Preparation of Polyclonal Antibodies Against Testis-specific Protease 50 and Characterization of Antibody Specificity

Introduction TheTSP50genehasbeenidentifiedasoneofthe testis specificoncogenes,whichisexpressedathigh levelsinapproximately92%ofhumanbreastcancer samples,makingitanattractivemolecularmarkerand apotentialtargetfordiagnosisandtherapy[1].Itisho mologoustomany…     

Evolution of Er^3＋ Distribution in the Oxyfluoride Glass Ceramics with Heating

The distribution characteristics of Er3+ ions doped in the oxyfluoride glass ceramics containing LaF3 nanocrystals heat-treated at 650 ℃ for different durations were investigated. The results of the integral absorption cross-section analysis demonstrated that the partition fraction of Er3+ in LaF3 nanocrystals increases with prolonging of heating time. The anomalous phenomena of Er3+ emissions in the up-and the down-conversion fluorescence spectra are well explained based on the calculated results.     

克拉霉素漂浮-生物粘附微囊的制备及性能研究

选用乳化-溶剂挥发法制备乙基纤维素载药微球(EMs), 并通过内部凝胶化法进行包衣制得海藻酸钠-乙基纤维素载药微囊(AEMs), 最后通过离子交联法进一步包衣制得壳聚糖-海藻酸钠-乙基纤维素载药微囊(CAEMs). 研究克拉霉素漂浮\|生物粘附微囊的制备工艺, 并考察微囊的体外漂浮性能、 粘附性能及体内滞留性能. 结果表明, CAEMs球形度较好, 药物包封率为72.3%~78.2%, 载药量为7.1%~12.7%. 在pH=5的醋酸缓冲液中, 6 h时的累积释放率为56.6%~70.6%, 漂浮率大于70%, 4 h时的体内滞留率为60.5%. CAEMs有望通过延长药物胃内滞留时间, 在临床用于根除幽门螺旋杆菌, 从而降低消化道溃疡的复发率.     

THERMOTROPIC LIQUID CRYSTALLINE COPOLYESTERS-SOLID STATE POLYMORPHISM

This paper offers some new evidence on the polymorphism of solid state of liquid crystalline aromatic copolyesters which were prepared in our laboratory. The effects of different treatment conditions(quenching and annealing) on solid structure have been examined mainly by DSC and X-ray diffraction. The discussion focuses on the supercooled mesophase and low temperature solid-solid transition, the shifting of double melting peaks of annealed samples and the changing of their ΔH data depending on the treatment temperature, time and thermal scanning rate.     

邻苯二酚紫退色光度法测定微量锰(Ⅱ)

在硫酸介质中．高锰酸根氧化邻苯二酚紫使其退色，退色程度在一定范围内与高锰酸根加入量成良好的线性关系。据此建立了一种测定微量锰（Ⅱ）的新方法。最大吸收波长λmax＝550nm，表观摩尔吸光系数ε＝4．2×104L·mol-1·cm－1·。锰（Ⅱ）量在0－0．8mg／L范围内符合比耳定律．方法应用于求和面粉中微量锰（Ⅱ）的测定，结果满意。     

Comparative X-ray photoelectron spectroscopic study on the desulfurization of thiophene by Raney nickel and rapidly quenched skeletal nickel

The desulfurization of thiophene on Raney Ni and rapidly quenched skeletal Ni (RQ Ni) has been studied in ultrahigh vacuum (UHV) by X-ray photoelectron spectroscopy (XPS). The Raney Ni or RQ Ni can be approximated as a hydrogen-preadsorbed polycrystalline Ni-alumina composite. It is found that thiophene molecularly adsorbs on Raney Ni or RQ Ni at 103 K. At 173 K, thiophene on alumina is desorbed, while thiophene in direct contact with the metallic Ni in Raney Ni undergoes C-S bond scission, leading to carbonaceous species most probably in the metallocycle-like configuration and atomic sulfur. On RQ Ni, the temperature for thiophene dissociation is about 100 K higher than that on Raney Ni. The lower reactivity of RQ Ni toward thiophene is tentatively attributed to lattice expansion of Ni crystallites in RQ Ni due to rapid quenching. The existence of alumina and hydrogen may block the further cracking of the metallocycle-like species on Raney Ni and RQ Ni at higher temperatures, which has been the dominant reaction pathway on Ni single crystals. By 473 K, the C 1s peak has disappeared, leaving nickel sulfide on the surface.     

