Conductively cooled 250-Hz single frequency Nd：YAG laser

A conductively cooled, laser diode （LD） end-pumped, injection-seeded single frequency Nd：YAG laser is designed and impleinented. The laser utilizes Nd：YAG rod as gain medium and compact dual-endpumping arrangement using two fiber-coupled LDs with a maximum output of 150 W. The optimized ramp-fire technique is applied to build reliable single longitudinal mode oscillating. The laser is capable of producing a 10-raJ Q-switched pulse with 13-ns pulse width at 1064 nm at a pulse repetition rate of 250 Hz. The output beam qualities M2 of approximately 1.19 and 1.22 in horizontal and vertical directions are detected, respectively.     

134-W phase locking of two-dimensional four-fiber lasers with improved self-imaging resonator

We experimentally demonstrate the phase locking of a two-dimensional （2D） array of four fiber lasers using an improved self-imaging resonator with a spatial filter. The high visibility interference round stripes of the coherent beam profile are observed. The coherent output power of the fiber array exceeds 134 W. Tile entire system operates quite stably, and no thermal effects observe in the spatial filter, indicating that the coherent output power can be increased using this method.     

128 W单频线偏振光纤放大器特性研究

高功率单频激光在激光雷达、光谱学、精密测量等领域具有广阔的应用前景.采用中心波长为1064 nm、光谱线宽为20 kHz、偏振消光比（PER）高于20 dB的单频线偏振分布式反馈光纤激光器做种子源（尾纤输出功率约为10 mW）,利用种子注入主振荡功率光纤放大技术,通过两级级联放大实现了128 W高功率单频、线偏振、近衍射极限单模连续激光输出.主放大器光-光效率达到83%,PER高于12 dB.采用分段温控技术有效地提高了光纤中的受激布里渊散射（SBS）阈值,实验中未观察到明显的放大自发辐射和SBS现象,进 关键词： 掺Yb光纤放大器 主振荡功率光纤放大 单频 线偏振     

Zn$lt;sub$gt;1-$lt;i$gt;x$lt;/i$gt;$lt;/sub$gt;Mg$lt;sub$gt;$lt;i$gt;x$lt;/i$gt;$lt;/sub$gt;O薄膜的光致发光特性研究

采用脉冲激光沉积方法在单晶Si（100）衬底上制备出c轴取向的Zn_1-xMg_xO单晶薄膜,通过荧光光谱仪研究了薄膜的光致发光特性.实验结果表明,Mg含量增加,Zn_1-xMg_xO单晶薄膜的紫外发光峰蓝移,发光峰强度减弱,缺陷发光强度增强.同时发现,由于Mg的掺杂,引入了一些束缚能较大的局域束缚态.对于氧气氛下制备的样品,实验发现紫外峰和绿光带发光峰同时增强,但是R值减小,紫外峰红移.对绿光发光机理研究发现,绿光发光带主要与锌空位、氧间隙（O_i）或锌位氧（O_Zn）等缺陷有关,它是由多个缺陷发光峰组成,各缺陷发光峰强度相对变化导致了绿光发光带的整体移动. 关键词： 1-xMg_xO薄膜')" href="#">Zn_1-xMg_xO薄膜 光致发光 脉冲激光沉积     

基于回波信号仿真的瑞利-喇曼-米激光雷达研制

 在分析瑞利、喇曼和米散射仿真回波信号的基础上,研制了一台探测大气温度、气溶胶和卷云的瑞利-喇曼-米散射激光雷达,实现了一台激光雷达针对大气温度、气溶胶和卷云光学特性的多参数探测。为提高瑞利和喇曼微弱回波信号信噪比,采用了极高灵敏度的R4632光电倍增管和光子计数技术;为实现对大气气溶胶和卷云的探测,532 nm回波信号采取高低分层技术、高层通道回波衰减方法和探测器门控技术。瑞利-喇曼-米散射激光雷达的探测结果证明了利用仿真回波信号指导激光雷达设计的可行性。     

Conductively cooled 1-kHz single-frequency Nd:YAG laser for remote sensing

A conductively cooled,laser diode(LD) end-pumped,injection-seeded single-frequency Nd:YAG laser is designed and implemented.The laser is capable of producing an 8-mJ Q-switched pulse with a 11-ns pulse width at 1 064 nm and at a pulse repetition rate of 1 000 Hz.At the maximum output energy of 8 mJ,the frequency jitter is less than 3.5 MHz(root mean square(RMS)) over two minutes,and the linewidth is around 54.2 MHz.The M2 of the laser beam is approximately 1.30 in both horizontal and vertical directions.The optimized ramp-fire technique is applied to build reliable single longitudinal mode oscillating.     

基于自发辐射抑制的红外光机系统优化设计

低背景探测的红外光机系统,目标信号很弱,系统自发辐射影响很大。指出了考虑系统自发辐射抑制的红外光机系统优化设计方法。从有效发射率和等效黑体辐射温度两方面比较了折反、同轴全反和离轴全反结构在自发辐射抑制方面的优劣,发现全反系统优于折反系统,离轴全反系统最优;从等效黑体辐射温度的变化,介绍了光机系统工作波段优化、结构优化设计和构件表面优化处理,发现甚长波探测在低背景下具有明显优势、光机结构表面高反和发黑合理布局效果更好;分析了制冷对光机系统抑制自发辐射的作用,发现制冷对自发辐射抑制作用明显,但制冷温度越低,效率越差,采取局部关键面制冷效果显著。     

Dual-wavelength fiber grating laser in linear overlapping cavity

We report a switchable dual-wavelength fiber grating laser in linear overlapping cavity. The laser features two overlapping cavities sharing a single Yb-doped gain medium fiber and two sets of fiber Bragg gratings. A coiling fiber setup is inserted into the 1035 nm laser cavity. Given that the bending loss is inversely related to the bending radius, the cavity loss of 1035-nm can be modulated. Modulating the bending loss facilitates the switching of the fiber grating laser to a single-or dual-wavelength output at 1030 or 1035 nm and convenient tuning of the power ratio of the two wavelengths. An approximately 152.6-mW output power and up to 38-dB polarization extinction ratio are observed. The simultaneous lasing at I030 and 1035 nm is a qualified seeder source for amplification to high power scale and can be applied to difference frequency generation of a terahertz signal. This dual-wavelength fiber grating laser is a potential pump source for generating terahertz radiation using a novel approach.     

A 110-W fiber laser with homemade double-clad fiber

A high-power ytterbium-doped fiber laser (YDFL) with homemade double-clad fiber (DCF) is introduced in this letter. The geometric parameter and laser characteristics of the fiber have been studied. With oneend-pumping scheme, pumped by a high-power laser diode with launching power of 280 W, a maximum continuous wave (CW) output of 110 W is obtained with an optical-to-optical efficiency of 40%.     

Power amplifier for 1064 nm using Yb3+-doped double-clad fiber

A master-oscillator fiber power amplifier(MOPA)system is presented,which consists of a single modelaser as the master oscillator and an Yba+-doped large-mode-area double-clad fiber as the power amplifier.The system emits up to 6 W of amplified radiation at a wavelength of 1064 nm.The slope efficiency andextracted pulse energy as a function of pulse repetition rate are analyzed.