运用NMR和DFT研究Michael加成反应的动力学行为及反应机理：(CO)5W=C(OEt)C2Ph作为底物

利用核磁共振方法研究了取代吡唑对炔基Fischer卡宾化合物的Michael加成的动力学行为，该反应为典型的二级反应。当吡唑的3，5-位由较大基团取代时，反应速率常数变小，而活化焓和活化熵明显增大。利用密度泛函理论研究了炔基钨卡宾为底物的Michael加成反应机理，发现吡唑上取代基团的增大可以导致第三步反应的活化能大于第一步，从而使反应的决速步骤由原来的第一步转变为第三步。     

Solid Phase Catalytic Oxidation of Alcohols by Polymer Supported Rare Earth Catalysts

Oxidation of alcohols to the corresponding aldehydes or ketones is one of the most fundamental reactions in organic chemistry [1,2]. Some of the products of the oxidation exhibit an important role in the organic synthesis as well as pharmaceutical synthesis. In most reactions, the lanthanide complexes show satisfied catalytic activities for some compounds. Furthermore, there has been increasing interest in the lanthanide complexes and several reports have appeared in the literature [3, 4]. But the exploitation of these complexes for the oxidation of some organic substrates has been limited. Here we reported a method for the preparation and the catalytic properties as well as the recycling of lanthanide complexes in oxidation of alcohols.The synthetic procedure for the polymer supported lanthanide complexes is shown as following(scheme 1):●-NH2+CICH2COOH(C2Hs)3N→●-NHCH2COOHM=Ce(Ⅲ), Tb(Ⅲ), Sm(Ⅲ)scheme 1The oxidation of benzyl alcohol was carried out in the presence of iodosylbenzene by the polymer supported Ce(Ⅲ), Tb(Ⅲ) and Sm(Ⅲ) catalysts at 80℃ for 4.0h, the yields of benz-aldehyde are as following (table 1):Table 1 Oxidation of benzyl alcohol with the supported catalysts**Reaction condition: benzyl alcohol 0.1 mmol, iodosylbenzene 0.15mmol,catalyst 0.2mg, 80℃ for 4.0h in 1,2-dichloroethane.It can be seen from the table that the Tb(Ⅲ) complex shows higher catalytic activity for the oxidation of benzyl alcohol. Further investigation is now being carded on to optimize the results.     

273.15 K下Li2B4O7-LiCl-H2O体系热力学性质的等压研究及离子作用模型

用等压法研究了273.15 K下Li₂B₄O₇-LiCl-H₂O体系不同质量摩尔浓度分数的等压平衡浓度和水活度; 计算了LiCl和Li₂B₄O₇混合盐溶液的渗透系数等热力学性质. 用273.15 K下的实验数据对Pitzer离子相互作用模型进行了参数化研究, 拟合求取了273.15 K下Pitzer离子相互作用参数, 用获得的参数计算了LiCl和Li₂B₄O₇在Li₂B₄O₇-LiCl-H₂O体系中的活度系数. 273.15 K下由相应的Pitzer模型计算的渗透系数值与实验结果一致. 这对完善含锂、硼盐湖卤水体系的热力学模型具有重要意义.     

新型聚醚的合成与表征

用高活性催化剂催化环氧丙烷开环聚合得到一类新型高质量聚醚。对产物进行IR和NMR表征和分析,并探讨了合成工艺条件。结果表明,调节单体与调节剂的比例,控制反应温度在100 5℃,压力在0.15 ~ 0.25 MPa ,可得到不饱和度低、相对分子质量可控、相对分子质量分布窄的聚醚产品。     

Theory on the molecular characteristic contour (II)--Molecular intrinsic characteristic contours of several typical organic molecules

The molecular intrinsic characteristic contour (MICC) is defined based on the classical turning point of electron movement in a molecule. Three typical organic molecules, I.e. Methane, methanol and formic acid, were employed as examples for detailed introduction of our method. Investigations on the cross-sections of MICC provide important information about atomic size changing in the process of forming molecules. The electron density distributions on the MICCs of these molecules were calculated and shown for the first time. Results showed that the electron density distribution on the MICC correlates closely with molecular chemical properties, and it provides a new insight into molecular boundary.     

Ni/SiO2催化剂上甲烷催化裂解制氢

研究了固定床反应器上甲烷在Ni/SiO2催化剂上的裂解反应，并分别用O2、H2O进行催化剂失活/活化循环实验，并对催化剂用XRD进行分析。结果表明,Ni/SiO2催化剂具有良好的催化性能,甲烷转化率～40%，并能在150 min的时间内保持其活性，无论是用空气氧化还是水蒸气汽化，都能有效地活化已失活的催化剂。XRD实验显示，多次裂解－再生循环过程，对催化剂结构没有明显破坏。     

新型阴离子Gemini表面活性剂与非离子表面活性剂C10E6混合溶液的胶团化的研究

研究了烷基苯磺酸盐Gemini表面活性剂Ia与非离子表面活性剂C10E6溶液混合胶团中分子间的相互作用. 通过表面张力法测定了Ia 和C10E6不同比例不同温度下的临界胶束浓度(cmc). 结果表明, 两种表面活性剂以任何比例复配的cmc比单一表面活性剂的cmc都低, 表现出良好的协同效应. 传统型非离子表面活性剂C10E6、Gemini表面活性剂Ia及混合物的cmc都随着温度升高而降低. 而且, 任何配比的混合胶团中两种表面活性剂分子间的相互作用参数β都是负值, 这说明两种表面活性剂在混合胶团中产生了相互吸引的作用. 混合表面活性剂体系的胶团聚集数比单一Ia的大, 但比单一C10E6的小. 向Gemini表面活性剂Ia胶束中加入非离子表面活性剂C10E6会使胶束的微观极性变小.     

4,4′-二(硬脂酰胺基)二苯甲烷在乙烯基类单体中的分子组装及其结构形态研究

4,4′-二(硬脂酰胺基)二苯甲烷(BSDM)能在乙烯基类单体中进行聚集、自组装,并可使苯乙烯、丙烯酸丁酯、甲基丙烯酸甲酯、甲基丙烯酸-2-羟基乙酯等凝胶化,形成相应的分子凝胶.凝胶/溶胶相变温度(TGS)与BSDM浓度有关,BSDM质量分数越大,凝胶体系中分子间氢键和π-π键越多,要破坏它们所需要的能量越高,TGS因而也就越高.透射电镜表明,BSDM在各种可聚合溶剂中通过分子间相互作用形成类似纤维状的聚集体结构.BSDM在可聚合溶剂聚合前后的偏光显微照片表明,BSDM在体系中的晶型结构是球晶.     

一维链状配位聚合物{[Cu(H2bttc)(H2O)3]·3H2O}n的非等温反应动力学和晶体结构

为研究配位聚合物{[Cu(H₂bttc)(H₂O)₃]·3H₂O}_n(H₂bttc=1，2，4，5-benzenetetracarboxylate)的热分解机理和非等温反应动力学进行了DSC和TG-DTG热分析。由热分析结果和FTIR光谱推测了其热分解机理；将Kissinger法、Ozawa法、积分法和微分法得到的动力学参数进行比较确定了第一个失重过程最可能的动力学模型函数。配位聚合物的X射线单晶结构分析表明它由 [Cu(H₂bttc)(H₂O)₃]_n分子链组成，并有客体水分子通过分子间氢键附着在分子链上。这一结构特点与热分析结果相一致。还有一种氢键将分子链连接起来形成二维框架，这一框架在失去配位水和结晶水后到553 K开始分解。