聚乙烯塑料在连续超临界水反应器中的油化研究

在连续超临界水（SCW）反应器中考察了反应温度、停留时间和反应压力对聚乙烯（PE）降解油化的影响。实验结果表明，在120s、25MPa下，从500℃提高到550℃，液体收率呈现先升后降的趋势，在530℃达到最大值（79%）；在520℃、25MPa下，随停留时间的延长，PE裂解程度加深，产物轻质化程度提高，导致液体收率降低，停留240s时，气体收率达到43%；反应压力对产物收率的影响较小，气、液产物中烯/烷比随反应压力的增加而增大。     

Cu/SiO2催化剂上苯胺和乙二醇一步合成吲哚的研究

采用浸渍法，制备了用于合成吲哚的Cu/SiO2催化剂，研究了不同载体和活性组分Cu对苯胺和乙二醇一步合成吲哚反应的催化活性，发现γ-Al2O3、活性炭、Na-Y，SiO2-MgO、MCM41、SiO26种载体中，SiO2是最好的载体；催化剂活性组分Cu含量为0.78mmol/gSiO2时，吲哚的收率高达88%，考察了水蒸汽、氢气、反应温度及接触时间等因素对反应性能的影响，并对催化剂进行了TG测试，得到了Cu/Sio2催化剂催化合成吲哚适应反应条件。     

Ti2(OMe)4/SiO2催化剂的制备及其合成碳酸二甲酯的反应性能

采用表面改性和离子交换法制备了SiO2负载的Ti2(OMe)4双核桥联配合物催化剂，用IR、TPD和微反技术考察了催化剂的表面构造及CO2和CH3OH在催化剂表面上的化学吸附和反应性能。结果表明：双核桥联配合物Ti2(OMe)4以Ti-O-Si键锚定在SiO2表面上；CO2在催化剂表面存在桥式和甲氧碳酸酯基两种吸附态，其中甲氧碳酸酯基吸附态是生成DMC的关键物种；CH3OH在催化剂上只有一种分子吸附态。在150℃以下，CO2和CH3OH在Ti2(OMe)4/SiO2催化剂表面上高选择地生成碳酸二甲酯。     

尿素法合成高结晶度类水滑石

尿素的高温分解特性被用于控制层状化合物合成过程中的pH值。室温下尿素可与硝酸盐形成均一溶液，当其高温分解时可以保证溶液内部各点的pH值始终一致，因而可获得高结晶度的水滑石样品。利用该法可合成出Mg-Al、Zn-Al及Ni-Al类水滑石，但难以合成出Co-Al，Mn-Al及Co-Cr类水滑石，相信这与不同金属离子发生沉淀时所需的pH值有关。     

在二甲基亚砜中电化学制备铈钴合金

利用循环伏安法和恒电位电解法研究了室温下在二甲基亚砜中铈钴合金膜的电化学制备.结果表明,二甲基亚砜中Ce(Ⅲ)在Pt电极上的还原反应为一步完全不可逆反应.控制沉积电位在-2.10V～2.30V,利用恒电位电解得到表面平滑,附着力好,铈含量为37wt%～45wt%的铈钴合金膜.     

密胺-脲甲醛树脂合成工艺放大研究

以密胺－脲甲醛树脂合成的小试工艺条件为依据，完成了放大试验过程的工艺研究。研究结果与小试研究的工艺条件相吻合。     

Determination of trace elements in drinking tea by various analytical techniques

Tea has been one of the most popular simulating beverages which is both heavily produced and consumed in Taiwan. The determination of minor or trace elements in drinking tea and tea leaves is therefore important for estimating the daily intake of Taiwanese considered as a safety indicator. In order to accurately and precisely determine the concentrations of trace elements in samples, several analytical methods such as AAS, NAA and ICP-AES are suggested. This paper attempts to utilize all three methods to determine the concentrations of minor or trace elements in different types of tea leaves and the extracts percolated from them. The influence of fermentation processes on the concentration levels of minor or trace elements in tea samples is investigated. Because only free metal ions are bioavailable for the human body, it is necessary to determine their concentrations in drinking tea. The dissolution of trace elements in drinking tea is therefore studied by simulating the common Chinese style of tea percolation. Concentrations of thirteen elements including Zn, Mn, Ca, Cu, Ni, Al, K, Mg, Cd, Pb, Na, Co and Sc are determined.     

含铈不锈钢的抗菌性能

以00Cr18Ni9不锈钢成分为基础,添加0～5%的稀土元素铈（Ce）.利用电子探针分析了加铈（Ce）不锈钢中Ce的分布;用化学分析法测定了含铈不锈钢中铈（Ce）和碳（C）的含量;用X射线衍射方法测试了含铈（Ce）不锈钢中铈（Ce）的析出相成分;采用贴膜法测试了含Ce不锈钢对大肠杆菌ATCC 8099、金黄色葡萄球菌ATCC 6538的抗菌性能.结果表明： 含Ce不锈钢具有优异的抗菌性能,与含Cu抗菌不锈钢相比,含Ce不锈钢无需时效热处理就具有优异的抗菌性能.并讨论了含Ce不锈钢的抗菌机制.     

Laser-enhanced ionization and laser-induced atomic fluorescence as element-specific detection methods for gas chromatography. Application to organotin analysis

The applicability of (1R,2R)-1,3-diacetoxy-1-(4-nitrophenyl)-2-propyl isothiocyanate [(R,R)-DANI] as a recently developed chiral derivatizing agent for the enantioseparation of a series of β-blockers is described. The thiourea diastereomers formed were analyzed by reversed-phase high-performance liquid chromatography, mixtures of water and methanol or acetonitrile being used for elution. Conditions of derivatizations (temperature, reagent excess and reaction time) were optimized, and the effects of organic modifiers on the retention and separation were investigated; the diastereomers could readily be baseline separated with methanol-containing mobile phases with resolutions between 1.58 and 2.72.