地锦草总黄酮最佳提取分离工艺的研究

采用四因素三水平的正交实验方法,对地锦草总黄酮的最佳提取工艺进行了探索.采用乙酸乙酯萃取、酸碱沉淀、铅盐沉淀3种方法,对其最佳分离工艺进行了探索.正交实验结果表明:温浸法中四因素对地锦草黄酮的影响顺序为乙醇浓度>样液比>提取温度>提取时间.通过实验得到了地锦草总黄酮的最佳提取工艺:以10倍体积的50%的乙醇水溶液在80℃浸提1 h.地锦草总黄酮的最佳分离方法为酸碱沉淀法.这些数据为中药地锦草的开发和应用提供了科学依据.     

溶胶-凝胶法制备还原态K-Co-Mo催化剂的合成醇性能

应用溶胶-凝胶法制备了还原态K-Co-Mo催化剂, 比较了不同的组分和不同的反应条件对合成醇性能的影响。实验结果表明，适量钾和钴助剂的添加能显著提高催化剂合成醇的性能，尤其是提高了C2+醇的选择性。此外，反应温度、压力以及空速对合成醇影响明显，升高温度可以提高催化反应中低碳醇的收率，但选择性下降；增加压力和空速可以提高低碳醇的收率和选择性，对合成低碳醇有利。在230 ℃，6.0 MPa，14 400 h－1条件下，催化剂合成低碳醇的收率为375.4 g/kg·h，选择性为70.2%，C1OH/C2+OH为0.48。     

不同环大小分子筛对钼基分子筛催化剂上甲烷无氧芳构化反应的影响

 钼基分子筛催化剂，由于不同分子筛的孔道大小及孔道形状不同\r\n，对甲烷芳构化反应表现出不同的催化性能．具有8元环孔道结构的小\r\n孔ERS－7分子筛没有催化活性，说明甲烷的芳构化反应离不开分子筛孔\r\n道的择形作用，较小的孔道中不能生成苯等芳烃．具有10元环孔道结构\r\n的ZSM－5，ZSM－11和ZRP－1三种分子筛具有较好的催化性能，但由于\r\n其孔道大小及孔道形状的差别在催化行为上表现出一定的差异．具有1\r\n0元环和12元环孔道结构的MCM－22分子筛，尤其对苯等轻芳烃而言，催\r\n化性能最佳．具有12元环孔道结构的JQX－1以及中孔分子筛SBA－15，\r\n虽然具有一定的催化性能，但活性较低．研究结果表明，孔道大小与苯\r\n分子动态直径相近或孔道稍大的分子筛是催化甲烷芳构化反应的良好载\r\n体，孔道过大或过小都不利于苯和萘等芳烃的生成．     

Study on Bifunctionality of Mo/HZSM-5 Catalysts for Methane Dehydro-Aromatization under Non-oxidative Condition

The optimum Mo/[H~+] ratio per unit cell of the active precursors in Mo/HZSM-5 catalysts for methane dehydro-aromatization, measured by 1H MAS NMR, was found to be about 1 when adjusting the acid sites by altering either the SiO2/Al2O3 ratios or the Mo loading. This implies that a concerted interaction between the Mo species and the Bronsted acid sites probably features the bifunctionality of the Mo/HZSM-5 catalyst. On the other hand, it was found that the driving force for Mo species to move into the HSZM-5 zeolite channels and the interaction between the Mo species and the Bronsted acid sites are closely and proportionably related with the amount of Bronsted acid sites per unit cell.