A basket tetradecavanadate cluster with blue luminescence

A blue luminescent tetradecavanadate compound, [Et4N]5[V14O36Cl], has been synthesized. It possesses an unprecedented half-open basket framework. Through the {ABAB}-type stacking, the {V14O36} clusters form infinite one-dimensional channels with considerable accessible volume in the crystalline state.     

Tl2O3/聚-N-乙烯基咔唑复合纳米线的研究

Stable monolayers of electropolymerized poly-N-vinylcarbazole (EPVK) and arachidic acid(AA) are obtained on a subphase of alkaline Tl2O3 colloidal solutions. As revealed by the atomic force microscope, there is phase separation in the mixed LB monolayers. Transmission electron microscopic observations reveal that ordered arrays of composite Tl2O3/Epvk nanowires are formed in the mixed monolayers. Formation of the composite nanowire arrays is attributed to the ordered adsorption of Tl2O3 colloidal particles along the polycationic EPVK chains. The composite nanowire array is 3.2nm wide with a spacing of 2.7nm.The composite nanowire arrays can also be formed when pure EPVK is used. Composite LB multilayers of Tl2O3/EPVK nanowire arrays are prepared. The bilayer spacing is 5.54nm.The present study is of importance to the fabrication of inorganic semiconductor/functional polymer composite nanowires.     

Multilevel structure of sludge flocs

In this work, the structure of two kaolin sludges and a waste activated sludge are investigated using both light-scattering and free-settling methods. Fractal dimensions estimated by the light-scattering and free-settling techniques (D(S) and D(F) respectively) differ significantly and support the hypothesis that naturally occurring aggregates possess a multilevel structure. A two-level floc structural model comprised of (i) a primary floc (of fractal dimension D(S)) consisting of primary particles and (ii) a secondary floc (of fractal dimension D(F)) consisting of the microflocs is proposed to interpret the experimental findings. The structural changes of sludge flocs before and after cationic flocculation are interpreted using the proposed two-level model.     

硫化物纳米级粒子化膜的形成与气相性质的影响

采用偏振光反光度、紫外及可见光谱、电子显微镜形貌观察、粒子大小测定及电子衍射等方法加以系统研究硫化锌纳米级粒子化膜的制备与气相性质的影响．     

马来酸酐与二苄基马来酸酯共存体系的荧光分析法研究

本实验测定了二苄基马来酸酯甲醇溶液的荧光光谱，并发现马来酸酐对该荧光体系有猝灭作用，通过对不同马来酸酐浓度与各种浓度的二苄基马来酸酯甲醇溶液在４００ｎｍ处荧光强度数据的分析，发现马来酸酐的浓度与荧光猝灭程度在一定范围内呈良好的线型关系。据此，提出了用荧光猝灭法对马来酸酐及二苄基马来酸酯的定量分析     

红外光谱法观察二茂镧系氯化物与氧及水蒸气的反应

用实时红外光谱法在特制的收池中分别观察了一些二茂镧系氯化物Ｃｐ２ＬｎＣｌ（Ｃｐ＝Ｃ５Ｈ５，Ｌｎ＝Ｈｏ，Ｇｄ，Ｌｕ）和Ｃｐ＇Ｌｕ（Ｃｐ＝Ｃ５Ｈ４ＣＨ２ＯＣＨ３）与干燥氧气及水蒸气的反应，结果证实这些二茂镧系配合物在室温干燥氧气氛中很稳定，但在水蒸气中很快水蒸气的反应，结果证实这些二茂镧系配合物在室温干燥氧气氛中很稳定，但在水蒸气中很快水解。从水解反应的最初始阶段和较后期采得的红外光谱提示可能存在...     

丙酮在XeCl准分子激光辐射下的多光子电离和碎裂研究

我们用扩散分子束多光子电离光谱技术研究了丙酮在XeCl准分子激光辐射下的多光子电离和碎裂行为。实验表明丙酮没有产生母体离子峰(m/e=58), 只给出m/e=43和15两个峰, 分别对应于丙酮光解所产生的两个碎片CH_3 CO和CH_3。其离子信号(1)分别与激光强度(Ⅰ)的3和3.6次方成正比。分析表明离子是由中性碎片电离产生的。     

The Photochemistry of Diazomethane the Reactions of Methylene with Toluene and P-Xylene in Liquid Phase (I)

The photochemistry of diazomethane in toluene and p-xylene solutions was investigated. The reactions of methylene with toluene gave eight products. In the diazomethane p-xylene solution, p-ethyltoluene, 1,2,4-trimethylbenzene, 1,4-dimethylcyclohepatriene-1,3,5 and three unidentified compounds were found as products of the reaction of methylene with p-xylene. The relative rates of addition and insertion reaction of methylene with toluene and p-xylene have been calculated.     

贫水电解质体系制备多孔阳极氧化铝模板的研究

在有机溶剂为主的含草酸电解质中,研究了大孔径有序度高的阳极氧化铝(AAO)的一步法电化学制备.实验证实,电解质中水含量的降低能够有效抑制铝的电氧化速率和溶解速率,使得其氧化膜孔道的生长能够稳定进行,所得到的六方孔道排列有序度明显高于纯水溶剂制备的电解质体系下的产物.考察了水含量、有机溶剂种类以及电解质浓度对AAO模板孔道形貌的影响.结果表明,有机溶剂贫水电解质体系使得电氧化电压的选取范围比水溶液电解质体系更宽,孔径连续可调,反应条件温和.该方法适合于制备均匀大孔径的AAO模板.     

Surface hydration and its effect on fluorinated SAM formation on SiO2 surfaces

Substrate hydration is demonstrated to be crucial to film quality during self-assembled (SA) film deposition of tridecafluoro-1,1,2,2,-tetrahydrooctyltrichlorosilane (FOTS) from the vapor phase. The surface hydration was studied by thermogravimetric analysis, and a model was developed to predict the conditions necessary to desorb all of the water adsorbed on a fused silica surface without significantly altering the concentration of the surface hydroxyl groups. The nature of the SA film was investigated as a function of the degree of rehydration of the dehydrated silica surface. The wettability and microstructure of the SA films were examined by water contact angle, ellipsometry, X-ray photoelectron spectroscopy, and atomic force microscopy. There is an optimum degree of substrate hydration, on the order of 1-1.2 monolayers of adsorbed water, required to produce a dense, durable and uniform FOTS film with high water repellency and a smooth surface.