Improved detectability with a polymer-based trapping device in rapid HPLC analysis for ultra-low levels of bisphenol A (BPA) in environmental samples.

A new high-performance liquid chromatography (HPLC) method has been developed to detect ultra-low concentrations of bisphenol-A (BPA) (below 1 ng/L (ppt)) using column switching electrochemical detection (ECD). The results were superior to those obtained from manual pretreatment procedure with membrane stationary phase. BPA is inherently ubiquitous in the environment, including tools and solvents used for its analysis; to obtain meaningful results, therefore, the concentration of the overall BPA contamination must be below the detection limit for BPA using the analytical system. Therefore, purified water for preparing the standard BPA solution must be filtered with a hydrophobic membrane to suppress BPA background levels of contamination. In addition, we investigated methods for effectively preserving environmental water containing BPA. The addition of a small amount of ethylenediaminetetraacetic acid (EDTA) provided good recovery even after overnight storage. By employing these precautionary measures and procedures to reduce BPA contamination from the analytical procedure, we could accurately determine l(-10) ppt of BPA in environmental water samples using a column switching HPLC system.     

Fabrication and Characteristics of Sol-Gel Derived Fluorinated Hybrid Material Films

Fluorinated inorganic-organic hybrid materials (HYBRIMER) were successfully prepared from fluoroalkylsilanes (FASs) containing fluoro-alkyl functions and methacryloxypropyltrimethoxysilane (MPTMS) through a sol-gel process. The influence of concentration and fluoro-alkyl chain lengths of FASs on the physical characteristics of the fluorinated HYBRIMER films was examined. Larger fluorine contents lowered the refractive index within a range, which was closely dependent on the fluoro-alkyl chain lengths of FASs. Thermo-optic coefficients (TOC) were negative values, and the values grew with increasing fluorine contents and fluoro-alkyl chain lengths. Also, the thermal stability is enhanced by addition of fluorine in the HYBRIMER.     

高功率LDA紧密侧面抽运Nd:YLF两级双程离轴放大系统实验研究

 介绍了一台10mm口径两级双程离轴放大系统，实现了对5mm×5mm口径光束的激光放大，耦合系统采用高功率LDA紧密侧面直接抽运棒状Nd:YLF方式。分析并实验研究了在不同抽运电流、放大脉冲与放大器LDA抽运时刻的不同延时及不同注入能量条件下，放大系统及光束每次放大时放大特性的规律。实验得到：在放大系统5mm×5mm软光阑处注入1.58mJ能量时，放大系统可输出129.2mJ能量，能量提取效率达到19.5%，满足该系统的设计指标。     

对撞增强型YAG相位共轭腔

降低SBS相位共轭腔的启动阈值以及如何提高输出光束的质量一直是人们关心的课题。报道了在YAG激光器上运行一种新型对撞增强型YAG受激布里渊散射相位共轭激光腔的输出特性。该腔具有较低的启动阈值和较高的输出能量;该腔型最高能输出150mJ的能量,输出脉宽最窄为11ns,光束发散角为1.3mrad,输出能量和光束质量都很优良。     

类钙钛矿化合物Ca(Mn2 Cu1)Mn4 O12的磁性与磁电阻效应

利用固相反应法制备了名义成分为Ca(Mn2 Cu1 )Mn4 O1 2 的类钙钛矿锰氧化物 .x射线衍射表明 ,为了获得较为致密的样品和减小杂相含量 ,可以采用高温烧结再在 10 73K长时间空气中退火的制备方法 .样品在低温下同时存在铁磁相和反铁磁相 ,由于反铁磁相的存在导致样品在 4 5K时的磁化强度显著降低 ,并在 8T的高磁场下仍未达到饱和 .样品呈半导体导电性质 ,在 85K和 6T磁场下磁电阻比的最大值可达 - 4 6 % .     

薄膜外延生长的计算机模拟

以Cu膜为例，用Monte-Carlo算法模拟了薄膜生长的随机过程，并提出了更加完善的模型.在合理选择原子间相互作用计算方法的基础上，考虑了原子的吸附、在生长表面的迁移及迁移所引起的近邻原子连带效应、从生长表面的脱附等过程.模拟计算了薄膜的早期成核情况以及表面粗糙度和相对密度.结果表明，随着衬底温度的升高或入射率的降低，沉积在衬底上的原子逐步由离散型分布向聚集状态过渡形成一些岛核，并且逐步由二维岛核向三维岛核过渡.在一定的原子入射率下，存在三个优化温度，成核率最高时的最大成核温度Tn、薄膜的表面粗糙度最低 关键词： Monte-Carlo算法 计算机模拟 薄膜生长     

切伦柯夫相互作用中分段式慢波结构与均匀慢波结构的比较研究

 分析了切伦柯夫束波相互作用中使用单段慢波结构的缺点。指出在分段式慢波结构中，漂移段及其两端的慢波结构组成一Bragg谐振腔，当漂移段长度合适时，根据渡越时间效应理论，这种结构能减小调制束中电子的速度分散，提高束波转化效率。通过粒子模拟方法，比较了均匀慢波结构与分段式慢波结构中束波相互作用的物理图像，验证了理论分析结果，并说明了后者有束密度群聚充分，束电子速度分散小，产生微波功率高、频谱质量好，最佳工作电流大，输入电功率高等优点。     

GC-MS技术在舰船胶粘材料毒性评价中的应用

胶粘材料简称胶粘剂、粘合剂、粘结剂、接着剂。因其能把各种材料紧密地粘合在一起,并具有各种良好的性能,因而广泛地应用于海军舰船的制造及维修中。应用GC-MS技术对在使用环境及条件下其释放物及高温热解物的定性分析是对其进行使用过程中毒性评价的重要步骤。1实验部分1.1仪器与材料仪器:JMS-D300(日本JEOL);PIATFORMⅡGC-MS。     

CATALYSIS OF POLYSTYRENE N-HYDROXYL SULFONAMIDE FOR ESTERIFICATION OF BUTANOL WITH ACETIC ANHYDRIDE

1. INTRODUCTION The development of efficient polymer-supported catalysts has attracted much attention [1]. For obtaining polymeric catalysts, catalytically active groups were introduced onto polymers mostly by copolymerization of the appropriate monomers bearing the desired catalyticfunctionalities (e.g. imidazole, OH, and COOH) or by modification of preformed polymers.Another possibility involves the attachment of side chains, containing the desired arrangement of functional groups, o…     

Synthesis of New 13-O-Acylavermectin Bl Aglycones

Six new 13-O-acylavermectin Bl aglycones(3-8) were synthesized from avermectin B1 aglycone and their bioactivities were evaluated against Spodoptera exigua, Spodoptera eridania, Tetranychus urticae and Aphis fabae.