乙烯基二硅氮烷分别与甲基氢二氯硅烷和二甲基氢氯硅烷的亲核取代反应合成了AB4和AB2型单体AB4M和AB2M,两种单体通过Karstedt催化剂催化的硅氢加成反应分别生成聚碳硅氮烷PAB4M和PAB2M.单体和聚合物的结构通过FT-IR、1H-NMR、13C-NMR、29Si-NMR和体积排除色谱-多角度激光光散射联用(SEC-MALLS)技术进行了表征,结果表明,单体的结构与设计结构相符合;单体聚合时主要以α-硅氢加成方式为主;聚合物具有超支化结构并由N(Si—C)3链节和大量端基双键组成.PAB4M和PAB2M的重均分子量分别为7800和5860g/mol,分子量分布系数分别为2·54和2·31·对PAB4M稳定性的初步研究表明,该聚合物对氯硅烷和在中性条件下对水稳定,但在HCl水溶液中可以降解,且通过控制HCl浓度可以调节其降解速度,从而实现对其控制降解.     

缓冲溶液pH计算公式的推导

酸碱缓冲溶液在分析化学中的应用是多方面的 ,因此酸碱缓冲溶液 ｐＨ的计算是分析化学中必不可少的一个内容。目前 ,高师院校的分析化学多采用华中师范大学等校编的《分析化学》(第 2版 ) ,笔者在几年的教学中 ,发现该教材在缓冲溶液 ｐＨ计算的公式推导中存在疏漏。为此 ,在比较其他教材中该章节的内容后 ,从酸碱平衡最本质的内容ＰＢＥ出发 ,提出一种新的缓冲溶液ｐＨ计算公式推导方法。1　华中师范大学版教材中的问题[1]　　以一元弱酸及其共轭碱体系进行讨论 ,设弱酸ＨＡ浓度为ｃａ,共轭碱ＮａＡ浓度为ｃｂ。将ＨＡ Ａ-体系以Ｈ2 Ｏ作媒…     

碘掺杂的3-乙基-5-[2-(3-乙基-2苯并噻唑啉基)亚乙基]罗丹宁的结构与电性能

The merocyanine dye 3-ethyl-5-(2-(3-ethyl-2-benzothiazolinylidene)-ethylidene)-rhodanine (BTER) known as Agfa-10 has been found to have a good photoconductivity as solution cast film. In this paper iodine-doped BTER was obtained by doping with iodine vapor. Its structure was investigated with the following characteristies. 1 The doped iodine had been excited as I_3~- anion. 2 Because the electron located on the sulphur atom was transferred to iodine, the charge transfer complex of (BTER-I_3) formed. 3 During the iodine doping process, BTER changed from α-form to β-modification. These had been identified by X-ray diffraction, VIS-absorption spectra and SEM picture.4 From the volt-Ampere curve obtained from sandwich cell, when E≤2.2×10~(-1) V·cm~(-1), the room temperature electrical conductivity of BTER and BTER-I_3 were found to be 2.22×10~(-10) s·cm~(-1) and 2.6×10~(-7) S·cm~(-1), respectively.     

BaF2/La2O3催化剂上甲烷氧化偶联反应活性氧物种的原位红外光谱

用原位红外光谱研究了BaF2/La2O3催化剂上甲烷氧化偶联反应的活性氧物种.结果表明,催化剂经O2预吸附后,在1 108~1 118 cm-1处出现超氧物种O2-的O-O键伸缩振动峰.经18O2同位素交换实验后,原1 108~1 118 cm-1处谱峰的强度减弱,同时在1 086和1 051 cm-1处出现(O18O)-物种和18O2-物种的吸收峰.同位素交换实验进一步确证了1 108~1 118cm-1处谱峰确为O2-物种的吸收峰.在700℃下,O2-物种能够活化CH4生成C2H4,而且O2-物种的消耗量和C2H4的生成量呈很好的消长对应关系.超氧物种O2-是BaF2/La2O3催化剂上甲烷氧化偶联反应的活性氧物种.     

番红花红O-Mn2+-H2O2光度法测定茶叶的抗氧化性

在硫酸介质中,Mn2 -H2O2体系产生的羟自由基可以迅速氧化番红花红O,使其颜色变浅。实验证明,茶叶提取液具有可清除溶液中的羟自由基的功能,从而使番红花红O溶液的褪色程度降低。根据溶液吸光度的这一变化,可建立一种测定茶叶对羟自由基清除率的新方法。将本法用于8种茶叶的抗氧化性的测定,结果满意。     

乳液体系中的RAFT可控/活性自由基聚合研究进展

可逆加成-断裂链转移聚合(RAFT)是新近发展起来的可控/活性自由基聚合方法。由于该方法具有适用单体范围广、反应条件温和、可采用多种聚合实施方法等优点,已成为一种有效的分子设计手段。本文总结了近几年文献报道的在乳液和细乳液体系中实施RAFT聚合反应的研究进展,对非均相体系的稳定性、聚合反应过程中的动力学特点、以及聚合产物的分子量及其分布等方面的研究进行了综述。     

ZnO纳米线的电化学制备研究

High-quality ZnO nanowires have been synthesized at relatively low temperature via one-step electrochemical anodization technique. In this method, Zn sheet acted as the anode and Pb sheet served as the counter electrode, and the complex solution of HF-C₂H₅OH-H₂O was used as electrolyte. ZnO nanowires were characterized by Field Emission Scanning Electron Microscopy (FE-SEM), Transmission Electron Microscopy (TEM) and Selected Area Electron Diffraction (SAED) and X-ray Diffraction (XRD). The results show that the nanowires were wurtzite crystalline ZnO, and the ZnO nanowires with the diameters of 70 nm and 30～40 nm were obtained by adjusting preparation conditions, respectively.