19F+27Al深部非弹性碰撞产物的角分布

完成了19F+27Al深部非弹性碰撞产物的角分布测量.初步分析了反应产B,C,N,O,F,Ne,Na,Mg和Al的实验室系角分布,展现出深部非弹性反应机制的特点,显示了反应系统随时间的演化过程. Angular distributions of fragments produced in the deep inelastic collision of~(19)F+~(27)Al have been measured for incident energy of 114 MeV at θ_(lab)= 9~(o), 24~(o), 40~(o), 55~(o), 70~(o) and 85~(o). Angular distributions of dissipative products B, C, N, O, F, Ne, Na, Mg and Al are analyzed to provide an evolution process of the intermediate dinuclear system formed in the reaction.     

加热炉热过程动态操作数学模型

根据加热炉生产特点,建立了钢坯加热过程的动态操作数学模型,分析了待轧时间变化时炉内钢坯温度分布情况。并针对加热炉待轧的灰色性,采用多目标灰色局势决策方法,得出了相应合理的待轧优化控制策略。模拟结果表明:该方法具有良好的动态性能,适合于在线控制。     

动态光散射实验

动态光散射技术是测量纳米及亚微米颗粒粒径的有效方法．本文介绍了动态光散射实验的原理、实验装置及方法，并测量了粒径为85nm的聚苯乙烯水溶液的粒径，分析了实验产生误差的原因．     

催化动力学测定痕量砷(Ⅲ)

在醋酸介质中,发现痕量砷(Ⅲ)能灵敏地催化高碘酸钾氧化靛红la褪色的指示反应,研究了该催化反应的最佳条件与动力学参数,建立了一种新的测定痕量砷(Ⅲ)的方法。该法的线性范围0.0-40μg/LAs(Ⅲ),检测限为1.92×10-6g/L,用于环境水样中砷(Ⅲ)的测定,获得了满意的结果。     

Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Fenton 试剂处理2,4-D废水研究

利用Fenton试剂(Fe2+/H2O2)处理含有除草剂2,4-二氯苯氧乙酸(2,4-D)的模拟废水.结果显示,Fenton试剂对2,4-D有很好的去除效果.Fe2+和H2O2的摩尔比为1:20,在H2O2为1/2Qth理论投加量的条件下处理30mtn,2,4-D去除率达到80.0%.考察了Fe2+投加量、Fe2+和H2O2投加比、2,4-D初始浓度和pH等因素对2,4-D降解的影响.通过GC-MS和HPLC检测到反应中间产物有2,4-二氯苯酚、邻氯苯酚和对氯苯酚,氯离子在这些中间产物上释放.通过离子色谱检测到进一步氧化的产物还有小分子酸,如乙醇酸、乙醛酸、顺丁烯二酸,提出了Fenton降解2,4 -D的可能途径.     

Photocatalytic Synthesis of Oxygenates from Gaseous CO2 and CH4 over Semiconductor

Photoinduced synthesis of CO2 and CH4 was investigated using a batch reaction system on several photoactive materials supported on silicon dioxide. Single semiconductor showed higher selectivity to C1 compounds. The production of C2-C3 oxygenates took place preferentially on composite semiconductor photocatalysts. In particular, it was found that acetone was the primary product over Cu/CdS-TiO2/SiO2.     

Experimental 511 W Composite Nd：YAG Ceramic Laser

We demonstrate a 511 W laser diode pumped composite Nd：YAG ceramic laser. The optical pumping system is consisted of five laser diode stacked arrays arranged in a pentagonal shape around the ceramic rod whose size is φ6.35×144mm. When the pumping power is 1600 W, the cw laser output up to 511 W at 1064nm can be obtained with a linear piano-piano cavity, and the optical-to-optical efficiency is 31.9%. To our knowledge, this is the highest value of laser output by using a newly invented composite Nd：YAG ceramic rod as the gain medium.     

Geodesic Acoustic Mode in Toroidally Axisymmetric Plasmas with Non-Circular Cross Sections

The geodesic acoustic mode （GAM）, first predicted by Winsor, Johnson and Dawson in an attempt to explain some experimentally observed low frequency oscillations in stellarators, is a special electrostatic fluid mode with low mode number and coupled with the so-called geodesic curvature of a toroidally confined plasma. The recent on this mode are due to the close relevance of the stabi- lization of drift turbulence by both the zonal flow and the GAM. Previously, the GAM was illustrated in very simple geometries,     

用不变速度推导卢瑟福散射公式

通过横向速度变换得到两种不变速度，由此推出卢瑟福散射公式。